Internal Combustion Engine. Most engines in road going vehicles are 4-cycle internal combustion gasoline engines.

learn more… | top users | synonyms

1
vote
2answers
358 views

Toyota manual transmission problem

I took my 2003 Toyota Matrix in to the dealership for service. It has 105,000 miles - the oxygen sensor needed replacing, but no other issues found. Now I feel as though I need to shift to a higher ...
7
votes
2answers
2k views

2004 Ford Focus engine cover would not budge after all screws are removed

I have a 2004 Ford Focus SE 2.0L. There’s some oil leak on the engine. A mechanic told me it could be the engine valve gasket being cracked (the car is pretty old and never had a valve gasket change). ...
2
votes
1answer
156 views

Does a water leaking make the engine heat faster?

I have a Range Rover classic 1993 which is heating very fast even if I just drive for 10 min, the heat is not rising too much but I used to drive this Range Rover before and especially in winter ...
12
votes
5answers
3k views

How to properly change out spark plugs?

I am looking into how to change out my spark plugs on my 4 cylinder 2005 Mazda 3. All I know to do is: 1: Open each cylinder. 2: Use a spark plug socket (with the rubber insert) to remove the old ...
2
votes
2answers
3k views

Cleaning fuel injectors with a pressurized can?

I've been experiencing rough idling on my 2003 Mitsubishi Galant for the last year or so. It has 182,000 miles on it. About every 6 months now I use seafoam cleaner in the tank and that clears it up ...
3
votes
1answer
895 views

Engine Code P1312 on 2001 Saab 9-3

I have replaced to brand new spark plugs. After some research, it seems that the problem might be the direct ignition cassette. Could there be other possibilities? Thanks
3
votes
2answers
8k views

Is short drive trip bad for your engine?

My wife's car often uses to drive to a nearby grocery store, which is too close to our house (about 2 miles). Some one told me that I should change the engine oil more often because engine is working ...
2
votes
1answer
217 views

94' Dodge Spirit 3.0l v6 Throttle position sensor over 4.96V

I pulled up the codes from my 94 spirit that's been running sluggish and unresponsive lately. I got a 24* Throttle position sensor over 4.96V. I put a new TPS in and I'm still getting this code. Do I ...
3
votes
1answer
183 views

Honda Accord 2004 V6 Australian, Can stopped in the middle of the road

Recently, when I was driving and had to stop at a set of light the car all of a sudden stopped. All the lights on the spedometer came up, but the A/C, radio all was working fine. I turned it off and ...
2
votes
2answers
6k views

Car overheating problem

I have a 2002 Ford Focus. Whenever the car is idling the heat gauge goes up at an alarming rate and goes the farthest into the red that it can if left alone. Now if I rev the engine a little the ...
2
votes
1answer
5k views

Hard Start in cold weather

We have a Ford Escape (2005 V6) with approximately 125k on it. I have done most of the maintenance on it myself since we bought it at 90k and it has overall been a great vehicle. The past two ...
4
votes
1answer
2k views

'98 Camry has occasional rough running / low speed idle problem

My '98 Camry (with the four-cylinder engine) usually starts, idles and drives like a dream. About a year ago I had the entire exhaust system replaced (including cat) due to corrosion. Since then it's ...
5
votes
2answers
392 views

When do engine type and mileage of a car affect pricing?

I'm currently designing a customer relationship management tool for auto shop owners and was wondering: Does engine type or the odometer value of a car ever affect pricing for a customer? What ...
3
votes
1answer
981 views

Rough noise while accelerating

My car is a 2002 Nissan Altima with 106,873 miles. After 95K miles, my car has been giving a rough noise from the engine. After shifting into second gear, it's smooth until I hit the gas pedal hard. ...
4
votes
2answers
1k views

01 sentra running hot

I have an 01 nissan sentra which had been running hot. If i start the car in the morning and turn temp control to hot and fan on and let the car warm up, i will have no heat and the car runs hot. Just ...
4
votes
1answer
1k views

09 Camry engine rumbles

This is a pretty straight forward question, but I have an 09 Camry 5-speed manual. It only has about 25k miles on it and has been regularly serviced. However, as of late I've noticed that when I ...
0
votes
1answer
813 views

Car driving experience not smooth

My Nissan Altima 2002 (106873 miles). It used to smooth after oil changes. But, I have been noticing that the car is not smooth as it used to be after oil changes. It used to feel like the car was ...
2
votes
2answers
4k views

1999 Honda Civic CNG, Flashing check engine light

I have a 1999 Honda Civic CNG with 140,000 highway miles. Initially, while driving the car at highway speed, the check engine light would flash and the car would lose power. I would have to stop and ...
2
votes
1answer
2k views

Maintenance on a 2005 Nissan Sentra 1.8S

My previous car was totalled and while shopping for used cars, I have found a 2005 Nissan Sentra 1.8S on sale for a very good price. It is being sold by the current owner, and it has been going to the ...
0
votes
2answers
3k views

Hesitation and backfiring on sudden acelleration when warm

I have an old Mitsubishi Triton Utility 1993. It has a 4g54 4 cyl petrol engine with a carby. No computers or anything like that to check error codes. If you press down on the accelerator quickly the ...
3
votes
2answers
2k views

Why does a car's engine vibrate at start, despite the circular geometry of its component's dynamics

If a well balanced system starts moving, it should not vibrate ! Or if it does, it should vibrate even more at high speeds ! But a car clearly vibrates hard during the startup, to then stabilize.
2
votes
2answers
2k views
0
votes
1answer
46 views

Noise isolation for 'vanilla' engine

Is it possible to add silicon or other soft devices between the engine of an old car and the chassis, in order to reduce the amount of noise that is transmitted and thus the amount of vibration felt ...
6
votes
4answers
3k views

Why does my car scream on cold start?

My 1988 Subaru XT6 2.7L engine screams at me on a cold start then it will stop and then do it again when I take it out of park, but then it stops. Also, my car is losing antifreeze. Any ideas why?
5
votes
1answer
1k views

2006 Audi A4 2.0T, No passing power

I have a 2006 Audi A4 2.0T Turbo Tiptronic Automatic that has no passing power. When I step on the accelerator the car will shift down into a lower gear, rev about 3500 RPMs but will not shift up ...
3
votes
2answers
1k views

Engine Revving/Misfiring - Formerly Running Lean - No Trouble Codes Now

For a few months now my 1999 Toyota Avalon XLS (California model - this apparently affects the emissions specs - I'm in NY however) with around 105k miles has been giving me these totally random ...
3
votes
1answer
373 views

How much vacuum should be present in a 2 stroke intake manifold?

I have a 2 stroke Mercury 2.5 hp that has recently been dropped in the water. The motor used to run fine but now it won't start. I have dried the motor out and cleaned the carby, it's got plenty of ...
2
votes
2answers
2k views

Aftermarket start-stop system

I am looking for an aftermarket device that turn off the engine when the car is in rest and turn on the engine when the throttle is pushed. Which are the producer? Where i can find it on internet?
1
vote
2answers
481 views

Possible to diagnose broken transmission without starting engine?

While I know a little about cars, the bulk of my knowledge came from when I was a kid bolting on stuff to my Honda and racing it illegally. (So, not much.) My '96 Civic DX (5-speed) recently passed ...
9
votes
6answers
21k views

Do I need to torque my spark plugs?

I have never torqued them before on several vehicles that I do tune ups on. I just apply a bit of anti-seize lube and get them "snug" and everything seems to work fine. Should I be using a torque ...
4
votes
2answers
1k views

Forced induction and engine braking

So does forced induction negate the effect of engine braking on compression motors? For example, going down an incline, drop into 3rd (automatic) to get some engine braking going. With my new Chevy ...
2
votes
1answer
1k views

Engine has become noisy

I have a 1993 Mercedes 308d. It always used to be fairly quiet, but recently the engine has started to sound quite noisy. Its OK when started then after it gets warm you notice when you come to a ...
1
vote
4answers
325 views

How to prevent a car from boosting?

Considering a turbo car. The specific model is a Dodge Caliber SRT 2008, but I'd prefer a more generic answer. How can one prevent the car from boosting while still having a car that can be driven ...
10
votes
4answers
27k views

What colour should power steering fluid be?

Recently started shopping for first car, so want to know as much as possible when going into a sale. Car I looked at recently has a brown dirty colour in the power steering reservoir, but the stuff ...
6
votes
1answer
352 views

Fast idle when engine is hot

I have a 2001 Buick Century. Lately, after driving around long enough for the engine to get hot, the idle speed will sometimes race. The car will want to surge forward even when I'm not giving it ...
3
votes
1answer
451 views

2004 Buick Rainier Ignition Coil Replacement

I have a 2004 Buick Rainier (6 cyllinder). I just found out the 4th bank ignition coil is bad. Seems easy enough just looking at it (I just replaced a few of the spark plugs a few nights ago with no ...
3
votes
1answer
210 views

2001 Audi A4 corroded part… What is it?

I noticed under my hood that a piece looks corroded through. My car hasn't given any warnings or check engine lights and no liquid is coming through. No one I ask knows what it is. Please help! ...
3
votes
1answer
2k views

Engine does not have enough power (and has limited RPM)

I have a 1982 Mercedes W123 (engine M102 - gasoline, 2.0L, 80kW, with Stromberg 175CDT carburetor). The car has been modified to run on LPG, the modification consists of adding a LPG tank, vaporizer ...
4
votes
2answers
125 views

Top Dead Centre

I replaced a cylinder head gasket on my 1993 Holden Apollo (Same engine as the toyota camry 5S-FE). However when I went to get TDC I think I may have forgotten to put the car in Neutral. Could this ...
1
vote
0answers
89 views

How can I rev my engine in drive while holding the brake and not stall? [duplicate]

Possible Duplicate: Why doesn't the engine stall out when you come to a stop with an automatic transmission? Occasionally I press both pedals simultaneously. I can feel my car trying to ...
3
votes
2answers
743 views

Advice needed - My car has burn mark on hood and seems to be leaking oil

I have a 4 year old, well loved Honda civic with only about 25K. It has been serviced nearly every 6 months. I just took it for a service a few weeks ago and today I noticed that it seemed to be ...
7
votes
3answers
333 views

Will I be okay running thinner oil with a minor oil leak on an older car?

Recently when I had some work done I was shown a minor leak, I believe he told me it was the oil pan. It doesn't drip out onto the ground, but if you look closely you can see condensed oil drops on ...
2
votes
2answers
182 views

Are engines of the same model bike identical?

I am planning to buy a Yamaha Crux from the showroom. I'd like to know how to compare the engines in each of the available bikes of the same model. Will they differ in any way? One mechanic I know ...
4
votes
3answers
1k views

Is it feasible to Turbo a NA engine while maintaining 87 AKI octane fuel use?

I initially thought there should be a way to bolt on a small aftermarket turbo onto my naturally-aspirated Honda D17A2 (9.9:1 compression ratio) engine in my EM2 Civic EX without having to switch from ...
5
votes
1answer
3k views

How to clean the MAF sensor on a 1997 Nissan Altima?

I have a 1997 Nissan Altima sedan. I’ve been told the issues I’m having with my car is from the mass air flow sensor. I was wondering how to clean/repair this sensor and contact points the best? What ...
6
votes
2answers
9k views

Why does my engine perform poorly and get bad gas mileage after using fuel injector cleaner?

At the advice of someone at a local auto parts shop, I poured a bottle of fuel injector cleaner into my gas tank. This happened around the same time that I had a brake job done and rotated my tires. ...
8
votes
1answer
485 views

Put Stop leak into engine. Can I reverse the process?

I accidently poured Barsleaks stop leak for the radiator into the engine oil compartment. Is there any way I can reverse the process? The stuff is hardening already. This a 2004 Volvo S80.
1
vote
1answer
2k views

1998 Ford Contour P0171 P0174

I have a 1998 Ford Contour that has a check engine light. I checked the codes, and found: P0171 System Too Lean (Bank 1) P0174 System Too Lean (Bank 2) P0401 Insufficient EGR Flow P1131 Lack of ...
7
votes
4answers
33k views

Is engine braking harmful? [duplicate]

Possible Duplicate: Does Downshifting (Engine Braking) Cause Extra Wear and Tear? My wife and I have a disagreement about a practice of mine--engine braking. When I'm driving her manual ...
3
votes
2answers
4k views

BMW E30 M20 oil warning light goes on on hot days but the motor sounds and performs fine

The car: BMW '90 E30 320i Cabrio with the six-cylinder M20 engine. The problem: the red engine oil warning light inside the instrument cluster (not the check control) lights up after some driving. ...