US-based multinational carmaker with subsidiaries in Europe and Australia

learn more… | top users | synonyms

5
votes
1answer
56 views

Focus ST 2.5 MK2 - Cambelt changed, super charger noise when giving throttle

I took my vehicle in for the cam-belt service drove back home and noticed this whine/supercharger noise which increases in loudness when I press down on the throttle. I suspect the cam-belt is too ...
5
votes
1answer
68 views

96 Ranger. I replaced the clutch. Now it won't go into gear

I'm no mechanic and I'm stuck. I've got a 1996 2.3L Ford Ranger. I replaced The clutch disk, pressure plate, pilot bearing, and release bearing. I then got the transmission put back into place. ...
3
votes
0answers
55 views

Heater only blowing cold air

I have a 1997 F150 with a 4.2L engine. The engine warms to a normal operating temp. Blower motor is fine. No matter where the AC/Heater control switch is turned to I only get cold air. Im thinking the ...
1
vote
0answers
27 views

I have a 2006 Ford Explorer that seems to bog down [on hold]

I changed the brakes line brake cylinder brakes caliber and the car still boggs down. what do you think is wrong.
4
votes
1answer
25 views

What could be causing my front right brakes to get tight and decrease in speed very rapidly on a Ford Focus 2006 zx4?

Well I've been having this problem for a long while now causing me not only frustration but not to be trusted at work for getting there late and other personal problems. I'm trying to sell the car ...
3
votes
4answers
52 views

Ideas for rewiring headlights – convert from halogen with DRL to HID + LED DRL

I need some ideas. My 2009 Ford F150 pickup uses the same wire for daytime running lights (DRL) and "full" headlights. The stock setup was halogen bulbs with full brightness receiving 12 V and the DRL ...
3
votes
1answer
27 views

Issues with 2003 Ford Focus headlights

The problems started when we found out that my car had no dim lights even though the bulbs and fuses seemed to be perfectly fine, and so were my brights. So the mechanic somehow "jumped" my dim lights ...
5
votes
1answer
33 views

Starting issue with 2007 F350 6.0 diesel

Intermittently, when it's cold out and I'm starting starting the vehicle and then shutting it off the vehicle will start to crank while the key is in the off position. With the vehicle in the off ...
5
votes
2answers
58 views

Diesel engine won't start when hot

My Ford forgo 2012 diesel refuses to start after driving long distances, but it usually starts well when it is cold. What could be the problem?
6
votes
3answers
250 views

Tapping into the on-board computer

I'm thinking of replacing my car's radio panel with a custom built Raspberry Pi device, something like this device. However, it's usefulness would be much larger, if I could get information from the ...
8
votes
2answers
105 views

What vehicle does this ancient ignition coil fit?

My father-in-law gave this ford branded ignition coil to me today, and I'm curious to know what vehicle it went to, and how it was hooked up originally. Can I easily determine whether it works or not ...
2
votes
1answer
19 views

How to fix B10A2 error code for Ford Escape 2013?

I have a 2013 model Ford Escape showing an error code B10A2. It has a 1.6L engine. I know little about cars, Please help me find out what is going on and how to fix it. Thanks in advance for helping ...
6
votes
1answer
60 views

Ford Fiesta 1.4 TDCi Oil Leak

I have a Ford Fiesta 1.4 TDCi 2006 model and I recently did a head gasket change. Now there is a oil leak from the engine, behind the turbo, i cant seem to find the source, but it looks bad. Can ...
6
votes
2answers
133 views

To Use Max AC or AC

If I understand properly, setting your vehicle in the AC setting will cycle air from the outside into your vehicle attempting to cool it before it is pulled in. Likewise, MAX AC only recycles the ...
4
votes
0answers
26 views

2002 ford explorer awd 4wheel

My 2002 Ford Explorer was in a front end collision. The engine was not damaged. It did push my radiator up against the fan while we were still on the scene. I freed the fan, hit the fuel reset and ...
4
votes
2answers
570 views

Removing catalytic converters on a 2000 v6 Mustang?

I live in Oklahoma, so we don't have to get emissions checked. I have a 2000 v6 3.8l Mustang. I bought the car for $3500 at 70k miles (it was a really good) so I don't want to spend more money than I ...
5
votes
3answers
62 views

What issue could I have that can be remedied by high quality gasoline?

I have a 2000 Ford Focus. 87 unleaded has always been an acceptable gasoline to use. For the past 8 months I have noticed more severe shaking at acceleration, whether I accelerate from a complete stop ...
4
votes
2answers
6k views

Diagnosing “wrench icon” on 2010 Ford Fusion Hybrid: will OBD2 scanner help me?

On my 2010 Ford Fusion Hybrid, I frequently get the yellow "wrench" icon which appears on the LCD screen to the left of the speedometer. On approximately 25%-50% of the trips I take with the car, the ...
2
votes
0answers
14 views

Ford Courier 2005, Cant engage 4wd high gear

I have 4wd Ford Courier 2005, I cant engage into 4 high gear.
5
votes
2answers
550 views

1987 Ford Ranger fuel gauge not working right

My fuel guage will work but when it gets to half a tank it will drop to empty with in a few minutes but still has gas in it.
2
votes
1answer
65 views

1991 ford explorer 4x4 metal screeching

I just bought this vehicle, and it never did this when I test drove it. While I was driving it made this metal screeching noise, and second or two later the noise went away and the rear of the vehicle ...
3
votes
1answer
28 views

1993 Ford Probe GT that has no spark and can't hear fuel pump kick in?

I had this car for three days. On the first day it was perfect and then the second day it just stopped out of no where. I started it up and it kept doing it every now and then until it never started ...
1
vote
1answer
248 views

Reverse grinds and transmission won't lock into 1st gear [closed]

I have a 2001 Ford Escort ZX2 with manual transmission. It has had noticeable play in the shifter but had no problems until suddenly the clutch just would not engage after being pushed down completely....
3
votes
1answer
209 views

Ford Ranger manual transmission randomly squeals in 5th gear

My clutch started to slip and was squealing so I had a new clutch, flywheel, slave cylinder, pilot and throw out bearings all replaced. It drives fine, but it randomly makes a loud squeal in fifth ...
2
votes
1answer
12k views

Ford Ranger Clutch Suddenly Has No Pressure

I recently (about 3 months ago) got my clutch replaced in my '97 Ford Ranger, and when i was driving it yesterday, the clutch suddenly stopped working. I was in gear when it happened and was able to ...
8
votes
2answers
1k views

What is this? maybe a sensor?

I discovered this loose tape connector while fixing a coolant hose by the heater matrix. There are two more of these attached to the very bottom of the windscreen glass on each end, the loose one ...
2
votes
0answers
12 views

97 Ford Ranger occasionally won't start

It just recently began not starting every once in a while. Not a click, nothing. If I turn the key backwards the radio comes on and I can turn the lights on. Then after a few tries it starts up and ...
6
votes
3answers
46 views

Safe jack / jack stand points for 2002 Ford Focus

I have a 2002 Ford Focus SE wagon. I want to place jack stands on the welds on the side of the car beneath the front and rear doors, but cannot fit both the jack and stands there. So I want to jack ...
4
votes
1answer
56 views

2004 Crown Vic seat belt tensioner won't extend

2004 Crown Vic had right rear door replaced, they didn't hang hinges carefully and door wouldn't open easily. I unbolted the front seat belt pretensioner from the door post to access the lower hinge ...
13
votes
4answers
13k views

Causes of early clutch failure EXCLUDING driver style

UK 61 plate, Ford Diesel Mondeo Estate, Econetic: clutch replaced at 31,800 miles; failure caused by 'driver style' I use my car daily for commuting and for business. It's supplied to me as a company ...
6
votes
1answer
4k views

How do the audio controls on the steering wheel communicate with the radio?

Do they use some sort of wireless protocol, such as Bluetooth? I can't imagine there is enough room to have physical connections for all of the controls that would also allow for the full rotation of ...
3
votes
2answers
35 views

Idling problems on 2004 Ford Mustang 4.6L V8

Need some help. I recently bought an '04 Mustang but am having idling problems. I've looked up some things on the Web but they didn't do anything for me. I've clean the IAC and it helped some but not ...
4
votes
1answer
324 views

What causes my Mustang to buck when I let off the gas at a high RPM?

I have a 2007 Mustang GT, 4.6L V8 with a 5-speed manual transmission. This is the car I learned how to drive stick on, and the only other car I've ever driven with a manual is a 1963 pick-up truck... ...
3
votes
3answers
7k views

turning right causing small vibration and noise

My 2004 Ford Focus makes small grinding and vibrating noises when turning to the right. The problem was much more severe earlier this month. I took it to the shop and had them get me new tires and an ...
5
votes
2answers
2k views

Why does my 2016 Mustang GT Manual jolt/thud when I shift?

I just learned how to drive manual in my 2016 Mustang GT. It has 3300 miles on it. It makes a "thud" noise when I put the stick into low gears (1,2,3) sometimes. This noise makes the car jolt, such ...
3
votes
3answers
318 views

2004 powerstroke white smoke now no start

I have been trying to fix my truck for a while so long story. I need help bought a 2004 power stroke with 100k miles. It ran well for 15k miles then started having low power for first few minutes to ...
1
vote
1answer
30 views

2009 Ford Ranger heater Blend Door

My heat blend door actuator burned out. I bought a new one. I installed it but the blend door only moved a fraction of what it is supposed to so I disconnect the actuator to not burn it. My question ...
3
votes
0answers
11 views

Are 2011 ford fusion headrests interchangeable between option packages?

The owner's manual for a 2011 Ford Fusion hybrid described headrests that can be adjusted back and forth in addition to up and down. Mine does not have them. The non-adjustable ones give my wife a ...
3
votes
1answer
48 views

1999 Ford Ranger - Removing head gasket and found mystery coolant line (?) coming out of firewall. What is this?

I bought this truck broken and I don't know any of its history other than it has a blown head gasket. I've tried to be diligent about labeling things and it's possible I labeled this but the tape ...
1
vote
0answers
13 views

1991 Mazda Navajo clutch issue

I have a 1991 Mazda Navajo SUV I just purchased, it has a 5 speed manual transmission with 4wd but the 4wd to my knowledge does not work. I drove it around the first few days I had it and it drove ...
0
votes
0answers
13 views

tap dash start ford falcon el 4.0 95

I tap the left side of my steering wheel lightly and turn the ignition to start my car what can I do
4
votes
1answer
27 views

Ford Explorer 2014 child seat in second row middle seat

Is it possible to have rear facing child seat in middle row middle seat?
1
vote
0answers
14 views

FORD FIESTA 1.4 YEAR MODEL 2013

We vacuumed the car with a lighter-connected car vacuum cleaner- all of a sudden wipers and dash light went grazy- unplugged vacuum cleaner but now although dash lights come on- car wont start
0
votes
2answers
10k views

How Does a Person End Up With Their Timing “180 Out”?

I have a 1969 Ford Thunderbird 429 Thunderjet and replaced the distributor with a stock distributor with a Pertronix electronic ignition. In the process of troubleshooting why it wouldn't start, we ...
3
votes
1answer
66 views

Air conditioning only makes cold air at idle

I need help finding why my car's air conditioning (2011 Ford Mustang v6) is only blowing cold air at idling and not while driving on the highway when it's 100°F here in Nashville. In the mornings ...
0
votes
1answer
26 views

gearshift problem on Polo 1.6 2007 econoline

My gears seems to have moved a position to the right. Reverse sutsd where 1st should sit 3rd where 5th should be and 5 th no where to be found as I'm out of space by then. Also note we changed the ...
2
votes
0answers
21 views

1989 Ford Econovan - clutch issues

I have a 1989 ford econovan and this morning when i got in the clutch fully depressed with no resistance. I parked it 4 days ago and had no issues while driving. The van starts up fine, but will not ...
6
votes
1answer
46 views

2010 Ford Taurus keypad panel pulling away

I just bought the car and in process of discussing the issue I have with the door keypad panel pulling away. The dealer promised to get a garage(close to my house) to fix it for me but I'd like to ...
5
votes
3answers
5k views

Ford Taurus common oil leak area?

On my last oil change, the technician noted some oil around top and side of the engine block and said there is a small leak. The only way to find where it is coming from is doing the whole dye test, ...
3
votes
1answer
44 views

Convertible top vinyl small crack repair

So I have a 2012 convertible V6 Ford Mustang and there is a very small crack developing in a crease on my roof: I believe the top is made from Vinyl and I must confess that I've neglected it. The ...