US-based multinational carmaker with subsidiaries in Europe and Australia

learn more… | top users | synonyms

1
vote
1answer
109 views

Ford ikon 1.8 nxt diesel - Starting problem [closed]

Ford ikon 1.8 nxt diesel. It has coverd 130000 kms. Now in winter, there is starting trouble. Mostly it takes 30 to 35 secs. Long self. I have checked its heater , hetaer timer ,fuel leakage , battery ...
2
votes
1answer
59 views

Constant drain on battery solution

I have a 2012 Ford Fusion SE. My problem is that my dc power outlets (cigarette lighter) are on continuously. I was charging one of my cell phone battery packs and as I unplugged it I noticed that ...
4
votes
0answers
41 views

Ford Bronco doesn't drive right after front end work [closed]

I just had new upper and lower ball joints, inner and outer tie rods replaced and an alignment on my front end of my 4x4 bronco done. As I drove it further I noticed a grinding sound as I drove. Also,...
6
votes
0answers
106 views

Ford Focus - Central Locking Failure

I would really appreciate some help. So my central locking has stopped working. I can put the key into the door and lock and unlock the car but I can't use the fob on the key. Attempt 1 I tried was ...
7
votes
2answers
131 views

02 Mustang GT 4.6

I was on my way to work and car started to run rough stumble and check engine light started to flash. Immediately turned around limped home about 3 miles. Changed plugs and swapped some old coils ...
2
votes
3answers
42 views

1995 Ford Thunderbird

When I step on the brake pedal I hear a hissing sound and the pedal goes all the way to the floor and the brakes barely stop the car. This doesn't happen every time but most of the time. Any ideas of ...
5
votes
0answers
45 views

1993 Ford f150 302 v8 5.0 liter

I had a problem with my wipers. The motor was junk, so I replace the motor. I bolted it back on, plugged it back in, and it still doesn't work. I unplugged it and pushed the button for the wipers and ...
3
votes
1answer
79 views

Low beams are acting weird

I have a 1991 Ford Explorer. Today I fired it up and the low beams weren't working so I opened the hood while they were still not working. My girl call me so I slammed the hood and BAM it started ...
8
votes
1answer
4k views

Ford Focus with error code P242F (DPF failure)

I have a 2008 Ford Focus (UK) with a 1.6 TDCi engine and 60K miles. This weekend I got error code P242F stating "diesel particulate filter restriction ash accumulation" and the vehicle has gone into ...
3
votes
0answers
46 views

Antifreeze in my engine, and now it's making a ticking noise

I changed a busted intake out, also changed the plugs. Some old antifreeze get in the plug holes when I pulled the plugs. I have reassembled the car, but it runs bad and has a ticking noise. ...
2
votes
2answers
210 views

Ford KA Car stereo reset after battery removed, requiring security code

I had the battery replaced in my Ford KA (08), and now the radio is requiring a passcode, which I do not know. Is there a way to find out what the passcode is, or bypass it somehow? I have seen this ...
3
votes
1answer
74 views

on 1989 f350, after turning ignition on to crank position, turn key to off and remove key, starter continues to crank . what is sticking?

After inserting key and turning to start position, starter continues to crank after engine starts. You can turn ignition off and remove key and starter continues to crank. have replaced solenoid, ...
2
votes
1answer
96 views

Why does my gear-shift lever seem to freeze in position sometimes?

My 1996 Ford Escort shift lever sometimes won't move into 1st gear position unless I turn the motor off, then start in that gear. It also, sometimes, won't move into any of the gear positions and I ...
3
votes
2answers
55 views

2002 Ford F-150 idle problem

Ok once in a while when I turn on my 2002 Ford F-150 the RPM's go from 1000 to 800 then back to 1000 over and over and this is at idle. I haven't gone to get it looked at and I want to see if it's ...
4
votes
3answers
167 views

Ford KA won't start

I tried to start my 2007 Ford KA this morning but it makes a very high pitched screeching sound. Almost like a grinding. The car won't start at all. Could you please advise on what this could be? ...
2
votes
0answers
40 views

my ute wont start

I drive a ford falcon au 2000 v8 ute. Drove my ute to the local shopping centre, about a 2 min drive & now it wont start. Ive got power on the dash, relays & fuses all look intact & got ...
3
votes
1answer
244 views

Why does my brake pedal go to the floor when i start the truck up?

My Ford F250 4x4 brake pedal goes to the floor when you start the truck and stay's to the floor until you shut the engine off then it returns? The brake booster, master cyl, rotors, pads, brake lines, ...
0
votes
1answer
123 views

1996 Ford Explorer Speedometer and Shifting issues, O/D light flashing

My 1996 Ford Explorer began having issues at the end of a moderately long drive home while going approximately 60 miles per hour (not sure if related; I drive that speed often). The speedometer ...
1
vote
1answer
84 views

2008 ford escape hybrid blend door actuator

i have a similar issue, my 2008 ford escape hybrid driver side remains on cold and my passenger side climate control works fine, no problems. I also notice that when i turn the knob on the driver side ...
1
vote
1answer
63 views

Empty Radiator with no leaks

I have a 1998 Ford Ranger 4 cycl. and 8 spark plugs which all the water was gone in the radiator with no leaks to be found...What would cause water to totally evaporate from radiator without any leaks ...
4
votes
2answers
452 views

Rear end Differential - rebuild or replace with used?

I have a 01 Ford F 150 with 320K miles. I love this truck and don't plan on ever selling it. I thought the bearings were going out in the back right side so I took it to mechanic. Two different ...
3
votes
0answers
26 views

ford mondeo v6 st24

Just wondering if anyone can help as we have this Mondeo and all of a sudden all the ignition went and have no power at all. Any suggestions as to what it might be? All the fuses are fine and still ...
2
votes
1answer
45 views

Auxiliary Shaft Sprocket

I have an '89 ford ranger that loses power and stutters intermittently around 2000 rpm. I thought this could be a timing issue. The Camshaft Sprocket and Crank pulley are lined up nicely but the oil ...
5
votes
2answers
1k views

Why does my 2016 Mustang GT Manual jolt/thud when I shift?

I just learned how to drive manual in my 2016 Mustang GT. It has 3300 miles on it. It makes a "thud" noise when I put the stick into low gears (1,2,3) sometimes. This noise makes the car jolt, such ...
3
votes
2answers
78 views

No radiator fluid in resevoir

Obviously you shouldn't drive with no coolant, because in most cases obviously your car will overheat, blow a head gasket and all that fun stuff. I drive a 4cyl 2.5L Ford Ranger. One time I realized ...
7
votes
4answers
182 views

2002 Ford F350 Superduty 7.3L Turbo diesel using a quart of oil every 43 miles

This Diesel engine has been rebuilt and it didn't use any oil till the HPOP went out. I replaced the oil pump and then I noticed my turbo when going up a hill and the Turbo would sound like a sneeze ...
1
vote
1answer
95 views

Is a valve stem and valve guide oil seal replacement on my 4.0 Ford possible?

Is a Valve stem and valve guide OIL SEAL replacement on my 4.0 Liter ford possible? Would (plenty of Hot) compressed Air be helpful to have for this process. My brother (aspiring genius mechanic) says ...
1
vote
1answer
62 views

Starter or Electrical?

My 2007 Mustang GT makes funny noise when starting, and lately disconnects my Clock and radio. Would that mean that I need a new starter or do I have electrical problems?
2
votes
1answer
53 views

electric windows broken

Can anyone help just got home and have gone to do my electric windows up and non of them will go up I had an issue with the passenger side switch not doing the window up but would do it down but now ...
1
vote
2answers
27 views

2007 Ford Focus wagon

While driving home the car coughed a couple of times then stopped. We tried to start it and it wont start not even click all the lights still work and the dash still lights up the radio even still ...
7
votes
1answer
125 views

Rough idle while warming up, goes away after a tiny rev

I have an 84 Ranger 2.8L V6. It seem that nearly every time I start the car, it has a pretty rough idle while it warms up. If I just rev the engine a little bit for a second and release (just barely ...
1
vote
0answers
37 views

Does Ford SYNC 2 resolve unresponsivness issues? [closed]

I've read a lot about My Ford Touch issues with being slow and unresponsive. Does Sync 2 resolve those errors?
1
vote
1answer
85 views

Power Steering Only Works on Left Turns

I just bought a restoration project, and I'm having trouble diagnosing a problem with the car. It's a 1963 1/2 Ford Galaxie with a 289. It has power steering, which works, but only when you turn the ...
7
votes
1answer
417 views

Why the different the colors of terminal corrosion on the battery?

I have a 2001 Ford Windstar. When I went to clean the battery terminals: the one with the RED cover over it was a bright blue color; the other had normal white corrosion. I do not know why the this ...
2
votes
2answers
100 views

Ford Escort overheats when switching FROM highway TO city driving

I have a 1998 Ford Escort with 113k miles. It's never given me any major problems before, except for the AC going out about 4 months ago (details to follow). In the past week while driving with the ...
3
votes
2answers
130 views

All warning lights came on, the odometer did not.

I have a 2008 F150 160k miles and all of the warning lights came on (Check engine, ABS, low tire, parking brake, 4x4 Hi and 4x4 Low from what I remember). The odometer was just a blank green screen. ...
3
votes
0answers
91 views

2004 ford taurus - screeching sound when attempting to start the car

To start, I know nothing about cars aside from how to drive them. I have a pre owned 2004 ford taurus with 60000 miles. Recently, it has been making a screeching noise when I turn the key to start the ...
2
votes
1answer
152 views

What OBD II protocol does the 2004 Ford Explorer?

Does the 2004 Explorer use J1850 or some other protocol ? Is there a way to extract codes by jumpering pins on the OBD connector ? Thanks
2
votes
3answers
485 views

Ticking or clicking when accelerating

So I've had my Ford F-150 for a few years now. It's a 2001 and up until the other day it was running and sounding like new. On the way back from work I stopped at the gas station to fill up. When I ...
4
votes
1answer
275 views

Coolant boils over but temp gauge registers normal

I have a 2002 Ford Taurus 3.0 L V6. I have had trouble off and on with it running hot for about a year. At first I put a new thermostat on it and it seemed to fix the problem. Month or so later, it ...
1
vote
1answer
47 views

Information from an EEC-IV on 92 Ford F150

Good evening. My general question is, what information, preferably real time, can be obtained from the EEC on a 92 Ford F150? I'm particularly looking to hook up an Arduino and digitizing the gauges ...
2
votes
1answer
76 views

Ford has proper fuel pressure and spark but won't start

My '97 Ford Expedition turns over but won't start. I have replaced the fuel pump and filter with no results. Fuel is hitting the rail at pressure. I checked the spark with a noid light, and it's ...
4
votes
1answer
40 views

Oil pressure low on an 84 Ranger

I've recently changed the oil and filter on my 84 Ranger 2.8L V6. I used 10w-30 dino oil and filled it in range on the dip stick. I noticed that after I changed the oil, the oil pressure gauge (on ...
6
votes
2answers
91 views

What vehicle does this ancient ignition coil fit?

My father-in-law gave this ford branded ignition coil to me today, and I'm curious to know what vehicle it went to, and how it was hooked up originally. Can I easily determine whether it works or not ...
2
votes
1answer
121 views

Car is slow to start, shakes occasionally, and smells hot… but runs fine?

I am driving a 2000 Ford Explorer with 140k miles on it. Although the car runs well, it feels like it is on the verge of a breakdown that I'd like to stay in front of if possible. When I start the car,...
4
votes
2answers
478 views

Removing catalytic converters on a 2000 v6 Mustang?

I live in Oklahoma, so we don't have to get emissions checked. I have a 2000 v6 3.8l Mustang. I bought the car for $3500 at 70k miles (it was a really good) so I don't want to spend more money than I ...
4
votes
1answer
94 views

2004 Ford Explorer accelerates too quickly from idle

I have a 2004 Explorer/v8/4wd/bauer edition. When I take off from a stop, there is a slight lag and then the vehicle over accelerates (sort of "jumps" off the line). If I gradually apply the ...
3
votes
1answer
45 views

Wheel bearing grease quantity

I own a Ford Ranger and want to know whether to pack extra grease in the hub, especially in the space between the inside bearing and the seal and within the spindle cap outside the outer bearing. I ...
3
votes
1answer
3k views

Low beams won't work

I have a 2007 Ford Focus. For some reason my low beams won't work. I've checked the fuses, replaced the relay, replaced the bulbs, and replaced the headlight switch in the dash. Still nothing. All ...
2
votes
1answer
129 views

Is it safe to lower the S550 (2015+) Mustang by 1" in the northeast US?

I have seen 5.1" and 5.9" listed as the ground clearance on the S550 (2015+). I don't know which is true, but I would like to lower the one I have ordered by 1" to improve handing. Is this safe to do ...