General Motors brand of motor vehicle.

learn more… | top users | synonyms (1)

1
vote
1answer
32 views

2006 Chevy impla 3.5

The coolant is hot and bubbling. The car is not overheating. I changed the water pump, the thermo sensor, thermostat and intake gaskets. Not sure if it sealed completely. Wondering, is it the head ...
0
votes
1answer
45 views

Best way to add amp and sub to car [closed]

I just got my first car, a Chevy Cavalier 2000 base, and I would like to put in a new radio, a decent amp and sub to drive the speakers and sub. I am right now looking at this radio. I would like to ...
5
votes
1answer
123 views

Why is oil filling up in my air intake system?

The car that I am working on displayed below is a 2002 Chevrolet Cavalier 2.2 DOHC. I would like to admit that my knowledge of cars is little to none. I decided to start tinkering around with it ...
5
votes
2answers
51 views

1989 Chevy Scottsdale 2500 HD 5.7 liter 350

I have just finished a body off restoration of my 1989 Chevrolet Scottsdale 2500 HD. My question, is there an OBDI or OBDII or do I need a adapter to scan it? Even if I rebuilt the engine and ...
5
votes
1answer
62 views

No Acceleration, loss of power, backfiring, CEL, stalling

91 Caprice - l am having problems on acceleration, loss of power, backfiring, check engine light, stalling. Had to repair shop three times and they have not fixed it. Is there a scanner that can ...
7
votes
2answers
78 views

2000 Chevrolet Silverado brakes dragging, 4 new rotors, 4 sets of pads, new e-brake shoes, new front calipers

I recently replaced myself or had replaced all pads, all rotors, front calipers, rear guide pins and brackets, rear brake shoes, and rear e-brake hardware, as well as the e-brake cable on my 2000 ...
10
votes
1answer
66 views

What can be used to protect the under-carriage of a hot rod?

With a sand blasted cab and bed I am looking for a solution to protect the metal body of a C10 hot rod on air ride. I have looked into possibly rhino lining the under side of the bed and cab but I ...
4
votes
1answer
52 views

one wire alternator

I have a one wire alternator on 350 Chevy V8 in a 57 Belair. After charging the battery and running the car for about an hour the battery will run down. Changed the alternator but no difference. ...
5
votes
1answer
79 views

WOT uphill, no increase in RPM, consuming more gas?

I own a city car Chevrolet Spark 2016. When going up a steep hill say in 4th gear, having the throttle down at 60% or WOT is practically the same. There's a minimal increase in RPM and power. Will the ...
3
votes
1answer
60 views

how much coolant required in chevrolet spark

Which coolant I can use in my Chevrolet spark and how much coolant and water required
9
votes
2answers
360 views

Before changing a fuel filter is it ok to let the line run dry?

I didn't see this question asked after searching through the tag fuel-filter but I was curious is it ok or would it even work on a Silverado if you remove the fuse for the fuel pump when it is running ...
3
votes
0answers
21 views

Transmission slip

I have a 2011 Chevy Impala. Once in a while the engine will rev and then kick into first gear. If I slowly press down onto gas petal it will not do this. If I start slow no problems, but if I put foot ...
5
votes
1answer
115 views

AC Cooling stops at high speed

My car ac works very fine in normal conditions. But when I drive it for awhile longer, and often at high speed, it stops cooling. I can still hear the fan sound loud and clear but air flow decreases a ...
6
votes
1answer
62 views

How to Adjust Camber on a 1999 Chevy Suburban

I have a C1500 (2wd, 1/2 ton frame) 1999 Suburban with 4 in spindles installed, but now the camber is much to negative and it's going to cause wear on my tires, and I can't seem to adjust the camber ...
6
votes
3answers
377 views

Engine temperature range?

Our 'new' ('07) Cobalt has a digital temp readout. Temperature varies substantially, depending on driving conditions - I've seen it as high as 210(F) on city streets, on a not-very-warm day. Our old ...
5
votes
2answers
93 views

2012 chevy equinox blows hot air even shut off

We have a 2012 Chevrolet Equinox. We cant turn off the interior heat even when we turn the temp all the way down. Even when we turn off the heater it keeps blowing hot air. What could be the ...
2
votes
0answers
25 views

Chevy sonic 2014 [closed]

I have a Chevy sonic 2014, purchased from B M W about 2 months ago. My car smelled like it was getting warm. Opened the hood brown sludge. Mechanic says it isn't a head gasket and are unable to detect ...
4
votes
1answer
186 views

Replaced busted brake line but the brakes still don't work

I have a 2003 Chevrolet Avalanche with a broken brake line. We replaced the broken brake line, added new fluid and bled the brakes for about an hour and there still seems to be air in the lines or ...
9
votes
3answers
184 views

Should I replace piston rings on chevy 350?

I recently acquired a chevy 350 manufactured in 2015 for free because of some crank issues. I'm in the process of rebuilding it and have finished the disassembly of the engine. The engine itself only ...
3
votes
1answer
35 views

Unable to redirect airflow from floor to defroster, etc.in 2006 Cobalt

I replaced the heater / AC control module, but the airflow deflector still doesn't change. It is stuck on floor. It sounds like the module is trying to change, but nothing happens.
3
votes
2answers
80 views

fuel system problem

I have a 89 camaro I personally don't think it's a fuel pump issue and I recently changed the relay, but whenever I turn the key over sometimes I hear the fuel pump turn on sometimes I don't. Could it ...
3
votes
3answers
97 views

I have replaced my brake cylinders, but the brake pedal goes to the floor

I have a '07 Silverado. Both rear wheel brake cylinders blew apart. I fitted new ones along with new shoes. I have bled the brakes but my pedal still goes to floor. What else can I do?
7
votes
1answer
139 views

Brakes grinding when roads are snowy

I have a 2013 Chevy Cruise that has new brakes changed by the dealership, and they work perfectly in the rain, and dry conditions. But when there's snow on the ground, the brakes often start grinding, ...
5
votes
0answers
70 views

low beam headlight won't work unless highs on

I have a 1961 Apache. It has the 4 headlight system. The dash lights wouldn't work right unless I wiggled the switch. I install all new headlights and bulbs in the dash. Then I installed a new ...
5
votes
1answer
55 views

Car won't start

My Chevy Spark 1.2 L 2012 model overheated and blew the head gasket. I replaced the gasket and spark plugs. The engine is turning, but it won't start. Plugs do get petrol. Engine sounds like sewing ...
4
votes
1answer
79 views

What is SAE 0x15 Short Term Fuel Trim Bank 1 Sensor 2?

I was taking a look at a neighbor's car, and noticed this PID stuck at 99.22% This is in addition to the regular STFT PID 0x06 which is staying fairly close to zero most of the time. What is this ...
8
votes
0answers
105 views

Severe Noise Under Acceleration from a Stop or Slow Speed

EDIT March 9, 2016 So I took the car to a guy who specializes in ATX gears, and he felt that it's not a tranny problem. Got a second opinion from a Chevy tech who concurred. So due to that and the ...
4
votes
2answers
63 views

Car turning off everytime I idle

My car currently has multiple fault codes: P0031 - Heater control unit (HO2s) P0037 - Heater control unit P0403 - Exhaust gas recirculation P0342 - Camshaft sensor My mechanic says we will need ...
3
votes
2answers
48 views

my brake pedal is sticking in the depressed position in cold weather

I have a 95 Chevrolet K1500 pickup and I have recently had the brake booster replaced and it worked fine for the past year but now my pedal is sticking in the pressed position but only in colder ...
2
votes
1answer
66 views

How to actually measure a T-Top on an IROC-Z

When GM built the 3rd Gen Camaro, they installed T-Tops in some of them. Others they contracted out to another company to have them installed. The problem is, the T-Tops the contracted company ...
5
votes
4answers
901 views

Car overheats idling in traffic

I have a 2000 Chevrolet Impala. I recently had the water pump, timing belt, radiator, and thermostat replaced because I had a coolant leak/overheating problems. I now don't have a coolant leak, ...
4
votes
1answer
49 views

ENG PWR REDUCED 2009 Chevy Cobalt LS

I have a 2009 Chevy Cobalt bought used a year ago from a dealership near me. It has about 81,000 miles on it and just recently started messing up. My coolant temp will start heating up to about 200F-...
6
votes
2answers
225 views

My clutch won't engage all the way down

1990 Chevrolet 1500 Me and my neighbor just put a new clutch and a pressure plate in and about 2 weeks ago I put a bottom slave cylinder on it. I'm having trouble with my clutch engaging as well as ...
2
votes
0answers
18 views

I have oil in the coolant of my Suburban what is the cause? [duplicate]

I have a 2002 Chevrolet Suburban with a 350 engine it has oil in the coolant. What is the cause? It has over 200000 miles.
2
votes
1answer
45 views

Squealing noise and battery gage drops

I have a 1989 Chevy z71 pickup truck. The engine makes a squealing noise and I noticed the battery gage drops down as well. Replaced the idler pulley already. Battery is new also. The squealing ...
7
votes
2answers
72 views

Occasional ABS fault

'04 Cavalier, 120K mi. We've had it for 6 years, driven every winter. Now, this winter, we occasionally get an ABS fault. This probably always occurs under slipping conditions. When it happens, ...
6
votes
1answer
614 views

Ticking noise while idling that increases with acceleration

2013 Chevy Cruze. 86000 miles. Our car has been ticking while idling, and the noise gets louder and faster when accelerating. Oil has been changed regularly. Water pump was changed recently due to a ...
1
vote
1answer
33 views

Can't seem to start vehicle

I have a 2000 Chevy Cavalier and I can't seem to get it started. I have replaced spark plugs, wires, core pack, and battery. Once I get it started and then I drive it back home it decides not to start ...
6
votes
0answers
45 views

What are the brightest bulbs for projector headlamps? [duplicate]

I bought some projector headlights with Hi 55 watt bulbs in both the high and low beam modes. The low beam, which is the projector lens, isn't that bright. What other bulbs would be recommended for a ...
4
votes
1answer
31 views

reprogramming a key for 2006 chevy malibu

i changed the master key for my 2006 chevy malibu because the old key got lost. now i have lost the new key and found the old one. is there a way to reprogram the key to work again? Will the ...
1
vote
1answer
20 views

Remote will not always unlock car plus cannot insert key into ignition? [closed]

Remote will not always lock & unlock car doors + key will not turn in power ignition. I did have it changed twice plus replaced remote battery twice 06
9
votes
1answer
51 views

'04 Daewoo Nubira brakes keep sticking on after disc and pad replacement

On my '04 Daewoo Nubira I have been and had new discs and pads all round and now the brakes keep sticking on, I have been advised I now need new calipers all round, how can I tell if its them or that ...
8
votes
1answer
71 views

Need help installing engine with 2-wire crank sensor into 3-wire setup

My problem is the 2008 chevy trailblazer 4.2 has a 3-wire crank sensor and the reluctor ring on the crank looks similar to a bicycle sprocket. While I did not look at the reluctor ring on the 2005 4....
8
votes
1answer
55 views

Roller rockers to a stock valve train

78 Nova but the engine is from a different car; casting # V0707CMH. I have a 350 with 305 heads. Stock valves, pushrods, cam, and lifters. The nuts on my stock rocker arms are in need of replacement; ...
4
votes
1answer
36 views

1994 Silverado not accelerating past 35

I have a 1994 Chevy Silverado. On my way to work today my truck would not accelerate past 35 mph but was revving high rpm's. I stopped and checked my fluids and my ATF wasnt showing anything on the ...
2
votes
0answers
17 views

trouble codes on a 1993 chevy silverado

when I hook my scanner up to view the check engine codes it says I have no power to my scanner. I tested all circuits and my fuses are all good. what could be my problem?
4
votes
1answer
25 views

2003 Chevy Malibu Deluxe. Engine counter balancer timing

I replaced my timing belt. Now the engine vibrates horribly. I believe the cam timing is 100% but I believe I didn't time my counter balancer correctly. The Haynes manual photos and description ...
4
votes
0answers
30 views

Brake squeaks on 2013 Cruze

I was told that the brakes on the 2013 Chevy Cruze would squeak if the rotors had condensation etc. They had already resurfaced front rotors, adjusted and cleaned the rear pads and told me basically ...
6
votes
0answers
57 views

Th400 Transmission help

I pulled my Th400 out of my K20 Chevy and I'm in the middle of rebuilding it and I was resembling it and when I went to put the completed gear train assembly in it and the center support assembly gets ...
3
votes
1answer
634 views

Chevy Cobalt key stuck in ignition, battery dead

I've got Chevy Cobalt 2007 with key stuck in ignition and dead battery. The battery is located in the trunk. The trunk could be opened either using the button (oh no, cannot do that because the ...