Japanese carmaker known for a variety of small hatchbacks, and the ever-popular mx5/miata sports car

learn more… | top users | synonyms

2
votes
2answers
727 views

Mazda 323: Plugged in Coolant Temp Sensor - Now Car won't Start

I recently bought a Manual 97 Mazda Lantis 323 1.8L DOHC 16 Valve BP. I found the following wire unplugged on the drivers side of the engine, next to the water intake from the radiator: It plugs ...
1
vote
3answers
459 views

Fast Idle and High Fuel Consumption

I just bought a Manual 97 Mazda Lantis 323 1.8L DOHC 16 Valve BP and I was amazed that it went through 1/4 tank gas ( about 12.5 liters or 3.3 gallons ) in one day after about 60 kilometers / 37 miles ...
5
votes
6answers
11k views

Uneven rotation sounds when my car gets to 50-60 MPH

My 2005 Mazda 3 with 73K miles (roughly 20K on the tires) on it starts to make a sound, just like your washing machine does when all of the clothes go to one side and its still spinning, when I get to ...
5
votes
1answer
5k views

My 2005 Mazda 3 Front Passenger window motor receives signal to go down, but not up

If you look at the picture below you will see that I took the plastic panel off my door, and separated the motor from the regulator. After I disconnected the motor that I thought was bad, I connected ...
4
votes
2answers
2k views

How do I know when to replace shock absorbers?

In my last trip to the shop, the mechanics told me that I should replace my shock absorbers. When I inquired as to why, I don't feel that they were very clear with their answer, like they normally ...
3
votes
1answer
72 views

Falling RPM's and Stalls after Releasing the Clutch

Once my 97 Mazda 323 get's up to normal operating temperature, around say 90 C, the RPM's will occasionally nosedive after taking it out of gear, releasing the clutch and letting off the gas. What I ...
6
votes
1answer
97 views

Oily Sludge in the Intake Manifold

When taking off the throttle body to clean my IAC, I noticed that there was a thick layer of oily sludge coating pretty much everything inside the intake manifold: I have two queastions: How did ...
5
votes
2answers
5k views

Manual horn switch

what are the pitfalls or things to look out for when manually wiring a switch from the battery to the horn? Some background: I just moved to texas where they require vehicle inspections. My horn ...
4
votes
1answer
39 views

How is “Fuel consumption (economy) - combined” Calculated?

I have a Mazda - 323 S V (BA) - 1.8 i 16V (114 Hp) and the data sheet for it says: Fuel consumption (economy) - combined 7.9 l/100 km. How is this calculated and under what driving conditions?
3
votes
4answers
857 views

Front-end metallic vibration noise - poorly lubricated brakes?

I have a manual-transmission 2008 Mazda 3 I. For the past day or two, I have detected a somewhat quiet metallic vibration noise coming from the front-end of my car. Some things I have noted: The ...
3
votes
2answers
139 views

If I were to convert a gas powered automobile to an electric car, would a difference in specs possibly damage the car?

I would like to convert a Mazda Miata into an electric car, I plan to remove the engine and the gearbox, and have the car be a direct drive. The motor I intend to use has twice the torque of a ...
3
votes
3answers
4k views

What should I do about PS0128 “Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature)” error code?

I have a Mazda 6 and recently purchased the OBD 2 module and saw the check engine light with the PS0128 Error Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature). I ...
2
votes
0answers
53 views

Performing a Cylinder Power Balance Test

In the course of trying to diagnose a hot weather rough idle / stalling problem ( which doesn't occur in winter weather ) on my 97 Mazda 323 I performed a cylinder power balance test eye balling the ...