Please specify the brand, model and year in your question.

learn more… | top users | synonyms

2
votes
2answers
64 views

Chain Tightening Guidance

I adjusted my chain, correctly, but some times when I check it, it feels to tight. If I roll the bike forward a bit it goes back to being correct looseness, is the normal?
2
votes
1answer
777 views

My motorcycle won't start at all why?

Something is draining my battery and my bike won't start. If it's the relays which one is it? My motorcycle doesn't crank at all. it makes a buzzy noise when I press the start button. It sounds like ...
2
votes
1answer
4k views

why doesn't my motorcycle power on?

I have a Suzuki sv 650 2007. My bike recently turned on head lamps, tail, and gauges. Now it won't power on at all, not even a jump start can turn the power on. What can I do to solve the cause? Does ...
2
votes
1answer
83 views

Why does the bike idle lower after balancing carburettors?

I have just balanced my bike's carburettors (they were initially way out of sync) it idles lower and seems to smoke more when I rev it (smells rich). Returning it to it's previous out of sync setting ...
2
votes
3answers
108 views

Motorcycle Recharge System Checks?

I have a 2007 V-Strom DL1000 motorcycle, whose recharge system is not recharging a new battery. I also have a multi-meter. Could someone share how I can check the recharge system without removing the ...
2
votes
1answer
460 views

How to determine what carburetors will be compatible with a motorcycle?

What are the parameters to determine whether or not motorcycle carbs are compatible with a certain engine? Is it just the size? For example, I have a 1978 Suzuki GS1000 with Mikuni carbs, and it's ...
2
votes
1answer
141 views

Suzuku Katana does not start after an accident

I have a Suzuki Katana GSX600F. So, after an accident I was in, I rode the bike home and all was fine except a little cosmetic damage, then in a rainstorm it tipped over and after picking it up and ...
2
votes
2answers
930 views

Larger cylinder volume, but less power, how?

KTM Duke 200 which has an engine of 200 cc, and, on the other hand, Royal Enfield Bullet 350 with a 345 cc engine. I.e. Enfield has 150 cc more than the Duke. But KTM produces 25 BHP of power, whereas ...
2
votes
3answers
810 views

Honda Unicorn missing during rain and cold weather

I have a 2009 model Honda unicorn motorcycle. It's very difficult to ride during rain or cold weather, because of missing. I asked service center but they did not do anything. I have changed the CDI, ...
2
votes
1answer
37 views

When should I perform a valve head adjustment?

My 2012 Yamaha R6 has about 12000 miles on it. During that times I've had a couple rough accidents and I think the combination of those two factors it may be a good idea to check my valve clearance ...
2
votes
1answer
87 views

Carburettor jetting on installation of aftermarket air filter

I have a 150cc motorcycle and am planning to install an after market air filter(K&N) since the stock one was favoring fuel efficiency and not performance. The bike has a carburetor (Mikuni) not ...
2
votes
2answers
86 views

1987 Yamaha FZ700 headlights not working

I recently bought a 1987 Yamaha fz700, and the owner said the headlights didn't work, and I can't figure out what's wrong. We checked some of the wiring out, and the bulb connectors have no power ...
2
votes
1answer
254 views

Remove Dent From Steel Motorcycle Tank

I was in a motorcycle accident and when I crashed my knee dented my tank on impact. Needless to say my knee is pretty bad but my tank only has a dent in it. Is there a trick for removing a large ...
2
votes
1answer
477 views

Using an open vs closed clutch cover on a motorcycle with a dry clutch

A common modification I've seen on motorcycles with a dry clutch is to replace the closed clutch cover with an open one. Besides the visual and auditory differences, will I notice anything else ...
2
votes
1answer
7k views

What are the differences between a wet motorcycle clutch and a dry motorcycle clutch?

What are the differences between a wet motorcycle clutch and a dry motorcycle clutch? More specifically, what are the differences in applications performance reliability maintenance/repair
2
votes
1answer
648 views

Motorcycle heats up within minutes of driving in the traffic

Ice cold engine of my KTM Duke 200 heats up and shoots the highest temperature and the gauge reaches the extreme within like 15-30 minutes of driving it in traffic. And the engine stops and doesn't ...
2
votes
1answer
792 views

Changing the exhaust on a motorbike

I have a Yamaha XJ6 from 2012 and I would like to change the exhaust. But I have a choice. Do I change only the muffler or the whole "line"? Other than cost what are the pros and cons of changing ...
2
votes
1answer
361 views

Kawasaki ZZR600 Model D3 - where is the fuel filter?

I've been looking for the location of the fuel filter. At first I thought it might not have one, and only the Model E ZZR's have one, because there seems to be no explicit mention of it or diagram in ...
2
votes
2answers
62 views

How to undo transmission nuts

I have an ~1986 Yamaha Ag 200 and I've been pulling it apart as a bit of a hobby to understand a bit more about how it works and hopefully in the end get it going. I've opened it up so some gears ...
2
votes
1answer
2k views

Motorcycle Front Forks: Fork tube stuck in bottom pipe - clunking sound when trying to remove

I'm rebuilding the forks on my CB400 project bike [ turning into a street tracker ;) ] The process from the manual is pretty straight forward: 1) Remove the front fork bolts and drain oil 2) With ...
2
votes
1answer
197 views

Motorcycle: Way to stop plastics fading?

I have a 13yo motorcycle that has a black plastic instrument panel. Although it is not regularly exposed to the sun the black plastic is fading to a chalky white. I was wondering if anyone knew of a ...
2
votes
3answers
9k views

Squeaking brakes on motorcycle - an issue or not?

The front disc on my motorcycle emits a low pitch squeaking noise when I'm pulling up to a complete stop (almost like the sound train brakes make when pulling up to a station). This only happens when ...
2
votes
1answer
536 views

Comparing v-twin with straight-four engines

This isn't really on-topic for "motor vehicle repair", but I figure it's kinda close. A few months ago, I bought a 1983 Honda Nighthawk 550, which has a straight-four engine. A friend of mine was ...
2
votes
2answers
899 views

Motorcycle 125cc question about PISTON condition and battery

Last year I bought a 125cc bike Modenas brand, most likely unknown to you. It is a moped. http://www.modenas.com.my/v2motorcycle.asp?id=70 It can go as fast as 110 km/h enough for the city and not ...
2
votes
1answer
1k views

Burned regulator/rectifier

I have managed to completely fry regulator/rectifier on my Suzuki GSR600 (K7). I suspect that it happened when I blindly splashed into a big water pond, so some water probably got on connector. Thing ...
2
votes
1answer
84 views

Oil all over outside of engine

I have a 1988 yamaha route 66....I put some oil in, it has a slow leak by kickstand...I took it for a 5 mile ride last night. Afterwards I found it sitting in oil, and the outter engine /side was ...
2
votes
1answer
42 views

Fork tube seals Suzuki sv650

So I recently inherited a 2002 Suzuki sv650... It was garage kept for about 6 years and needs some love. I noticed that the rubber seals on top of the fork shock tubes won't stay with the tubes... ...
2
votes
1answer
129 views

Is it possible to check if the fuel filter on a Yamaha XJ600 is getting clogged?

Right after buying an used Yamaha XJ600N, I found that the rust in its fuel tank had clogged the fuel filter causing the motorcycle to lose power and until the engine died. The service station cleaned ...
2
votes
1answer
36 views

Derbi Cafe 125 stalling when changing to 1st

I have a Derbi Cafe 125. This morning I started the bike up, let it run for a few minutes, changed from N to 1st, and the bike cut out. This happens repeatedly until I walked to work. I then realized ...
2
votes
1answer
136 views

What is Total litres (reserve, usable)15 litres (3.2 litres reserve, 2 litres usable)?

I bought a new bike(Pulsar 150), and while reading its specs in the user manual i found Total litres (reserve, usable) = 15 litres (3.2 litres reserve, 2 litres usable). what does this mean, I assume ...
2
votes
3answers
2k views

Tick Tick sound from a Royal Enfield Classic 350 at idel

I own a Royal Enfield Classic 350. At idle, the engine starts to produce a TICK TICK sound. However it vanishes when the rpm rises and when riding the motorcycle. This question is a very frequently ...
2
votes
3answers
140 views

Can I put a regular lead acid battery in place of a gel battery in a BMW R110RT?

I just got a 2000 BMW R1100RT and the previous owner told me the battery is 7 years old so I figure it's time to go. I saw this video https://www.youtube.com/watch?v=XEBjekqUV9c and the guy points ...
2
votes
1answer
2k views

Bike is sometimes not wanting to shift into neutral

I have a 1982 Suzuki SP250. The bike "doesn't want" to shift into neutral sometimes. I have to rock it back and forth and shift up and down the gears a for a while before it shifts. I have changed the ...
2
votes
1answer
1k views

2 week old disk brake pads rubbing on rotor. Is this OK? (motorcycle)

I got the pads on the front brake of my bike replaced 2 weeks ago. Immediately I heard a rubbing noise at low speed. I thought this would be ok - that the pads just had to be worn in or something, but ...
2
votes
1answer
3k views

Motorcycle gears seem really stiff and hard to shift when cold

So I have noticed that even for a fruther 10 to 15 mins after warm up, the gear lever on my motorcycle (bought brand new - 6 months old) seems really stiff and harder to change. COuld this have ...
2
votes
1answer
666 views

What can cause gas to blow back into air filter in a motorcycle

I have a 1987 kawasaki ninja. I've had it for two years and it ran good until this year. When I started it this week, gas started to flow back into air filter box. Has anyone ever encountered this? ...
2
votes
1answer
42 views

Mounting bar end mirrors on non-hollow bars?

I bought a CRG hindsight bar end mirror but the CRG adapters and all the adapters I find online seem to be for hollow bars. But the bars on my 12 Yamaha R6 just have a threaded hole for a bolt.
2
votes
2answers
326 views

“tick-tick” sound in Enfield Clasic Motorcycle

BIKE ENFIELD CLASSIC 350 2013 Model ODOMETER: 14000 One and half year old Oil changed one and half month before general servicing. There is a particular sound from the engine while riding ...
2
votes
1answer
102 views

Axle nut sizes on a 2001 Honda Shadow

It seems that the axle nut on a 2001 Honda Shadow are different sizes on either side of the bike. What size are these so I may get the correct wrench to work with them. I have tried other sources ...
2
votes
4answers
282 views

Fuel meter on Yamaha TZR 50/125

I have my eyes on my childhood dream, Yamaha TZR 125. But, as it turns out, this motorcycle doesn't have any type of fuel meter. And, I'm pretty sure, it doesn't have any sensor for it too.. ...
2
votes
1answer
245 views

Pulsar 150 drifts right side

3 years old, 25000km done. The main problem is that the bike pulls or drifts towards the right side. I took it to the original service centre where they said the front fork bent and they overhauled it ...
2
votes
1answer
104 views

What is the right way to attach the Micarb to the engine head of my Enfield Bullet 500?

Before an upgrade to a new Hitchcock conical air filter, the carburetor was held in place by both the original (massive) air filter and the rubber manifold attached to the engine head, and it was ...
2
votes
2answers
355 views

Ducati ST4s not starting

I ride a 2002 ST4s that was bought new in 2008 and has now travelled 8800km. I have fitted a power commander and carbon mufflers and done some minor alterations to the air box. Spent some time setting ...
2
votes
1answer
271 views

Dirt bike silencer core cracked/rusted

After removing and disassembling my FMF Factory 4.1 dirt bike silencer, I saw that the inner core was cracked and extremely rusty (having the potential for more cracks). I definitely want to fix this ...
2
votes
1answer
1k views

How do I clean/grease my dirt bike steering bearings?

My dirt bike's steering has become increasing harder to steer. Other dirt bikes I've ridden have much smoother, almost effortless, steering. How can I have that same smooth steering? What parts do I ...
2
votes
1answer
337 views

Squeal (vacuum leak?) and high idle after rebuilding carbs on '82 Yamaha XJ 750 Maxim

I've got an '82 Yamaha XJ 750 Maxim. I rebuilt the carburetors this weekend, and after putting it back together, it seems like it's got a vacuum leak. There's a loud squeal every time a cylinder ...
2
votes
1answer
396 views

Motorcycle: Irregular brake bite (front single disk)

My motorcycle's front brake is giving a irregular bite. I don't know how to express it in words please check the illustration below. --------$^^^^^^^^-^-^-^-^-^^--^^^---^^^^^^----^^^| ~60Kmph ...
2
votes
1answer
344 views

What do I need to put rear shocks on my 1982 Yamaha Maxim XJ 750?

I bought the bike and didn't notice the previous owner had taken the rear shocks off (worst oversight I ever made, kicking myself now). I want to put some shocks on it, but I'm not really sure what I ...
2
votes
1answer
267 views

Moped bike motor problem carburetor

I have tried many technicians but none have solved my problem. I had problems in the past past, but one day my bike started to make a noise while opening the throttle when cold after about 50km/h ...
2
votes
1answer
802 views

How reliable is a Honda GB400 (motorcycle) grey import?

I am considering getting a 1985 Honda GB400TT bike as I simply love the look of them and they seem to be selling at a good price. I understand these are grey imports (imported 2nd hand from Japan) ...