1
vote
1answer
131 views

Reading CAN messages through UART to OBD-II Board and MATLAB Toolbox

I want to read/write CAN messages. I have MATLAB in my laptop which has a Vehicle Network Toolbox which supports reading/writing CAN messages. I have my hardware OBD-II to UART board, FTDI and OBD-ii ...
4
votes
1answer
56 views

OBD2 and CAN-bus

Do all vehicles with OBD2 have a CAN-bus? Otherwise, what are the alternative buses used? Are there special versions of the buses for trucks and school-buses than for cars/suv/vans?
1
vote
2answers
73 views

Writing CAN Messages

I want to know what should i write with the CAN ID to send it to ECU. I am using ELM327 and Raspberry Pi with all connections to OBD-ii. initially for sending general PIDs to the ECU through ELM327 ...
4
votes
4answers
385 views

Controlling door locks via CAN bus

I'm trying to figure out how to lock and unlock the doors of a 2010 Toyota RAV4 using the CAN bus via the OBD-II port. I have a microcontroller attached via an CAN controller and a CAN receiver, and ...
8
votes
1answer
586 views

How do I find the correct pins in a CAN-BUS connector?

This question might be too technical for this forum, but I'll give it a go. I have a 2012 BMW R1200R motorcycle with CAN-BUS. I'd like to make an Arduino interface to the connector on the bike, but I ...