2
votes
2answers
28 views

Rough Acceleration & ticking noise

Vehicle: 2000 Blazer 4WD Automatic 260,000+ miles (Runs perfectly if not for something going wrong every two weeks) Symptoms: Engine sounds rough when accelerating When accelerating there's a ...
1
vote
1answer
18 views

99 chevy suburban motor kicks back

What would cause a fuel injected motor to kick back while cranking it? I have a 1999 chevy suburban 4wd 5.7 ltr. I know it needs an intake manifold gasket, but would that cause it to kick back and ...
4
votes
1answer
63 views

Random Misfiring - Tried All Basic Fixes - Tech Says Engine Ground

Starting about a week or two ago, my 3.4L engine (2004 Chevy Monte Carlo LS) has thrown a p0300 code, random misfire. Here are the things I've done: Changed spark plugs and wires Knocked fuel ...
1
vote
0answers
36 views

Chevrolet Corsa doesn't accelerate until I restart the engine

It works fine for the first 10 km or so, then it'll suddenly stop accelerating, as if I weren't even pressing the pedal, and I have to restart the machine and it'd work again, for at least other ...
1
vote
1answer
71 views

Gas pedal not responding

It just doesn't work, as if I weren't even pressing it and it happens regardless of the speed. I have to turn the engine off and on again and it'll work for another 3 or even up to 20 minutes ...
2
votes
0answers
61 views

2004 Chevy Malibu Classic Acceleration & starting problems

I was riding along and my 2004 Chevy Malibu Classic stopped accelerating. I was pressing the gas but it wouldn't go any faster. I coasted off the highway and turned it off, then I started it back up ...
2
votes
1answer
78 views

drove without #3 cylinder plug wire. Help!

I drove without a spark plug wire in my 1978 GMC Sierra 5.7L. It drove fine and I didn't notice any problems until it died after about 2 miles. It was acting as if it was out of fuel or power when it ...
2
votes
3answers
798 views

Remove rounded manifold bolt

I'm trying to take off the manifold bolts on an old Chevy 350 (the ones that connect the manifold to the header). I got 4 out of the 6 bolts out, but 2 are extremely struck and rounded due to all the ...
2
votes
2answers
135 views

SB350 cutout at freeway speed, revs fine in neutral

Was hoping someone could help me out with an issue I'm having since I'm running of ideas... In case it helps, its a 71 Nova with a small block 350. Carbuerated and HEI, without any computer chips or ...
1
vote
1answer
169 views

Adjusting the idle setting on a 2005 Cavalier

The air conditioning unit on my 2005 Cavalier only engages when the engine is idling above a certain level (observationally, it appears to be between 1000 and 1200 rpm). During the summer months, ...
3
votes
1answer
1k views

Car Stalls When Coming to a Stop

Make: Chevy Model: Cavalier (4 cyl.) Automatic Year: 1993 Miles: 230K Normally my Cavalier drives just fine without problems. However, if I drive for 45+ minutes then it will sputter and stall out ...
2
votes
1answer
440 views

Normal spark advance for 96 LT1 engine? STFT also varies bank 1 vs bank 2. What does it mean?

I used my HP Tuners as a scan tool on my 96 LT1 in an Impala SS. The "Advance" as read by the tool sits at -12 deg at idle, then goes down to -35 deg if I rev it (no load) to about 2k RPM. I'm ...
3
votes
2answers
445 views

97 GMC k1500 missing badly. Ignition system problems?

I have a 97 GMC Sierra k1500 with a 305 (5.0L) engine. It seems like every year for a few years now it will suddenly start missing very badly. There will be random misfires on all cylinders almost ...