The clutch disengages the engine from the gearbox in a manual-transmission car, enabling the driver to change gear.

learn more… | top users | synonyms

7
votes
2answers
3k views

How to test a clutch

I have just bought a second hand car, and I have the feeling that the clutch is worn out. How can I do a quick clutch sanity check ?
5
votes
1answer
393 views

Manual Transmission Whirs when coasting down, clutch disengaged, shifter in gear

I have a 2004 Nissan Xterra. When I am at speed, usually in 3rd or so, and I am coming to a stop, I disengage the clutch, brake, and coast to a stop, with the shifter still in gear. As I do this, ...
4
votes
2answers
27k views

Is it ok to give gas while releasing the clutch?

First question on the site, I hope this is appropriate. I drive a 2013 Ford Fusion SE with manual transmission. I learned to drive a manual as a kid but picked up a lot of bad habits. In particular I ...
0
votes
3answers
7k views

Approximately how many hours of labour is involved in a clutch replacement

Because the cost of labour varies dramatically from country to country, region to region, city to city and sometime even suburb to suburb it doesn’t make much sense to ask how much the labour portion ...
6
votes
3answers
3k views

Troubleshooting 'random' clutch problems

I've got a customer who came in complaining that the clutch pedal had gone 'funny': it wasn't 'coming back up' like it used to. As he was in for service anyway, we replaced the clutch fluid, and it ...
3
votes
3answers
22 views

1995 Geo Tracker - Shifting Issues

I just put in transmission fluid and replaced the clutch cable. I've re-adjusted it (not that I have much if a clue on what I'm doing). It did good for a few days then I had a problem with 2nd gear ...
3
votes
2answers
387 views

Difference between “dumping the clutch” and N->D in an auto?

What's the difference between dumping the clutch, and going from N->D at high RPMs with an automatic transmission? Will this cause any damage to the vehicle?
3
votes
1answer
4k views

How does a AMT (Automated Manual Transmission) work?

I know that a TCU automates the operation of the clutch. But I'm clueless on how an AMT can do anything a human does using a manual. 1)If you are stopped at a hill. When pulling off, a driver brings ...
3
votes
3answers
5k views

Manual Transmission - Stuck in Neutral

I was at a red light and my car was in neutral and got stuck (wouldn't go to first). My mechanic told me that it is the clutch and is going to cost $1,200 to replace. The guy at AutoZone said that it ...
3
votes
2answers
3k views

Clutch catches VERY low, is this bad?

This is similar to the 'clutch catches very high' question but obviously the opposite. It's a Peugeot 206 X reg and I have had it since 30K miles and it has run fine and I and the previous owner ...
2
votes
1answer
87 views

How to bleed Toyota Tacoma clutch system?

Vehicle: 2007 Toyota Tacoma 4WD v6 6 speed I found this tutorial on pre-bleeding but it is generic (not vehicle specific) and I think there are differences between the cylinder it uses and Tacoma's, ...
2
votes
1answer
417 views

Using an open vs closed clutch cover on a motorcycle with a dry clutch

A common modification I've seen on motorcycles with a dry clutch is to replace the closed clutch cover with an open one. Besides the visual and auditory differences, will I notice anything else ...
2
votes
1answer
2k views

hydraulic clutch fails to fully disengage

I have a 2005 Toyota Corolla Verso 2.0 D4D (UK model). The clutch does not disengage fully with clutch pedal fully pressed. This is a hydraulic clutch. When in gear and brake is released with clutch ...
2
votes
1answer
1k views

Adjust clutch on toyota tazz…

I took my car in for a service. Upon receiving it back I have to push the clutch in to it's absolute max before shifting gears. It wasn't like this before. If I can describe in terms of percentages it ...
1
vote
1answer
54 views

New clutch master cylinder not filling with fluid after replacement

Vehicle: 2007 Toyota Tacoma 4WD v6 6 speed I installed a new master cylinder (the truck is at about 120K mi) but when I reconnected all the plumbing, it seems like it is not filling with fluid. The ...