A self propelled two wheeled motor vehicle with an engine larger than 50cc's.

learn more… | top users | synonyms

15
votes
4answers
61k views

Symptoms of Lean or Rich carb settings on a motorcycle

I have a 1981 Yamaha XS650. I recently put in K&N stock replacement filter (ie, they are in the airbox and conform to the size of the original), however they may be leading to a leaner mixture ...
7
votes
3answers
2k views

How might I fix a dent in a Honda Rebel fuel tank?

In a silly move during an engine overhaul, I dropped my Honda Rebel's fuel tank and put a dent in the top side. Is it possible to pull this dent out? I've heard there is a method using heat and ice ...
12
votes
2answers
168 views

Motorcycle Four Body Carburetor Synchronization Balancing

I would like to adjust four-body carbs by myself, in order to avoid spent money every time. What are the basic rules, tools and secrets of synchronizing multiple carburetor bodies?
24
votes
5answers
5k views

What is the technical reason the engineer decided the motorcycle gear pattern as follows?

The gear pattern is selected by clicking a lever with your left foot, and is typically laid out as follows: 6th gear (if applicable) 5th gear 4th gear 3rd gear 2nd gear NEUTRAL 1st gear What ...
17
votes
7answers
1k views

Seized nut & bolt - difficult to access

Last year I added crash sliders to my aging Honda CBR 600F (1998) Recently whilst trying to remove the fairing for other work, I found the nut and bolt were "seized". Actually, by using a spanner at ...
8
votes
1answer
355 views

Carburettor jetting on installation of aftermarket air filter

I have a 150cc motorcycle and am planning to install an after market air filter(K&N) since the stock one was favoring fuel efficiency and not performance. The bike has a carburetor (Mikuni) not ...
1
vote
1answer
89 views

Supercharger calculations

How to determine safe supercharged pressure and CFM for a motor cycle engine (fuel injected 149cc (9.31 cubic inches) 12.9 bhp?
8
votes
2answers
403 views

Why is the engine on my Royal Enfield Classic 350 shutting down?

After travelling 7-8km on my Royal Enfield Classic 350, the bike acts as if the fuel is finished & the engine shuts down, but it starts again when I pull the accelerator. What could cause this ...
7
votes
2answers
446 views

what are the advantages of upside down forks

Recently I have come across many bikes which have upside down front forks. From browsing around the internet , I was not able to get a concrete answer for why it is preferred over conventional ...
4
votes
2answers
5k views

What is the difference between a normal battery and a maintenance free battery in a 2 wheeler segment

What is the difference between a normal battery and maintenance free battery. Is a maintenance free battery really free of maintenance or just it requires less no of charge cycles. I currently own a ...
2
votes
2answers
146 views

1987 Yamaha FZ700 headlights not working

I recently bought a 1987 Yamaha fz700, and the owner said the headlights didn't work, and I can't figure out what's wrong. We checked some of the wiring out, and the bulb connectors have no power ...
15
votes
1answer
2k views

How do I find the correct pins in a CAN-BUS connector?

This question might be too technical for this forum, but I'll give it a go. I have a 2012 BMW R1200R motorcycle with CAN-BUS. I'd like to make an Arduino interface to the connector on the bike, but I ...
6
votes
0answers
119 views

Once-only thud knock when open throttle

I have a 1997 Yamaha TRX850. When I open the throttle I'm hearing a thud knock sound near the left crankshaft cover. That sound does not always appears and I can't find any correlation between ...
6
votes
2answers
762 views

What should I look for in a basic motorcycle maintenance toolkit?

I'm looking to do more of my motorcycle maintenance myself, and am wondering what I should be investing in, when it comes to tools/devices. What are the basic tools that I'd need when starting to do ...
4
votes
2answers
3k views

1999 gsxr 600 - What is wrong when my regulator keeps burning out?

I recently had my clutch replaced and a new battery put in. Within a month my regulator/rectifier burnt out of it. So, I purchased a new one. After 2 weeks that one burned out also. I replaced the ...
17
votes
5answers
51k views

Why should the fuel petcock valve be turned to “Off” position when not using the vehicle?

It’s mentioned in the user manual of my motorbike, that when not using the vehicle, I should turn the petrol tap (the one that has three positions “On”, “Off” and “Reserve”) to “Off” position. I don’t ...
12
votes
3answers
2k views

What are the Advantages of a Single Side SwingArm on Motorcycles?

I have noticed that Ducatis , Honda and Triumph have bikes with a Single Sided SwingArm Much like most of the scooters. Are there any advantages of following this design , if so why are not all ...
11
votes
3answers
632 views

How to start my motorcycle when the kick-starter fails?

This morning I tried to start my motorcycle but the kick-starter failed. It was idle for about a month but it was riding fine before that . My motorcycle doesn't have an electric starter function. ...
11
votes
3answers
2k views

How do you get the carburetors out of a 1983 Kawasaki KZ1000 P?

It's a 4-cylinder engine, and the carbs are really wedged in there. The best way I know is to loosen the boots on both sides, pull the carbs back, and try to slip them out sideways, but what a pain! ...
10
votes
1answer
137 views

Motorcycle Speed Wobble - How do I figure out the problem?

I have a 2005 GSXR 600. I took it for a test drive and the head shakes around 65mph or so and then goes away when I go past that. It's worse when I'm slowing down without the front brake. When I ...
7
votes
3answers
599 views

What do these compression figures mean

This is a follow up question to What are the causes of fluctuating intake manifold vacuum I have a 2005 Honda CBR600 F4i which suffers from occasional hesitation at low rpm when accelerating. After ...
7
votes
2answers
6k views

Carburetted motorcycle stalls when accelerator is applied

My father has 1995 Kawasaki VN 800 Vulcan with low kilometrage (18 000, 11 000 miles). We had installed new Vance & Hines pipes on it (in hindsight, way, way too loud, but that’s beside the point, ...
5
votes
2answers
829 views

Why are gears designed in this pattern in motorcycles? [duplicate]

On motorcycles with manual transmissions, the shifting gears goes (down to up) like this: 1st Gear (all down) Neutral (half up) 2nd (full up) 3rd (so on) What is the logic behind this? Wouldn't ...
5
votes
2answers
1k views

Royal Enfield Classic 350 - Motor Break-in Best Practice

How many km's should be driven with a lower speed to setup the bore for a Royal Enfield Classic 350, what is the minimum speed for that duration and how many km's should we maintain that lower speed?
4
votes
3answers
7k views

Tick Tick sound from a Royal Enfield Classic 350 at idle

I own a Royal Enfield Classic 350. At idle, the engine starts to produce a TICK TICK sound. However it vanishes when the rpm rises and when riding the motorcycle. This question is a very frequently ...
2
votes
1answer
172 views

How to learn motorcycle maintenance theory

I'm a motorcycle novice and want to learn how to maintain a bike and fix problems that may arise. I've found a few great videos that have elucidated some basics: How a motorcycle engine works: ...
10
votes
1answer
80 views

Is it possible to fit mashroomhead air filter in Honda Stunner CBF 125?

I have Honda Stunner CBF 125 2009 model. I just need to know is it possible to replace the typical air filter with mashroomhead air filter to improve the bike performance? Is there any other way ...
9
votes
3answers
1k views

What are the causes of fluctuating intake manifold vacuum

I have a 2005 Honda CBR600 F4i which suffers from occasional hesitation at low rpm when accelerating. I also get occasional fault codes from the ECU indicating a vacuum leak. Today I connected a ...
9
votes
4answers
2k views

Is it OK to skip gears?

I'm not sure if this is on topic, but I'd like to know the answer before it comes a repair question. I have a Y2K Triumph Speed Triple - great bike. First gear comfortably takes to 90km/h. Needless ...
7
votes
2answers
248 views

Suzuku Katana does not start after an accident

I have a Suzuki Katana GSX600F. After an accident I was in, I rode the bike home and all was fine except a little cosmetic damage. In rainstorm it tipped over and after picking it up and trying to ...
7
votes
3answers
10k views

What are the pros and cons of installing an filter on a bike?

What are the advantages and disadvantages of installing high performance air filters (K&N,Green cotton,etc.) over original filter? What are the changes/working occur internally?
6
votes
1answer
54 views

Paintless dent removal for old tank

Is there a way to remove dents like this on the right side of the image? I've seen suction tools but the reviews are bad. Any ideas?
6
votes
1answer
859 views

Clutchless Downshifts Using Throttle Blip on a Motorbike/Sequential Gearbox

This is with respect to non synchromesh, sequential transmission. Ducati along with several after market systems, implement clutchless downshifts by automatically applying a slight throttle to unload ...
6
votes
2answers
236 views

Is this the correct procedure for a stator test?

Stator Test I have a 2007 DL 1000 V-Strom: I followed the following process while checking the stator: Put multimeter to VAC Tested the three phases of the stator connector plugged into a new ...
6
votes
1answer
18k views

What are the differences between a wet motorcycle clutch and a dry motorcycle clutch?

What are the differences between a wet motorcycle clutch and a dry motorcycle clutch? More specifically, what are the differences in applications performance reliability maintenance/repair
6
votes
4answers
5k views

Can a motorcycle's brake lever be bent back into shape?

I recently had a low speed spill on my bike leaving the brake lever rather bent. Can I bend it back (roughly) straight or it is likely to just break? Given that it is cast aluminium, I suspect is will ...
6
votes
2answers
1k views

Suzuki GSXR600 (K7) - Burned regulator/rectifier

I have managed to completely fry regulator/rectifier on my Suzuki GSXR600 (K7). I suspect that it happened when I blindly splashed into a big water pond, so some water probably got on connector. Thing ...
5
votes
3answers
1k views

straight pipes and carb rejetting?

I have a 1984 Honda GL 1200 standard wing and I am going to put straight pipes on it, however some forums say I will need to upjet the carbs, and others say I will not. Has anyone on this site ever ...
5
votes
5answers
1k views

Preventing visor from fogging

How do you prevent your visor from fogging? I ordered a pinlock today for my HJC helmet, but had read some good things about NEC pinkstick (some kind of wax for visor). Usually I just keep the visor ...
4
votes
2answers
357 views

Do I need to reprogram ECU when adding custom Air filter

I was thinking of replacing the air filter of a bike into a custom free flow filter. I understand that I have to mod the exhaust to free flow as well to accompany the increase in exhaust due to the ...
4
votes
2answers
158 views

Why does the bike idle lower after balancing carburetors?

I have just balanced my bike's carburetors (they were initially way out of sync) it idles lower and seems to smoke more when I rev it (smells rich). Returning it to it's previous out of sync setting ...
4
votes
1answer
223 views

XJ600 1994 Seca 2

I am wondering if anyone can shed light on an issue we are having with this particular bike. Basically, the bike starts fine cold and warms up and drives perfectly for about 15 minutes ( responsive to ...
4
votes
3answers
2k views

2001 Suzuki Katana 750 won't start after jump start and new battery

Bike has been running just fine. Recently left the lights on while at work, completely draining the battery. Couldn't get it push started there, but was able to get it jumped. I thought no biggie ...
3
votes
1answer
471 views

Bottom piece of spark plug broke off in motorcycle engine

I was riding my 2005 RM125 dirt bike the other day when it bogged down all of a sudden. I noticed the spark plug had backed out of the head, thus causing the stall. I pulled the spark plug all the way ...
3
votes
1answer
1k views

Using an open vs closed clutch cover on a motorcycle with a dry clutch

A common modification I've seen on motorcycles with a dry clutch is to replace the closed clutch cover with an open one. Besides the visual and auditory differences, will I notice anything else ...
3
votes
3answers
152 views

Motorcycle Recharge System Checks?

I have a 2007 V-Strom DL1000 motorcycle, whose recharge system is not recharging a new battery. I also have a multi-meter. Could someone share how I can check the recharge system without removing the ...
3
votes
3answers
323 views

What are the critical maintenance items for a new motorcycle?

I have purchased a new motor bike recently. What are the critical maintenance items that I should focus on? For example: Is it true that we should not run new bikes on high rpm for some time? What ...
2
votes
1answer
496 views

Kawasaki ZZR600 Model D3 - where is the fuel filter?

I've been looking for the location of the fuel filter. At first I thought it might not have one, and only the Model E ZZR's have one, because there seems to be no explicit mention of it or diagram in ...
1
vote
5answers
7k views

Replacing regular twin shocks with nitrox for my bike

I have a bike with regular Twin shock absorbers (Spring and damper). I am planning to change this to Gas charged shock absorbers. Since I used to ride my friend's Bajaj Pulsar 150, and it feels more ...
1
vote
1answer
3k views

Alternative to Bajaj Pulsar 180 UG4 stock headlamp

I am from India and I own a Bajaj Pulsar 180 UG4 2012 motorcycle. I travel on the highway while coming back home from the office at night. I am not satisfied with the brightness of my stock head lamp, ...