The clutch disengages the engine from the gearbox in a manual-transmission car, enabling the driver to change gear.

learn more… | top users | synonyms

5
votes
1answer
37 views

2002 Peugeot 206 Clutch won't disengage

When the car is running, I am no longer able to put it into any gear; like it would happen when you're not holding the clutch, so that is one of the reasons why I think there is something wrong with ...
4
votes
2answers
4k views

Clutch pedal suddenly doesn't go deep enough to engage gears

I was driving normally (no problems, everything going smoothly; never had felt any problems with the clutch, was catching on well etc.) and all of a sudden, with no warning sign or anything (no shock, ...
2
votes
1answer
103 views

Clutch is stuck disengaged and pedal will not move

My clutch pedal on my 2005 Toyota Corolla will not move. I can start the car by pressing the clutch safety switch by hand. I can put my transmission into gear with the engine running, so the clutch ...
1
vote
2answers
34 views

What will happen in result of the failure of a clutch release bearing?

I drive a 88 Mazda RX-7 non-turbo 5spd. The previous owner claims the clutch was done last July(little under a year ago) and I have no reason to doubt such claims. I do believe the clutch release ...
2
votes
0answers
31 views

MG ZS 180 - overheating clutch

So I got a new (well 2004) MG SZ 180 the other day and it turns out there is a small issue with it. After using the clutch in stop/start traffic, changing gear gets harder and harder until I end up ...
2
votes
2answers
22 views

Ford Transit not going into 1st gear easily

With a lot of Googling I've found loads of different things that could be causing this - and none for a Ford Transit so I hope someone can explain exactly what is causing this problem, and from the ...
2
votes
2answers
12k views

How to extend the life of the dual mass flywheel in a diesel engine?

I am looking for ways to improve the life of the dual mass flywheel (DMF) in my 2005 Ford Focus tdci. I have heard that they can wear out quite quickly on the Ford Focus if they are driven in city ...
1
vote
1answer
31 views

2001 Fiat punto: slave cylinder repaired brake warning light

My clutch slave cylinder was replaced today but my brake fluid warning light came on for a second on two bends. Is this more likely an electrical fault? I will take it back to the garage nect week. ...
1
vote
1answer
35 views

Achieving least wear on clutch when changing gears? [closed]

I want to do the least wear on my clutch on a manual car. I only recently passed the test and I wonder if I ever learnt to use the clutch efficiently. Here's how I change gears: foot of gas press ...
1
vote
1answer
79 views

Vauxhall Astra diesel replacement clutch

Could someone let me know if a clutch and flywheel is changed on a Vauxhall Astra diesel do they change the gearbox oil as part of the job. Many thank
2
votes
1answer
24 views

Clutch issue in 1995 Mazda Miata

My clutch pedal had absolutely no pressure unless I would pump it, but that wouldn't do much. It finally gave out so I changed the master cylinder next to the break cylinder with one that I know works ...
1
vote
1answer
110 views

Ford Ranger manual transmission randomly squeals in 5th gear

My clutch started to slip and was squealing so I had a new clutch, flywheel, slave cylinder, pilot and throw out bearings all replaced. It drives fine, but it randomly makes a loud squeal in fifth ...
1
vote
1answer
21 views

02 renault scenic. Metallic tapping sound when engaging the clutch

The other day my wife was driving the car when it lost much of its power and she described loosing power on the left side of the car. To the point that she checked the tires for punctures. This was ...
2
votes
1answer
33 views

How to bleed Toyota Tacoma clutch system?

Vehicle: 2007 Toyota Tacoma 4WD v6 6 speed I found this tutorial on pre-bleeding but it is generic (not vehicle specific) and I think there are differences between the cylinder it uses and Tacoma's, ...
1
vote
1answer
30 views

New clutch master cylinder not filling with fluid after replacement

Vehicle: 2007 Toyota Tacoma 4WD v6 6 speed I installed a new master cylinder (the truck is at about 120K mi) but when I reconnected all the plumbing, it seems like it is not filling with fluid. The ...
5
votes
2answers
35 views

01 gti not going into reverse 1st 3rd or 5th after I changed the clutch

So I changed my clutch a few days ago and now it will not engage reverse 1st 3rd or 5th gear but will engage 2nd and 4th no problem with the car on and off. I readjusted the cables but still nothing ...
0
votes
1answer
109 views

Ford Fiesta and Focus Clutch Issues

I am in the UK and I am currently planning to get a Ford Focus/Fiesta depending on the budget and features. I have viewed 2 Fords so far - a Focus (100K miles, 2001 model) and a Fiesta (35k miles, ...
0
votes
2answers
217 views

Noise when pressing clutch pedal

I have a Saab 900 and when I press down on the clutch pedal to change gear it makes a rasping noise? Could someone tell me please is this serious?
4
votes
2answers
55 views

Manual transmission difficult to put into gear. Do I need a new clutch?

I have a 1998 Jeep Cherokee Sport, manual transmission (the 6 cylinder model, I believe 4.0L). It has 4 wheel drive. I've lent the car to some friends recently who were 'rusty' with their manual ...
0
votes
1answer
67 views

Do i need a clutch replacement for my 2003 vw jetta?

I am not very good at describing car problems, but i'll try my best. My 2003 Jetta is an automatic. Here recently, while I drive, the engine light comes on. My car revs very high, even though i am ...
3
votes
1answer
104 views

Stiff clutch on Toyota Corolla: can it be adjusted?

I have a 2003 Corolla (mileage ~70K) that drives very well generally, except for one problem: The clutch has always been quite stiff since I purchased it a couple of years ago, and I think it's slowly ...
9
votes
4answers
6k views

Causes of early clutch failure EXCLUDING driver style

UK 61 plate, Ford Diesel Mondeo Estate, Econetic: clutch replaced at 31,800 miles; failure caused by 'driver style' I use my car daily for commuting and for business. It's supplied to me as a company ...
1
vote
1answer
77 views

Noise when the engine is idle

I would like to know why my car is making noise when the engine is idle, but the noise is silence when I pressed the clutch ?
3
votes
1answer
205 views

Clutch Pedal will not depress

On my 2000 Jaguar V6 3Lt I replaced the clutch friction plate and slave cylinder/thrust bearing. After bleeding the clutch, the pedal is hard frozen and will not depress. I flipped the clutch wrong ...
0
votes
2answers
46 views

All signs of clutch slipping but the car only has 48,000 miles. How can this be?

I have a 10 yr old fiat panda with 38k miles on the odometer. Manual Transmission. Within couple months I started getting all of the symptoms of the clutch slipping. The condition is worse in a higher ...
5
votes
2answers
22k views

Clutch catches VERY high, is this bad?

I have a '98 Rodeo and the clutch catches extremely high up the pedal. It's probably 1-2" down (90% up in the travel). The clutch does not slip at all and the car runs great. Is this indicative of ...
3
votes
0answers
25 views

Clutch/transmission noise [duplicate]

I have a manual transmission in a Ford Ranger with 240,000 miles and it has recently started making an intermittent grinding/grating noise. The conditions under which I have heard it are: Clutch is ...
2
votes
1answer
49 views

Foot slipped off clutch while downshifting. Damage?

I have an '08 Honda Fit with a 5-speed manual transmission. I hit a steep hill earlier today and decided to downshift from 3rd to 2nd, so I didn't ride the brake for several miles. Before my RPMs ...
4
votes
2answers
40 views

To repair or not repair?

I drive a 2005 Honda Civic DX, 166k miles. My clutch was having problems over the past few weeks, it would shudder the entire car when i would let it out from 1st and 2nd gear. It has since stopped ...
1
vote
1answer
173 views

Scooter clutch plate gets damaged/burn't for a short time

I have an Indian Scooter (Bajaj Chetak) which was bought 15 years ago. For the last few days, the scooter has been witnessing lot of problems. 1. The clutch plate gets damaged and burn't - It ...
3
votes
1answer
72 views

Will a worn clutch ever completely fail to engage? If not, what will cause this?

I've noticed my clutch beginning to slip for maybe a month or two; it was slower to engage, but not badly enough to affect driving. Over the last week or so, it was getting significantly worse every ...
5
votes
1answer
1k views

Clutch less shifting - why does it work? Is it bad?

I have been driving stick for 15 years and within the last year I learned I can shift gear without the clutch. Normally the transmission will not let me shift gears without using the clutch. ...
3
votes
1answer
263 views

Replaced clutch on '84 Bronco 2, now clutch does not disengage

I replaced the clutch on an '84 Ford Bronco 2 (2.9L). After removing the transmission I found out that the throw-out bearing and slave cylinder were completely destroyed. I replaced both parts and ...
4
votes
2answers
347 views

1st gear hard to engage unless stopped, Subaru 2004 Impreza Outback Sport

Since I've bought my 2004 Impreza Outback Sport, I've had a problem with shifting into 1st gear. First gear is generally difficult to engage while moving. You can just force it, but it's really ...
4
votes
3answers
159 views

Did I damage my car by trying to move in reverse with the handbrake on?

I was in a hurry to leave for the office yesterday and forgot that my handbrake was engaged while starting. I started the engine, clutched, and reverse geared, and found the vehicle not moving ...
2
votes
4answers
24k views

difference between mechanical and hydraulic clutches

What are the differences between a mechanical clutch and a hydraulic clutch? Applications Performance/driving Reliability Maintenance/Repair
5
votes
2answers
13k views

Engine revs high 5th gear manual transmission

What might cause a car with a manual transmission that in 5th gear when given a punch of gas revs to very high rpms – with no power transferred to the wheels (i.e. the tachometer and speed go ...
1
vote
1answer
45 views

Clutchless manual transmission

I have an Isuzu truck which has just had the clutch replaced. It has a clutchless manual transmission which has not been working since the replacement of the clutch. There is a light in the dash ...
2
votes
1answer
184 views

How bad is it for transmission if you release clutch without gas in second gear?

For instance, if you stop at the red light and you release clutch while still in gear in manual transmission, the car would wobble and die. Of course you can start it up again, but what is the actual ...
1
vote
1answer
100 views

Toyota Tazz 1.3 clutch grunding

Yesterday was driving my 2003 Toyota Tazz, when I was changing to 3rd gear the clutch didn't come up. Stopped the car and tried to put it into 1st gear, but gear couldn't move. Switched it off and put ...
1
vote
1answer
127 views

Mazda 3 over-revs after releasing the clutch pedal on up-shifts, but mechanic says clutch is fine

I originally thought I wasn't getting the bite-point right on our new (2nd-hand 2005) Mazda 3, but after paying more attention it's clear that when up-shifting, the engine revs often blip up about ...
2
votes
1answer
859 views

Bike is sometimes not wanting to shift into neutral

I have a 1982 Suzuki SP250. The bike "doesn't want" to shift into neutral sometimes. I have to rock it back and forth and shift up and down the gears a for a while before it shifts. I have changed the ...
2
votes
1answer
47 views

Clutch or damaged 5th gear?

Just trying to figure out whether my car's issue is a worn out clutch or a damaged 5th gear. Going up through all the gears, there's no resistance, slipping, grinding or any other suspicious noise. ...
5
votes
6answers
8k views

How will I know clutch pads need replacing?

I have a manual shift honda civic. How would I or the motor mechanic know that the clutch pads need replacing? Would they check it during oil change? Certainly you don't open the transmission box to ...
4
votes
1answer
300 views

What would cause a clutch master cylinder to go bad?

I have a 1980 Honda Prelude and have only driven it a few hundred miles per year for the 10 years I've owned it. Redid the clutch when I got it, with new cylinders and everything. Last week I got in ...
3
votes
2answers
229 views

Difference between “dumping the clutch” and N->D in an auto?

What's the difference between dumping the clutch, and going from N->D at high RPMs with an automatic transmission? Will this cause any damage to the vehicle?
1
vote
2answers
1k views

Vaxhall Astra H clutch problem

A couple of months ago I noticed some problems starting with the clutch; the pedal became extremely spongy and the biting point was right down at the bottom, expecially on cold starts first thing in ...
1
vote
2answers
107 views

Suzuki Swift Sport 2012

My car (2yrs old) needs a new clutch after 45km and Suzuki won't cover it under waranty. I'm no mechanic but the car has not been driven hard and has mainly had longer highway journeys never. Is ...
2
votes
1answer
54 views

Rodeo clutch slips

I just bought a 98 rodeo 2wd v6. The clutch was fine on test drive and grabbed fine even though the pedal was adjusted to the top. When I was driving it home it started to slip. Is there a way to ...
1
vote
0answers
41 views

Clutch drops to the floor when I start to apply the brakes

Why does my clutch drop to the floor of my 93 ford escort as soon as I start to apply pressure on my brakes. I already changed out my master cylinder and bled the brakes. Could it have anything to do ...