The tag has no wiki summary.

learn more… | top users | synonyms

12
votes
1answer
6k views

Is Anti-Seize a lubricant, abrasive, or both?

I'll flesh my personal bias at the outset - being a heavy diesel mechanic for a time, and mechanically inclined my entire life, I use Anti-Seize wherever I can. If it has threads and it's not part of ...
8
votes
3answers
805 views

Should lost CV gaiter grease be replaced?

I discovered a small hole, possibly a puncture, in an outer CV gaiter on the front. The hole was right next to/under the (outer) metal ring holding the CV gaiter, so it wasn't in a very flexible bit. ...
7
votes
4answers
4k views

How to stiffen up a loose ball & socket joint for a motorcycle mirror?

I have bar-end mirrors on my Buell 1125CR. They're fairly heavy anodized aluminum pieces that pivot on a ball & socket joint for adjusting the angle of view. One of them fits snugly on the joint, ...
6
votes
3answers
5k views

How do I apply dielectric grease to my battery?

I recently had a new battery installed in my 2006 Subaru Forester. The shop did not use any dielectric grease, just connected the leads to the terminal and that's it. What is the preferred method of ...
3
votes
1answer
95 views

Amount of grease needed on a typical wheel bearing.

Replacing front wheel bearings on a RWD truck. Inner and Outer. Will 14oz tube of grease be plenty? Is there a rough estimate per bearing or does it depend on the type?
2
votes
2answers
2k views

Should I grease an axle when I replace it on my motorcycle

I have a taken the front wheel out of my motorcycle to replace the tyre. When I put the axle back in is it a good idea to grease it? If so what type of grease should I use?
2
votes
1answer
144 views

Safe way to clean oil sludge around the engine?

My Case 85xt Skid Steer has a hydraulic leak somewhere but the engine area is covered in oil sludge so I can't tell where it is coming from. Is it safe to use de-greaser and or water around the engine ...
1
vote
2answers
198 views

What is the best way to clean axle components?

I'm currently servicing (changing seals/gaskets, some cleaning and repainting some parts) my front axle on a Toyota Land Cruiser 87. I'm also putting new brake rotors/calipers/pads. What is the best ...
1
vote
2answers
921 views

How much grease when packing wheel bearings? [duplicate]

My Kia failed its annual safety inspection so I'm going to be replacing the front wheel bearings (both front wheels have top-to-bottom play when up on the lift). Some people say you should only use ...
1
vote
0answers
62 views

Serpentine belt area has insane amount of gunk

I had to replace the alternator on my Toyota Tacoma V6 4L and I noticed an ungodly amount of gunk collected on and around the old one. The truck is 2007 with just over 100K mi on it. The old ...