The clutch disengages the engine from the gearbox in a manual-transmission car, enabling the driver to change gear.

learn more… | top users | synonyms

13
votes
1answer
268 views

Engine noise / rattle when clutch is fully pressed [BMW 320d e46, manual]

I have a strange noise, like a rattling/stomping sound at idle, when pressing the clutch pedal. The clutch and the flywheel (DMF), were both changed with new parts. Except for that sound, the car ...
7
votes
1answer
86 views

Manual 2008 Ford Ranger won't go into gear sporadically

I recently purchased a used 2008 Ford Ranger. Not long afterwards I began having trouble getting it into gear. I took it in and the clutch was worn out and needed to be replaced. The slave and ...
4
votes
1answer
57 views

Car is shaking, feels like the car doesn't have as much power, gear knob also shaking and exhaust smelt of fuel (and was louder than usual)

Okay so the car is a Nissan 200SX S15 and as i'm relatively new to the manual transmission I wanted to practice hill starting (which is where i screwed up). I pretty much let go of the clutch way too ...
3
votes
1answer
55 views

2005 Honda CBF 600 — clutch plates get stuck overnight

I bought a 2005 Honda CBF 600S, rode it for about a week, and then asked my mechanic to check if everything is OK, and to replace the clutch cable. The mechanic also replaced all the fluids, ...
8
votes
0answers
80 views

Clunking sounds when decelerating or idle with clutch engaged

I have an issue with a 2010 Opel / Vauxhall Insignia 2.0 CDTI Sports Tourer (aka Buick Regal in the States if I'm not mistaken) and I'm having difficulties pinning it down. It's going to be a lengthy ...
4
votes
0answers
40 views

96 Ranger. I replaced the clutch. Now it won't go into gear

I'm no mechanic and I'm stuck. I've got a 1996 2.3L Ford Ranger. I replaced The clutch disk, pressure plate, pilot bearing, and release bearing. I then got the transmission put back into place. ...
4
votes
0answers
67 views

Reason for high petrol useage (Ford Focus Titanium 2013)

I'll start off with the car specs: 2013 Ford Focus Titanium Navigator 1.6L with about 39k miles on the clock. I recently checked the oil on the engine and it was on the bottom notch of the ...
4
votes
0answers
121 views

MG ZS 180 - overheating clutch

So I got a new (well 2004) MG SZ 180 the other day and it turns out there is a small issue with it. After using the clutch in stop/start traffic, changing gear gets harder and harder until I end up ...
3
votes
0answers
34 views

What are the differences between a normal and an anti-hopping/slipper clutch?

Obviously an anti-hopping clutch won't make the motorbike hop. How is this achieved? What are the mechanical and functional differences between a normal and an anti-hopping/slipper clutch?
3
votes
0answers
59 views

Clutch drops to the floor when I start to apply the brakes

Why does my clutch drop to the floor of my 93 ford escort as soon as I start to apply pressure on my brakes. I already changed out my master cylinder and bled the brakes. Could it have anything to do ...
1
vote
0answers
29 views

Royal Enfield Classic 350, Clutch is not disengaging

I own a classic 350 which has done 5000 Kms. Recently my clutch cable broke and I tried replacing it with a new one (which I had done once before), but now the clutch lever seems stuck and it's not ...
0
votes
0answers
29 views

New alto clutch lasts not even a month with gear breakdown

A month ago I got my (78000 kilometer run)car serviced and the new clutch set was replaced. Within a month while applying reverse gear I got disconnected with gear and sent car for repair. Initially ...