Internal Combustion Engine. Most engines in road going vehicles are 4-cycle internal combustion gasoline engines.

learn more… | top users | synonyms

8
votes
1answer
1k views

How to use an engine stand

This is one thing which I have asked many times on a car forum and never received a satisfactory response for. I know that the engine block is somehow bolted onto an engine stand like the one ...
7
votes
2answers
343 views

How do modern engines differ than older ones

Modern engines produce more horsepower with more fuel economy but with the same procedure of burning the fuel air mixture and moving the piston, but the old ones and new ones are both four cylinders ...
7
votes
2answers
563 views

Two-Stroke Diesel Engine - Do they use forced induction on them?

As I have indicated before, I'm very diesel ignorant. I just know the basics, very basics. In a two-stroke diesel engine using forced induction seems necessary but at the same time I see challenges. ...
7
votes
1answer
167 views

Car can't start after rocker gasket change

I have a 2008 BMW 120d LCI with N47 engine. Recently was diagnosed with some oil leak on the rocker gasket near the injector area. Were advised to change the rocker gasket seals. So I did change the ...
1
vote
1answer
235 views

2000 Toyota Celica GT stalls with acceleration few minutes after starting

I have a 2000 Toyota Celica with about 180k miles. When my car has been off for a few hours and I try to start it up, if I try to press on the gas (either in drive, reverse, or park) within a few ...
3
votes
0answers
218 views

2003 Ford Taurus SE, Vulcan engine - Chirping sound from intake manifold, car stalling out?

Over the past 2 weeks or so my car has been making a chirping sound near the intake manifold and the accelerator. The chirping sound comes and go, and about a week ago I had an issue where my car ...
3
votes
2answers
200 views

2006 Pontiac g6 rough idle and intermittent spongy brake and starting issue

I have a 2006 Pontiac G6 with 160k on the 3.5 motor. Around 155k the brake pedal went hard and spongy. Also, about 1 in every 40-50 times I start it cold, the starter will turn without a successful ...
6
votes
4answers
232 views

Cheap vs Expensive Fuels [closed]

What is the difference between the cheapest fuels in a place like Tesco's and the 'high quality', highly priced competitors? Is there actually any noticeable difference in available power, engine ...
16
votes
4answers
3k views

When does it make sense to replace a camshaft?

Preamble (Rant) I was reviewing this question in which the OP presents a repair quotation that includes replacing the "intake camshaft" to fix an engine that had overheated. To me this ...
3
votes
1answer
330 views

Different heads on Dodge Magnum 360

I'm working on a 98 Dodge Ram 2500 with a Magnum 360 V8 (roller cam shaft). It had a cracked head on one side, so I purchased a pair of remanned heads from an eBay retailer. These heads are the 466/...
3
votes
0answers
44 views

Break-in engine [duplicate]

I am going to buy new car Mitsubishi Pajero Sport (Model: MBS MT 4x4). I've heard stories of people 'breaking in' engines for the first few hundred or couple thousand kilometers using methods such as: ...
3
votes
1answer
369 views

VW Passat B5 EPC Light on Dashboard

There is a yellow light on my dash that says 'EPC'. I have no idea what this could mean on my car as I haven't noticed any difference in the way it drives, nor are there any unusual sounds other than ...
0
votes
3answers
349 views

99 honda civic motor issues

I have a 99 honda civic. The engine started knocking while my boyfriend was driving it. He said it had just started. It was low on oil so i figured it was just overheating. However that didnt fix the ...
6
votes
5answers
5k views

Remove rounded manifold bolt

I'm trying to take off the manifold bolts on an old Chevy 350 (the ones that connect the manifold to the header). I got 4 out of the 6 bolts out, but 2 are extremely struck and rounded due to all the ...
7
votes
1answer
215 views

What should one do to reduce the HP lost at the wheels on an automatic transmission?

I have a 1990 Toyota Supra Turbo 4 speed auto. I've done some research about automatic transmissions and manual transmissions and what are the positives and negatives of each. (For example, MT is said ...
3
votes
0answers
46 views

Antifreeze in my engine, and now it's making a ticking noise

I changed a busted intake out, also changed the plugs. Some old antifreeze get in the plug holes when I pulled the plugs. I have reassembled the car, but it runs bad and has a ticking noise. ...
6
votes
2answers
226 views

RPMs jump to 2500 when clutch is disengaged or transmission put in neutral

Good morning all. I drive an 05 Chevy Cavalier, 2.2L, 5-spd manual trans. Lately I've been having issues which I am told is throttle related. As I'm driving for a little bit (time varies) I go to ...
4
votes
1answer
131 views

What is causing a clacking knocking like sound on my toyota camry 1999

I got the heads redone by a engine tech, but for some reason after it starts I get this clacking knocking like sound. The timing is correct. I'm assuming the firing order is correct as well, But just ...
1
vote
1answer
384 views

Mk1 VW Golf/Rabbit - Engine idle fluctuates at random times

I have a Mk1 VW Golf/Rabbit with K-Jet mechanical injection. Occasionally when I pull up at stop lights the engine idle will rhythmically dip and climb (between 600 and 1200 rpm). This probably ...
2
votes
3answers
76 views

2002 Mitsubishi Galant - Squeaking and starting problems

Just got this 2002 Mitsubishi Galant. I knew it had couple of problems with it, as I'm decently handy with cars. I thought I could figure out the problem. I'm a bit stumped on this one. My first ...
8
votes
3answers
561 views

Why don't all diesel engines have throttle plates?

I learned recently that many older and some newer diesels don't have throttle plates to control airflow. I was also quite shocked to learn about a condition called diesel engine runaway. Apparently ...
4
votes
2answers
217 views

Engine idle surging on startup & sputters during acceleration

So I don't know anything about cars. But my truck has been having a few problems. It starts up fine and then the idle is really weird, the RPM's surge. The motor keeps bogging down and when you try to ...
2
votes
1answer
186 views

Engine oil reducing almost to half

I recently changed engine oil of my Apache rtr 160. I used otul 5100 15W50. Later I started experiencing vibrations, a lot of vibrations. I checked on the engine oil. The quantity is reduced to half. ...
5
votes
1answer
77 views

New fuel pump and spark plugs but gas pedal still not responding

I have a Ford Explorer 2007 and I'm experiencing the car cutting out on me. For example, when turning a corner with the engine revs low, the gas pedal wouldn't respond and then the car cut out. It ...
7
votes
4answers
2k views

why do engines have so much unused horsepower?

I've looked at the power rating of an engine used in a Humvee (5500 lbs) and was surprised it's only ~190 horsepower, which is exceeded by many 4 door sedans. So an obvious question is why doesn't my ...
4
votes
1answer
87 views

Can snowblowers auger belt weaken or is this just wet snow

So I have an old Toro 824 used snowblower from the mid 90's. The last two times I used it we had wet snow. Snow kept getting clogged and I had to break it up with broom and then it would just clog ...
3
votes
2answers
390 views

Why there is no injection on 1st and 4th cylinders in Fiat Punto?

I have Fiat Punto 2 1.2 with LPG (sequence, stag 4). There is problem with the injection on the 1st and 4th cylinders. Sometimes it works and sometimes it doesn't. 2nd and 3rd work without problems. ...
4
votes
1answer
111 views

Valve Adjustment - 1975 Harley Davidson Ironhead

On Harley Davidson Ironhead motor (1975 XLCH), how do I adjust the valves? I seem to remember a mechanism in the bottom end but....I can't recall.
2
votes
2answers
3k views

Engine oil leak from motorcycle

I'm having this peculiar problem. There is an engine oil leak from my 160 cc motorcycle. The thing is that, I got the engine oil changed couple of days back, by a nearby mechanic. Now the problem is ...
4
votes
1answer
109 views

Why do old motorcycle engines rev so slowly?

I know someone with an older Yamaha XS750. It's from the late 1970's. When I rev the engine in neutral it rev's up really slow. It comes down from the revving a slowly as well. When I rev a 2005 ...
4
votes
0answers
40 views

Saying its running hot but full of coolant and not over heating

2005 Hyundai Elantra. Says its running hot but has coolant and so far hasn't over heated and also can't turn on heat in car because smoke pours from vents into the inside of car.
5
votes
2answers
70 views

What senses/controls how much fuel is spent for a given RPM?

When maintaining a constant speed on the highway whether up, down or flat the engine still has the same RPM (assuming the incline is shallow enough not to require a gear change) - common sense would ...
3
votes
2answers
3k views

Peugeot 206 engine occasionally cutting out when idle

Sorry if this is vague, I don't know very much, but I'll do my best. I want to have as much information possible before taking it to a garage to do anything. I have a 2003 Peugeot 206 1.1l which has ...
6
votes
1answer
64 views

2004 Tahoe Conking, Glub Glub Glub

My 2004 Tahoe is not running well and conked out on me the other day. I just had it repaired for some other reasons and the repair shop suggested we needed to have spark plugs replaced so it will run ...
2
votes
1answer
40 views

Help with six cylinder out of a trailblazer.05 into a 06

I would like to know if I can just drop in. Can't find anything on how to tell what reluctor wheel is in the motors. Need help due to the fact that I took on a project and don't have a lot of ...
5
votes
3answers
600 views

Should I avoid full throttle when driving with a cold engine?

Apparently I should avoid full throttle until my engine temperature is warmed up fully (to 90 degrees on the gauge) Normally I just get in and drive normally after about 10 seconds, and then after ...
22
votes
6answers
26k views

Is Start & Stop technology good or bad for my car? (Alfa MiTO)

I was recently in the lucky position to obtain an (almost brand new) Alfa Romeo MiTo, Progression. Like many new cars coming out these days, it has "Start & Stop" technology that turns the engine ...
15
votes
8answers
30k views

My car's coolant temperature reaches almost 100 C / 212 F in a fast pace

Today, after a very hot day, I saw that my coolant was almost reaching 100C/212, I pulled over, stopped and took a look over the hood. The very little water that remained in the coolant tank was all ...
17
votes
4answers
56k views

what is difference between DOHC and SOHC?

I want to know the SOHC and DOHC configurations. On what factors an engine manufacturer decides to go with SOHC or with DOHC, what should I choose? DOHC or SOHC?
3
votes
1answer
188 views

Inconsistent warm engine tick sound in 2013 F-150

I'm the original owner of a 2013 Ford F-150 XLT 3.7 which now has 30,000 km. After the last oil change, the engine is making an inconsistent tick sound when warm and also vibrates a little. The ...
7
votes
3answers
194 views

Will an old engine have worse fuel efficiency than a new engine?

I have a gasoline-engine car that is four and half years old and has been driven for 60 000 kilometers. I have noticed that the fuel efficiency is not what it was when the car was new. However, I ...
1
vote
2answers
124 views

2001 GMC Jimmy wont start? [closed]

Hi I have a 2001 GMC Jimmy it was running fine, then parked it. it starting acting funny, sometimes would take a couple times to start, so checked my oil dipstick, it read a little high and smelt ...
3
votes
2answers
1k views

Cold engine works on three out of four cylinders

When my Honda CBR900’s engine is cold, it works only on three cylinders. When the engine begins to warm, all goes fine and all the cylinders begin to work. What can cause this?
7
votes
2answers
11k views

Why would my engine temperature raise from normal to high and drop back down again?

I have a Nissan Micra (UK, 51-plate, 2001 model) that I have been using to drive to work on a daily basis - 10 miles each way a day on a variety of roads - streets, main roads, main roads in traffic, ...
4
votes
2answers
239 views

Filling gouge on oil sealing surface in aluminum engine block

I bought a 2004 Subaru Impreza Outback Sport (2.5L EJ251 SOHC) a year ago and have found a leaking crankshaft seal. When going in to replace it, I see that the leak is probably caused by a small gouge ...
5
votes
1answer
191 views

Subaru Impreza 2.5i - What are reasons my engine would sputter when turning off?

I have Subaru Impreza 2.5i (2.5 NA). My car's engine sputters a bit when turning it off. Specifically it seems like the cars engine keeps turning for a little longer right after I remove the keys. ...
11
votes
1answer
377 views

2005 Subaru 2.5 RS - Engine-wise, how damaging is burning oil?

Assuming that an engine always has enough oil to be lubricated properly but burns quite a bit of oil, can it cause any damage in the long-term because it doesn't belong in the combustion chamber? I ...
5
votes
4answers
4k views

Add 2 stroke oil to a 4 stroke petrol engine during burn-in period

I'm planning to get a new petrol (gasoline) car soon. A friend of mine, who worked as a motorbike mechanic when he was young, told me he puts a small quantity (125 ml / 4 oz) of 2 stroke oil in the ...
3
votes
2answers
354 views

Who gets title if you sell a frame and an engine separately

I have a POS (Piece of S**t) salvage motorcycle I purchased cheap for a purpose which has now passed. I'm ready to get rid of it and there's a guy down the street that mentioned possibly wanting to ...