Questions relating to any part of the vehicle braking system

learn more… | top users | synonyms

1
vote
3answers
31 views

Master cylinder leak

I'm working on a 63 Impala, and got a new master cylinder in. The 63 has a single brake line, but the new master has two ports. The manufacturer included a plug for the extra port if it's not needed, ...
-1
votes
0answers
15 views

Why won't the brakes pump up on a 99 F-150 [on hold]

Brakes on a Ford F-150 wont pump up after bleeding the them will pump up to while not running but when running it won't pump up?
6
votes
2answers
2k views

Is it normal for stop distance to be long on brand new brake pads?

I just had the brake pads replaced in my car. As I left the shop I noticed coming to a complete stop took longer distance or needed a fair bit more force on the pedal. Is this normal? Will the ...
4
votes
3answers
75 views

Parking brake suddenly slack but cable not broken

The handbrake on my VW Passat estate B5 has suddenly become slack. With the handbrake on, the faulty side wheel is free to turn by hand. Foot brake works as normal Lifting the centre console, I can ...
1
vote
2answers
22 views

Pontiac g6 runs lean; throwing codes

My 2006 g6 v6 3.5 is showing codes p0171, p0174, p0705 and u0073 171 and 174 show that the engine is running lean. Is this a serious issue? 0705 shows the trans range sensor a circuit 0073 says the ...
6
votes
3answers
128 views

Wheel change/balance leading to continuous braking

So I go to get my wheels changed and balanced and I leave with the driver side rim heating up unnaturally even after driving just a few miles. The car stops unusually quickly. It's quite clear that ...
9
votes
5answers
13k views

What causes brakes to pulsate right after rotor and pad replacement?

I have a 2002 Infiniti Q45. I replaced the front rotors and pads on Sunday. It was the first time I've done this on a car, though I have done it countless times on various motorcycles. I was careful ...
2
votes
1answer
435 views

Front right 'squeals' when turning

Hi I have an incredibly frustrating noise coming from the front right of the car. It only occured after replacing pads and rotors. It occurs when turning left (weight on right) and occasionally going ...
1
vote
2answers
29 views

Resurfacing brake rotators without replacing pads

I had my 300C Chrysler serviced for brake issue some time ago. They said that there was wear on both front and rear brakes. They changed the front pads, and said that there was pulsation when ...
1
vote
2answers
40 views

What is the cause of a soft brake pedal after bleeding?

I installed new rear calipers on both sides, new pads on all four wheels, and bled brakes with engine off, then with engine on, two times each. The pedal is hard when the engine is off and extremely ...
3
votes
2answers
25 views

Brake Pads worn in under two months

Vehicle: 2000 Chevy Blazer 4WD 4.3L V6 Engine Current Symptoms (I suspect this might be the symptoms of 2 over-lapping problems?) Brake light comes on. It then goes off if I press the brake to the ...
2
votes
1answer
24 views

Replaced rear rotors and pads, now both rotors hot on first test drive

Yesterday I replaced the rotors and pads on my 09 Mini Cooper. I thought it went well, but in the first short test drive, it feels like the emergency brake is set a bit. I drove a half mile, and both ...
1
vote
2answers
28 views
2
votes
1answer
21 views

Brake pedal is hard to push even after new brakes

The brake pedal in my 06 Pontiac g6 seems harder to push than normal. Since the issue started, I've had the rear rotors and pads replaced, along with a control arm. For the first 10-15 minutes of city ...
4
votes
3answers
2k views

Did slamming on my brakes really fix them?

I have a 2006 Mazda 3 that until yesterday, had soft/spongy brakes. A few days ago I brought it to my local repair shop to take care of the problem, and $300 later, I had new front pads and machined ...
2
votes
0answers
21 views

While driving, my handbrake gets automatically engaged (maybe)

I own a Hyundai Accent. I drove it for around 800kms yesterday. All was fine until I was close to my house. I heard a noise coming from the rear wheel as if the wheel was stuck. After a while, ...
5
votes
3answers
3k views

Brakes go to the floor

Vehicle: 2000 Blazer v6 4.3L Symptoms: Brake goes to the floor before braking. You have to push hard to stop. Easy to "skid" tires. Brake light is on. The day before they worked perfectly fine, and ...
3
votes
2answers
91 views

GSX-R front suspension technology timeline

I have noticed that people frequently choose the GSX-R front end for a front end conversion on old bikes to improve handling and comfort. The GSX-R was produced from 1985 through the present, and I'm ...
4
votes
2answers
148 views

Motorcycle - sudden brake failure - suddenly gone - is it safe?

Recently, my old Honda ST 1100's front brakes failed. It was very sudden; meaning one moment, they worked perfectly, the other, not anymore. There was no gradual decline; no warning, nothing. The ...
2
votes
1answer
314 views

Motorcycle: Irregular brake bite (front single disk)

My motorcycle's front brake is giving a irregular bite. I don't know how to express it in words please check the illustration below. --------$^^^^^^^^-^-^-^-^-^^--^^^---^^^^^^----^^^| ~60Kmph ...
4
votes
1answer
1k views

Reading ABS diagnostic codes on a Volvo 940

I want to read any fault codes stored in my 1992 Volvo 940's ABS module. I've tried the procedure described in the popular 700/900 series FAQ without success. That procedure involves plugging the ...
4
votes
7answers
5k views

Why are drum brakes still fitted on Ford's cars?

Currently I own a Mk5 Astra SRi, however I am looking to sell this and buy a Ford Focus Mk2. The other day I looked at a Ford Focus Zetec Mk2. My understanding is that Zetec is sort of the ford ...
1
vote
3answers
84 views

Does downshifting ( Engine Braking ) help when my car brakes CAN lock the wheel?

Know facts: When your car brakes (e.g. because of the weight) can't stop the car, it's recommended to use downshift (engine braking) to help brake the car. The best way to stop the car is to brake ...
4
votes
1answer
71 views

Brakes smell, car pedal hard, light smoke, slows down during gear shift

3 weeks ago I bought a car from a private dealer. When I tested it out, the car was completely fine. Not to long ago after, I noticed that my back tail lights were on and figured out it was the braker ...
2
votes
1answer
37 views

Brakes pads changes and cutting rotors

My brakes started vibrating occasionally when slowing down on highways at high speeds. I have been realizing that the brakes feel low. I went to a shop for an oil change and the mechanic peeked in ...
1
vote
1answer
46 views

Does the brake pad need to fit perfectly into caliper?

I just did my first brake job. The brake pads I put into the caliper were significantly smaller than the old ones. The old ones needed to be hammered out of the caliper because they were tightly ...
2
votes
0answers
30 views

2001 Ford F150 howling when braking with trailer

I have a 2001 Ford F150 Lariat with the 4.6L V8 Engine. Sometimes while I have my trailer hooked up I get a tremendous howling while braking. Almost so loud you can't hear anything else in the cab. ...
4
votes
2answers
73 views

Modest braking sounds similar to squealing tires

When I'm braking at a stop sign, I'm hearing a sound that sounds like a high pitched tire squeal; it's like a mix between tire squeal and the constant chirp from a bad belt, and it's coming from the ...
2
votes
1answer
75 views

Brakes slide when pressing on them

I own a 2001 Hyundai Sonata, and when I go press on my brakes, the car will slow down, but when I press down on them hard (for an immediate stop) they slide for some reason. Is this common? I've put ...
1
vote
1answer
35 views

Do I need to service rear Drum Brakes?

Car: 2006 Mitsubishi Lancer ES 2.0L SOHC Automatic I recently rotated my wheels and noticed that the rear wheels make a slight grinding noise. After some research on the internet, I think the issue ...
0
votes
0answers
25 views

Why does the brake on a 2000 Sienna click and squeak?

When I depress the brake pedal on a 2000 Toyota Sienna, every time the pedal reaches near the halfway mark, there is a discernible click. As the vehicle approaches a stop and I feather the brakes, ...
4
votes
4answers
8k views

At what point do you need to replace the calipers?

I bought my car in February 2013 with 49K miles. It now has 61K miles on it and my brakes are starting to squeak very gently, until I apply more pressure on the brake pedal. When I bought the car, I ...
2
votes
2answers
167 views

Rear drum brakes will not release

I have a 2010 GMC Canyon. When you first start up and put the vehicle in gear the breaks will not release.if you accelerate then it will pop and release. This will happen the first two or three times ...
3
votes
0answers
129 views

Front wheel scraping noise

I have some weird scraping/rubbing noise in my right front wheel. I I hear it regardless of weather i brake or not, and the slower i go the more low pitched and grindy it sounds. It continues to ...
1
vote
0answers
15 views

Should rotors be replaced every time brake pads/discs are? [duplicate]

Someone told me once that new brake pads/discs last much less if they are installed on old rotors, i.e. that an old rotor will wear a new brake refill much faster than a brand new one because of the ...
-1
votes
1answer
24 views

popping noise on 07 charger

So my car a while now has been making a popping noise and it's gotten worse. Everytime I step on the brake something from the bottom of my car pops most of the time when I turn the steering wheel it ...
-1
votes
2answers
25 views

Steering wheel vibration

While driving my 2012 camaro at freeway speeds, the steering wheel vibrates violently. However, it will continue to vibrate intermittently even after braking every few seconds.
1
vote
2answers
40 views

why are new brakes squeaking?

I had my brakes completely redone for my annual test and now they squeak whenever I use them. It's really a bit annoying and I was wondering why they do that if there's anything I can do about it.
3
votes
0answers
19 views

Trying to order a part, shows up brake knuckle spindle assembly, but all are used for 98 civic?

I'm trying to order the hub assembly and brake knuckle spindle assembly for a 98 Honda Civic so that I don't have to do any press work with the bearings. On other vehicles the parts can be bought new ...
1
vote
2answers
10k views

Brake pedal will not return after being depressed: brake booster diagnosis?

After being on holiday for a few weeks, I come home and find that the car brake pedal on my (automatic tranmission with ABS brakes) car will no longer spring back up after depressing it. After doing ...
1
vote
1answer
226 views

How do 99 chevy tracker rear brakes self adjust?

I adjusted the brake shoes a bit after I installed them, but do they now adjust on their own as they are used, or how do I get them to adjust?
3
votes
2answers
37 views

Should I replace the disc?

Recently, my car began to make very loud noises whenever I used the brakes. At first, I didn't suspect the brake pads because I thought they were still able to undergo a few thousand kilometre. To be ...
4
votes
0answers
28 views

Strange electrical issue with after market brake lights

I've got a 1991 Jeep Wrangler. About 3 years ago I put LED brake lights on. They worked great until just a couple days ago, when the drivers side stopped working. Shortly after, they started working ...
2
votes
1answer
32 views

custom built silicon carbide discs

My toyota corolla CE110 brake performance is not to the expectation, it takes an unusual amount of distance and requires comparatively hard braking to get it to stop. I had checked it by a mechanic ...
2
votes
1answer
19 views

Clicking of Brakes

My vehicle was recently in a accident involving a raccon (go figure) and did a lot of damage. I already had it checked out and they said it needed alot body work and possible wheel alignment. However ...
2
votes
4answers
127 views

back brakes smoke

Just had back brakes and rotors replaced a week ago, came home from church yesterday and there was this horrible smell and smoke coming from passenger side back brake area what could me the cause for ...
4
votes
3answers
15k views

Changed my brake pads but brakes started smoking due to a stuck caliper (99 Honda Accord)

Long story short, I was doing a simple DIY brake pad change and it seems that the brake caliper got stuck (the the brake line seem to be slightly twisted). I went for a test drive in the neighbor and ...
2
votes
0answers
35 views

Continual Brake Issues on a 2002 Kia Spectra

I have a 2002 Kia Spectra. We have replaced the rotors 3 times, but prior to doing that we were having problems with our back brakes. The mechanic we were going to said nothing was wrong with the back ...
3
votes
1answer
27 views

Brake fluid to be used on a 1960 Chevrolet Corvair

I have a 60 Corvair and have never changed the Brake Fluid. I am planning to flush out the old fluid and replace it. What brake fluid should I replace it with. Dot 2,3,or 4
2
votes
0answers
21 views

Tire pressure sensor doesn't read

I work on several makes and models, and found that after replacing brake pads that the "low tire pressure" warning comes on as a sensor fault. Is there something I'm hitting that causes this? How can ...