US-based multinational carmaker with subsidiaries in Europe and Australia

learn more… | top users | synonyms

3
votes
2answers
43 views

I just found out that my muffler wasn't even connected. I was driving it around lots is that bad?

I have an 1991 Ford Explorer. I just found out my muffler wasn't connected. I was wondering why it was so loud when I got it. I have been driving it for a month now and I'm hoping I didn't wreck ...
2
votes
2answers
211 views

Temperature gauge stays in middle even when engine overheats

I have a 2005 Ford Escape. It overheats once in a while up to the point that you can physically see coolant in the reservoir tank boiling. My main concern is that the temperature gauge on the car ...
2
votes
1answer
11k views

Ford Ranger Clutch Suddenly Has No Pressure

I recently (about 3 months ago) got my clutch replaced in my '97 Ford Ranger, and when i was driving it yesterday, the clutch suddenly stopped working. I was in gear when it happened and was able to ...
2
votes
1answer
81 views

What does my serpentine belt run?

My F-150 '04 has a 5.4L Triton. I believe this is a pretty accurate diagram of the serpentine belt. I want to have a better understanding of what's under then hood. I'm pretty familiar with the basics ...
2
votes
1answer
36 views

What is this in my 5.4 triton?

Lookin' at my 04 Ford 150's 5.4L Triton. What is this engine component? I'm sure it has to do with the 4wd? Thanks
2
votes
1answer
56 views

Constant drain on battery solution

I have a 2012 Ford Fusion SE. My problem is that my dc power outlets (cigarette lighter) are on continuously. I was charging one of my cell phone battery packs and as I unplugged it I noticed that ...
6
votes
0answers
92 views

Ford Focus - Central Locking Failure

I would really appreciate some help. So my central locking has stopped working. I can put the key into the door and lock and unlock the car but I can't use the fob on the key. Attempt 1 I tried was ...
4
votes
0answers
41 views

Ford Bronco doesn't drive right after front end work [closed]

I just had new upper and lower ball joints, inner and outer tie rods replaced and an alignment on my front end of my 4x4 bronco done. As I drove it further I noticed a grinding sound as I drove. ...
7
votes
1answer
397 views

Why the different the colors of terminal corrosion on the battery?

I have a 2001 Ford Windstar. When I went to clean the battery terminals: the one with the RED cover over it was a bright blue color; the other had normal white corrosion. I do not know why the this ...
5
votes
0answers
42 views

1993 Ford f150 302 v8 5.0 liter

I had a problem with my wipers. The motor was junk, so I replace the motor. I bolted it back on, plugged it back in, and it still doesn't work. I unplugged it and pushed the button for the wipers and ...
2
votes
2answers
180 views

Ford KA Car stereo reset after battery removed, requiring security code

I had the battery replaced in my Ford KA (08), and now the radio is requiring a passcode, which I do not know. Is there a way to find out what the passcode is, or bypass it somehow? I have seen this ...
1
vote
2answers
11k views

Where is the Wiper Relay/Control Module located on a 1994-1998 Ford Mustang???

I am trying to repair my wipers, there is no voltage in the wires that connects to the wiper motor. I checked the fuses and current is passing through them, so they are ok. I think the Wiper Relay ...
3
votes
1answer
79 views

Low beams are acting weird

I have a 1991 Ford Explorer. Today I fired it up and the low beams weren't working so I opened the hood while they were still not working. My girl call me so I slammed the hood and BAM it started ...
3
votes
1answer
70 views

on 1989 f350, after turning ignition on to crank position, turn key to off and remove key, starter continues to crank . what is sticking?

After inserting key and turning to start position, starter continues to crank after engine starts. You can turn ignition off and remove key and starter continues to crank. have replaced solenoid, ...
2
votes
1answer
86 views

Why does my gear-shift lever seem to freeze in position sometimes?

My 1996 Ford Escort shift lever sometimes won't move into 1st gear position unless I turn the motor off, then start in that gear. It also, sometimes, won't move into any of the gear positions and I ...
3
votes
2answers
54 views

2002 Ford F-150 idle problem

Ok once in a while when I turn on my 2002 Ford F-150 the RPM's go from 1000 to 800 then back to 1000 over and over and this is at idle. I haven't gone to get it looked at and I want to see if it's ...
1
vote
1answer
86 views

Is a valve stem and valve guide oil seal replacement on my 4.0 Ford possible?

Is a Valve stem and valve guide OIL SEAL replacement on my 4.0 Liter ford possible? Would (plenty of Hot) compressed Air be helpful to have for this process. My brother (aspiring genius mechanic) says ...
3
votes
1answer
89 views

Six to Eight Engine Swap 1968 Mustang, what parts are required

Swapping out a 200 cid L6 for a 302 V8. What parts are required to make the swap. I would like answers with reliable sources. I am finding mixed information on this topic. The engine mounting ...
4
votes
3answers
2k views

Realistically, how much can I expect to improve cloudy headlights by polishing?

The headlight lenses on my vehicle (a 2001 Ford F-150) are cloudy, and presumably as a result, the headlights are not terribly effective. (I could post a photo if you want.) I bought a polishing kit ...
2
votes
2answers
5k views

Diagnosing “wrench icon” on 2010 Ford Fusion Hybrid: will OBD2 scanner help me?

On my 2010 Ford Fusion Hybrid, I frequently get the yellow "wrench" icon which appears on the LCD screen to the left of the speedometer. On approximately 25%-50% of the trips I take with the car, the ...
3
votes
2answers
1k views

Ford Ka - Passenger footwell water leak

Ford Ka 2005 - Has developed a water leak in the passeneger footwell. Car has been back to garage, couple of times now but problem persists. Edit I've lost count the amount of times the car has ...
1
vote
2answers
342 views

What would cause a blowout of the boot on the sparkplug wire at the plug?

1994 Ford 7.5 liter. #3 plug wire on passenger side has blown through the boot at the plug three times in the last 2000 miles. What is causing this?
4
votes
3answers
142 views

Ford KA won't start

I tried to start my 2007 Ford KA this morning but it makes a very high pitched screeching sound. Almost like a grinding. The car won't start at all. Could you please advise on what this could be? ...
2
votes
0answers
40 views

my ute wont start

I drive a ford falcon au 2000 v8 ute. Drove my ute to the local shopping centre, about a 2 min drive & now it wont start. Ive got power on the dash, relays & fuses all look intact & got ...
3
votes
1answer
204 views

Why does my brake pedal go to the floor when i start the truck up?

My Ford F250 4x4 brake pedal goes to the floor when you start the truck and stay's to the floor until you shut the engine off then it returns? The brake booster, master cyl, rotors, pads, brake lines, ...
0
votes
1answer
113 views

1996 Ford Explorer Speedometer and Shifting issues, O/D light flashing

My 1996 Ford Explorer began having issues at the end of a moderately long drive home while going approximately 60 miles per hour (not sure if related; I drive that speed often). The speedometer ...
4
votes
5answers
5k views

Knocking noise when turning at full lock/opposite lock?

I have noticed that I have a knocking noise when I turn full lock or full opposite lock. The noise is a single knock as I reach lock and then another knock as I start turning back. I will ...
1
vote
1answer
70 views

2008 ford escape hybrid blend door actuator

i have a similar issue, my 2008 ford escape hybrid driver side remains on cold and my passenger side climate control works fine, no problems. I also notice that when i turn the knob on the driver side ...
2
votes
0answers
466 views

Can a blend door be easily fixed/replaced in a Ford Escape Hybrid 2006? Also, passenger side airbag removal?

I recently got my AC compressor fixed, but after doing this it turns out my AC still isn't great because of a messed up blend door (according to my mechanic). Apparently this is a fairly common ...
1
vote
1answer
59 views

Empty Radiator with no leaks

I have a 1998 Ford Ranger 4 cycl. and 8 spark plugs which all the water was gone in the radiator with no leaks to be found...What would cause water to totally evaporate from radiator without any leaks ...
4
votes
2answers
301 views

Rear end Differential - rebuild or replace with used?

I have a 01 Ford F 150 with 320K miles. I love this truck and don't plan on ever selling it. I thought the bearings were going out in the back right side so I took it to mechanic. Two different ...
5
votes
1answer
10k views

Ford Escape won't shift into gear, O/D light flashing

I've got a 2002 Ford Escape (automatic transmission) that will start fine and reverse without any problems, but when I put it in drive and try to pull forward, it remains in idle. I can hit the gas ...
3
votes
0answers
26 views

ford mondeo v6 st24

Just wondering if anyone can help as we have this Mondeo and all of a sudden all the ignition went and have no power at all. Any suggestions as to what it might be? All the fuses are fine and still ...
3
votes
2answers
70 views

No radiator fluid in resevoir

Obviously you shouldn't drive with no coolant, because in most cases obviously your car will overheat, blow a head gasket and all that fun stuff. I drive a 4cyl 2.5L Ford Ranger. One time I realized ...
5
votes
0answers
230 views

2011 Ford Focus 1.6 (UK) stalling often

Over the past 6-8 months my 2011 (<40k miles on the clock) Ford Focus 1.6 Zetec has started to stall. A lot. It's worse in busy traffic with a lot of stopping and starting or at a slow speeds ...
1
vote
1answer
62 views

Starter or Electrical?

My 2007 Mustang GT makes funny noise when starting, and lately disconnects my Clock and radio. Would that mean that I need a new starter or do I have electrical problems?
2
votes
1answer
50 views

electric windows broken

Can anyone help just got home and have gone to do my electric windows up and non of them will go up I had an issue with the passenger side switch not doing the window up but would do it down but now ...
6
votes
1answer
5k views

How important is it to use a real flare nut wrench when removing the fuel line on an old Ford tractor?

An article on overhauling the carbs on a Ford 8N tractor says to use a flare nut wrench to disconnect the fuel line. How important is it use that kind of wrench, vs. an open ended wrench?
3
votes
1answer
254 views

Truck won't crank; no sound from starter relays

I have a 1997 Expedition, which badly needed a tune up: the motor was shaking. I changed the plugs, which stopped the shaking; two days later the truck won't start. The battery is hot and the lights ...
1
vote
0answers
36 views

Does Ford SYNC 2 resolve unresponsivness issues? [closed]

I've read a lot about My Ford Touch issues with being slow and unresponsive. Does Sync 2 resolve those errors?
1
vote
1answer
77 views

Power Steering Only Works on Left Turns

I just bought a restoration project, and I'm having trouble diagnosing a problem with the car. It's a 1963 1/2 Ford Galaxie with a 289. It has power steering, which works, but only when you turn the ...
3
votes
0answers
82 views

2004 ford taurus - screeching sound when attempting to start the car

To start, I know nothing about cars aside from how to drive them. I have a pre owned 2004 ford taurus with 60000 miles. Recently, it has been making a screeching noise when I turn the key to start the ...
5
votes
2answers
1k views

Do power steering hoses just burst randomly or is it usually caused by installation error?

Power steering pump went out 10 months ago. Took it to Pep Boys where they replaced it. Today, while driving, the power steering goes out again.... It was explained to me at Pep Boys that the power ...
2
votes
1answer
138 views

What OBD II protocol does the 2004 Ford Explorer?

Does the 2004 Explorer use J1850 or some other protocol ? Is there a way to extract codes by jumpering pins on the OBD connector ? Thanks
2
votes
1answer
56 views

How are some manufacturers or retailers able to sell for so much more, while others sell for less?

I have a 2007 Ford Taurus with 128,000 miles. I need to replace my ignition coil and wires, but I'm seeing some new coils for around $35 and some for around $120 (Both online and in stores). The ...
1
vote
1answer
244 views

My Ford Escort ZX2 not starting

Ford Escort ZX2 I go to turn my car on. I have power, but it will not start. No clicking. Took starter off, it was bad. Put it back on. Also, took a new battery, put in my car from truck. Still same ...
1
vote
2answers
200 views

2000 mustang 3.8l v6 smog pump issues

I have a 2000 mustangs v6 3.8l The smog pump is not working (I think its an electrical problem) but that's outside of the point. I live in Oklahoma and we have no emission stuff (Amen!!!) so can I ...
2
votes
3answers
400 views

Ticking or clicking when accelerating

So I've had my Ford F-150 for a few years now. It's a 2001 and up until the other day it was running and sounding like new. On the way back from work I stopped at the gas station to fill up. When I ...
1
vote
1answer
45 views

Information from an EEC-IV on 92 Ford F150

Good evening. My general question is, what information, preferably real time, can be obtained from the EEC on a 92 Ford F150? I'm particularly looking to hook up an Arduino and digitizing the gauges ...
4
votes
1answer
225 views

Coolant boils over but temp gauge registers normal

I have a 2002 Ford Taurus 3.0 L V6. I have had trouble off and on with it running hot for about a year. At first I put a new thermostat on it and it seemed to fix the problem. Month or so later, it ...