Internal Combustion Engine. Most engines in road going vehicles are 4-cycle internal combustion gasoline engines.

learn more… | top users | synonyms

2
votes
1answer
469 views

Ford Fiesta Mk6 engine component

I have a ford fiesta mk6. Can someone please identify the hose on the left (green square) ? It's cracked right now and it's leaking cooling liquid (I think). Here is a picture of the engine: PS: ...
2
votes
1answer
178 views

Small Engine Storage

I get conflicting info concerning small 4-cycle engine storage and would appreciate any recommendations. My snowthrower is stored in the off season April thru Oct. The manual for the engine says run ...
1
vote
0answers
42 views

Does “slogging” an engine (open throttle at very low RPM) increase mechanical wear? [duplicate]

When I was taught to drive, I was told that "slogging" the engine - open throttle at low RPM, e.g. 1000 RPM - was bad for it. Particularly when driving up a hill as that means you'll be stuck at that ...
1
vote
5answers
1k views

Why didn't tuning box or remap work on my mondeo st tdci

I brought a tuning box a few months ago. When I fitted it, it didn't work so I sent it back. They tested it and it was working fine, so I tried it again, but it wouldn't make my car any quicker. So I ...
0
votes
1answer
586 views

what is the advantage of octane 90 petrol vs octane 95? how it effect to fuel consumtion of a car? [duplicate]

i need to know about advantages of octane 90 petrol VS octane 95 or unleaded. how it effect to fuel consumption of a car?
4
votes
1answer
812 views

Astra Turbo sounding like a diesel

http://www.youtube.com/watch?v=ph6JOhFJcJA The video above demonstrates the sound I hear when my car is at operating temperature. I don't know why it would sound so rough. It doesn't sound quite as ...
3
votes
1answer
991 views

What could make a noise when I decelerate with a manual gearbox?

Update 06/23/2014 One week later, this noise is now very, very loud, even when I don't decelerate. As soon as I put the 5th gear and clutch, it vibrates whether I accelerate or not. It's like if the ...
4
votes
1answer
2k views

Engine suddenly died on uphill, then went back to life after a few tries

Car: BMW 318 TDS Compact. 90HP. 168.000KM Situation: was driving a very intense uphill section at 70km/h, in 4th gear (2.000 rpm). Everything was ok. Engine sound, temperature, etc... Suddenly, ...
4
votes
0answers
71 views

Chevrolet Corsa doesn't accelerate until I restart the engine

It works fine for the first 10 km or so, then it'll suddenly stop accelerating, as if I weren't even pressing the pedal, and I have to restart the machine and it'd work again, for at least other ...
3
votes
1answer
91 views

Jeep Grand Cherokee redlines after engine overhaul

I just replaced pistons, lifters, pushrods, and head on a 1999 Jeep Grand Cherokee. It started right up, but the RPM went to redline. I checked throttle body components, the linkages are OK, but the ...
1
vote
1answer
142 views

Engine torque throughput curve is flat or wavy in low gears between 2000 and 4000 rpm

As the title says BMW's (93 E34 525i M50B25TU) engine misbehaves in low gears, namely in 1st and 2nd, most of the time when the engine is cold but sometimes even when it is properly warmed up. The ...
5
votes
2answers
2k views

Do fast cars need to occasionally be driven fast?

In the broad spectrum of cars, there's higher end models with sport-focused engines. Examples would be an BMW M3, and even more so Ferraris and Koenigseggs etc. Apparently they're more fussy, in that ...
3
votes
3answers
746 views

2003 Nissan 350 Z won't accelerate

We own a Nissan 350 Z and this morning it would not start. It would turn over but it wouldn't fire. After pulsing the gas a little bit it would start but then letting off the gas would cause it to ...
3
votes
0answers
241 views

2004 Chevy Malibu Classic Acceleration & starting problems

I was riding along and my 2004 Chevy Malibu Classic stopped accelerating. I was pressing the gas but it wouldn't go any faster. I coasted off the highway and turned it off, then I started it back up ...
2
votes
2answers
4k views

Should I replace a “blown” engine on my John Deere mower?

I have a 2005 John Deere 115 19 HP automatic riding mower. After leaving it in the garage all winter, I started the mower, drove it about 50 yards, and engaged the blade. It went about 20 feet, made a ...
1
vote
2answers
96 views

Can a variable engine exist?

I have really no knowledge about mechanics but such a curious guy. Excuse my Ignorance. Does a variable engine exist? Like as the vehicle slows down the engine will slow down and when the vehicle ...
2
votes
2answers
2k views

Formula for calculating output power after putting a rpm reduction gear

I'm thinking of starting of converting an old car to an electric car. I have a question, but google won't answer me my very long not very well explained question. Take this scenario. I would take a ...
2
votes
1answer
2k views

How can I identify which cylinder is responsible for a petrol engine misfire?

My petrol engine has developed a persistent misfire. How can I figure out which cylinder is the culprit in order to hone in on the root cause?
1
vote
2answers
7k views

I have an issue with Stepping on gas and no increase in speed

It only happens rarely.. but sometimes when stepping down the gas it would suddenly max out the speed gauge, and you hear the very loud engine noise as if i stepped down the gas all the way, but what ...
6
votes
5answers
12k views

Why can some cars go through water while others can't?

Why can some cars (mostly old Russian cars on YouTube) seemingly go through water while others can't? I'm talking about situations when the water level is at half the height of the car, so the engine ...
3
votes
1answer
101 views

How are the engines of street cars different from trucks and performance cars?

Consider three cars. All three cars have different engines, but all engines are 3 lit. V6s. The engine in first car is made for great gas mileage. The engine in second car is made to be able to tow ...
1
vote
1answer
176 views

Engine swap considerations

I'm interested in restoring an old car that has a relatively underpowered engine. I'm curious how difficult it would be to replace it with a different (cheaper, more common, more powerful) engine. ...
4
votes
1answer
284 views

Removing difficult engine bolts

Currenly trying to remove part of the engine mount off my Vauxhall Astra to get to the thermostat and I've hit a stumbling block by two VERY tight screws that are almost impossible to get a wrench on ...
3
votes
3answers
896 views

How can I do a cheap but safe and good tuning which will improve the cars performance?

I have a Skoda Octavia 5 1.6 MPI and I want to make a good cheap safe tuning that will increase the cars performance above 100 hp it already has. How can I do that?
2
votes
3answers
109 views

How to identify parts needed for a repair?

Here's a general question: How do you identify, in advance, what parts will be necessary for a repair (including all the various fasteners, o-rings, etc), and order them? Certainly for simple ...
3
votes
3answers
152 views

do all quattros have shafts connecting front and rear axles

I have recently purchased a 2009 Audi A5 Quattro, and in looking underneath the car there does seem to be a place for a shaft to connect the front axle to the rear axle (which you would expect) but ...
3
votes
2answers
179 views

Seized engine on 13 yo Infiniti, out to pasture for 1 yr. Donate for scrap or worth a revisit?

We live in the temperate Northern California foothills, and lo these many months ago, my wife took my father's 2001 Infinity up the Reno mountain pass without seeing (or checking) the dangerously low ...
1
vote
1answer
365 views

Hyundai Tucson Diesel 2.0 2008 - Difficulty Starting

Hyundai Tucson Diesel 2.0 2008 and takes at least 4-5 attempts to start before it idles badly for about 10 seconds and then is fine. Doesn't die at the traffic lights, no problems at all otherwise. ...
3
votes
2answers
2k views

What is that knocking sound my engine makes when the revs drop too low?

I have a 2013 Subaru Impreza with a 2.0 liter engine and a manual transmission, and when I let out the clutch too fast while in reverse or 1st, sometimes the engine RPM will drop so low that it makes ...
4
votes
1answer
4k views

High pitch whistle at a very particular throttle level

The symptom: while accelerating, at a very particular throttle level/pedal angle my engine recently started whistling in a very high pitch. If I let go of the gas or push it in more the sound goes ...
2
votes
1answer
968 views

2003 Honda Civic 1.7 vTec - White Smoke from the tailpipe

I have a Honda Civic 2003 gx 1.7 liter vTec stick shift 4 cylinder. Just today I had to put oil in my car. Drove for about 5 minutes got to a light and when I shifted into first gear a white cloud of ...
1
vote
1answer
138 views

1981 amc concord won't start

I have a 81 amc concord. I drove it and it died and went to start it again there was nothing. Replace starter battery and starter relay. There is no headlights no buzzer no radio no dome light. Any ...
4
votes
2answers
2k views

Troubleshooting a Misfire

Car: 2005 Dodge Grand Caravan In the past few days I started to feel the engine stumble. Yesterday the engine light came on and the error was a that cylinder 4 was a misfire (there was also a ...
-1
votes
2answers
490 views

The disadvantages of mitsubishi lancer 2007 [duplicate]

I am planing to buy a new car that has to be good enough to be used everyday . I have tried the speranza and the brilliance but weren't good and not reliable to be used everyday . Many friends ...
5
votes
3answers
3k views

Why are drive by wire systems so unresponsive?

Purchased a honda Fit seeing their reasonable price and good engine power. However I have a lag between me pushing the pedal and the engine responding. I constantly have to downshift to get any power ...
3
votes
2answers
1k views

Mini Cooper P1638 code

I have a 2007 Mini Cooper. It keeps throwing code P1638 on my code reader on these really really cold mornings, and the engine seems to search for idle, reving betwween 500RPM and 1400RPM. The car ...
3
votes
2answers
1k views

Going more than recommended Speed in Break-in Period

I have a new Yamaha motorbike. Seller told me not to ride speed more than 50 Kmph for first 1000KM but I rode it 60 for 10 - 15 minutes due to some reason. How does it affect to my Motorbike ?.
1
vote
1answer
321 views

How to spot remove high temp engine paint?

I've recently painted an engine post reassembly, due to cost reasons. No doubt I've encountered overspray on certain parts. I know sandblasting the engine proper is a huge no-no, and soda blasting ...
2
votes
1answer
136 views

Engine Whine Problem

I have a 2000 Ford Explorer V6 4.0, manual. I bought it brand new and have put just over 175,000 miles on it. I was driving down a dirt road to my home and noticed what sounded almost like a hissing ...
1
vote
2answers
496 views

Proton jumbuck loss of power/shaking

I was driving to work this smorning when my car started shaking and losing power no matter how much I put my foot down after about 2km of driving it started working fine again but the engine has a ...
4
votes
1answer
17k views

How much does displacement affect performance?

I'm interested in learning more about the steps that can be taken to increase the performance of an engine. I'm curious how much displacement affects performance. For example, compare the following ...
2
votes
2answers
415 views

What does CC refer to when describing an engine?

I have been learning about various older cars on Wikipedia. I've always wondered what the "cc" refers to in the engine description. For example: 1964–1969 Porsche 911: 1991 cc 1965-1969 Porsche 912: ...
5
votes
3answers
3k views

Cylinder 1 and 4 has low compresion, after engine has been redone

I have a Opel Corsa 1999 B type. We had a mechanic redo the engine about 4 months ago, but this week it just does not want to start. Today had other mechanic look at the engine, and did a quick ...
4
votes
2answers
288 views

Can I use a CNC machine or waterjet to make an adapter plate to adapt a 5 speed transmission to a rare, obsolete engine?

I am the sad, proud owner of a Nissan SD33T (Diesel), mated to a 4 speed T-19. The power this engine outputs (101HP, 160#/TQ stock) means it struggles on the highway, and I don't want to sacrifice my ...
2
votes
3answers
170 views

When should we change the machine lubricant? Cold engine or hot engine?

According to the manual, we should change the lubricant when the engine is still hot to easy the lubricant flow out completely. But from other perspective, loosening the bolt at the high temperature ...
2
votes
1answer
143 views

drove without #3 cylinder plug wire. Help!

I drove without a spark plug wire in my 1978 GMC Sierra 5.7L. It drove fine and I didn't notice any problems until it died after about 2 miles. It was acting as if it was out of fuel or power when it ...
2
votes
2answers
176 views

1997 ford f150 lariat

We have a 1997 ford f150. My husband replaced the thermostat, but it still reads cold and doesn't put out any heat. Any suggestions? We are in Ohio, it's December, and it's freeeezzzing - need heat! ...
5
votes
4answers
1k views

Engine repeatedly dies at shorter and shorter intervals this cold morning, finally won't start

I have Pontiac Grand Am 2004. It's been needing some regular maintenance, but other than that runs mostly fine. When I went out to start it this morning, it started fine. I went to start brushing snow ...
4
votes
3answers
7k views

Slower Engine Start When “Cold”

I have a 2012 Honda Civic EX (4 Cyl Automatic, 5-speed transmission, Regular Gasoline). I get it serviced regularly and it has around 28k miles. The engine light has never come on. I am noticing this ...
2
votes
2answers
3k views

Changing Motor Mounts

My 2007 Ford Focus ZX3 SES (65k miles ) has a vibration at all engine speeds. Other research has led to a high probability that this is from worn out motor mounts. I have read after market ...