Brake systems on vehicles are typically driven by either pneumatic or hydraulic systems that multiply the force applied by an operator to slow a vehicles rate of speed through the use of friction.

learn more… | top users | synonyms

3
votes
1answer
20 views

2000 mazda 626 v6

My Mazda shuts off when I apply the brakes. Can anyone help me with this problem. It idles just fine but when I apply the brake to put it in reverse it bogs down and completely shuts off. What could ...
5
votes
2answers
105 views

How brake vacuum booster works?

If the brake vacuum booster makes vacuum on one side and the other is with normal atmospheric pressure, why doesn't it get sucked by itself towards the vacuum side? If the vacuum isn't enough to pull ...
3
votes
1answer
182 views

Noise and vibration when car is moving

My 2007 Toyota Corolla has been having an odd issue. When the car is moving, even slowly, I hear something that sounds like rubbing, and as I go faster, there is a vibration that starts as though a ...
2
votes
1answer
534 views

How to test and repair brake imbalance?

My 2000 Honda Civic Aerodeck just failed its MOT (roadworthyness test) on Front Brake Imbalance (51%). I changed the pads a few months ago, and had trouble with both calipers on the driver's side of ...
2
votes
2answers
1k views

2012 Ford Escape grinding noise while braking

My Ford Escape started making an unusual noise recently. Would appreciate if anyone can help me diagnose the problem. The noise only occurs when I brake and only when my speed gets down to about 15 ...
4
votes
1answer
26k views

Front Wheel Squeal When Driving After New Brakes

We have a 2006 Buick Lacrosse. We just installed new front brakes. 2yr rotors and lifetime performance ceramic pads. We have used these pads in the past on the car and never experience this issue. We ...
2
votes
3answers
759 views

Pontiac g6 runs lean; throwing codes

My 2006 g6 v6 3.5 is showing codes p0171, p0174, p0705 and u0073 171 and 174 show that the engine is running lean. Is this a serious issue? 0705 shows the trans range sensor a circuit 0073 says the ...
2
votes
1answer
72 views

Would waiting a few weeks to replace pads and rotors have damaged calipers?

I took my Volvo s60 for regular 84k maintenance a few weeks ago and I requested to get my brakes and rotors checked. I was told that they needed to be replaced. I booked an appointment for three ...
1
vote
1answer
33 views

what vehicle disk brake diameter 220 mm tickness 10 mm

I have a caravan with unknown disk brakes. The disk is 220 mm in diameter and 10 mm tick. What vehicle are these from?
0
votes
3answers
77 views

Do I have battery or engine problems?

Yesterday, I used my car to drive literally 2mins. Away from my dorm building to get to my class building and back because of bad weather. 30+mins. Later I come back outside and use my remote to ...
1
vote
1answer
329 views

Toyota Camry 2000: Odd Coughing when starts

Recently, I notice that my car begins coughing couple minutes after it starts. It have happened since Jan, 2012. First, I thought it might be due to Winter since it is cold weather. However, it ...
12
votes
3answers
5k views

Change calipers on both sides?

Four months ago, I had a seized brake in the front left. The slide bearing was stuck and the outer pad was worn more than the inner (at the piston). I wasn't able to move the journals of the bearing ...
1
vote
0answers
18 views

Recommended rotor disc combination for Ranger truck. Normal usage [closed]

Any recommendations for brake rotor and brake pad combination for good stopping power. My rotors warped after 185,000 miles. I am easy on my brakes; first set of pads lasted 150,000 miles. This is for ...
18
votes
9answers
190k views

When do brake rotors really need to be replaced?

I need to replace my rear brake pads. A mechanic suggested I also replace my rotors because they are rusted around the edges. The rotors are in fact quite rusted, however, there is no rust on the ...
1
vote
1answer
73 views

caliper leaking…

I drive a 2008 Ford Taurus X. In June, I had the rear rotors and pads replaced. They also had to replace the right rear caliper. Last week (less than 2,000 miles later) the left rear caliper started ...
2
votes
1answer
372 views

What is brake imbalance? How can I fix it?

My 2000 Opel Agila 1.2 has an advisory on it's MOT saying: Front Brake imbalance [sic] high at 23% What does this mean? What's wrong with my brakes? What does the 29% mean? How can I fix it? ...
2
votes
1answer
52 views

2001 Ford F150 howling when braking with trailer

I have a 2001 Ford F150 Lariat with the 4.6L V8 Engine. Sometimes while I have my trailer hooked up I get a tremendous howling while braking. Almost so loud you can't hear anything else in the cab. ...
3
votes
3answers
247 views

What are the different types of disc brakes

I have head of Ventilated Disc,Carbon Ceramic disc. I do not know what are the different types of disc brakes available on the market. Which one should I choose. I would also like to know the ...
0
votes
1answer
127 views

Brakes sticking in front [2010 Chrysler Town & Country]

I changed the front brakes & rotors on my 2010 Chrysler Town and Country. Now the front brakes will not release after driving it for awhile. They both heat up and sound like they are grinding ...
3
votes
1answer
85 views

Tire pressure sensor doesn't read

I work on several makes and models, and found that after replacing brake pads that the "low tire pressure" warning comes on as a sensor fault. Is there something I'm hitting that causes this? How can ...
7
votes
3answers
318 views

Wheel change/balance leading to continuous braking

So I go to get my wheels changed and balanced and I leave with the driver side rim heating up unnaturally even after driving just a few miles. The car stops unusually quickly. It's quite clear that ...
2
votes
3answers
185 views

Vehicle squeaking 3-4 times when beginning to drive. Stops after getting some speed

Recently I've noticed that my 2012 Nissan Frontier (Automatic Transmission) is squeaking when I start driving from a complete stop. It will only squeak 3-4 times and will go away once I've gained some ...
2
votes
2answers
2k views

Pressing on gas and brake at the same time by mistake - How harmful is it to the gearbox?

I usually brake with my left foot when driving a car with automatic transmission. I find it easy to switch between right-foot and left-foot braking if needed (for example, if I need to drive a car ...
7
votes
3answers
36k views

Brakes go to the floor

Vehicle: 2000 Blazer v6 4.3L Symptoms: Brake goes to the floor before braking. You have to push hard to stop. Easy to "skid" tires. Brake light is on. The day before they worked perfectly fine, and ...
2
votes
0answers
64 views

brake pedal staying down. Then ok after a few days being stood

I have a Mercedes C200 and the other day the brake pedal stayed down while I was driving. It did come back up a little as I carried on home. I haven't driven the car for a day or so. then this morning ...
3
votes
1answer
119 views

Brake fluid gone, rear brakes out. '99 pathfinder

The other day I started my car and the e-brake light stayed on after releasing it and I figured it was electrical at first. When I started using the brakes I realized I had to push about twice as far ...
2
votes
3answers
971 views

What is the cause of a soft brake pedal after bleeding?

I installed new rear calipers on both sides, new pads on all four wheels, and bled brakes with engine off, then with engine on, two times each. The pedal is hard when the engine is off and extremely ...
4
votes
4answers
3k views

1972 Toyota Land Cruiser FJ40 Disc Brake Conversion

I just bought a '72 FJ40 and realized that three out the four (drum) brake cylinder's are seized and one of the grease seals is leaking bad. Since I have to replace the brake cylinder's, I am ...
5
votes
1answer
1k views

Reading ABS diagnostic codes on a Volvo 940

I want to read any fault codes stored in my 1992 Volvo 940's ABS module. I've tried the procedure described in the popular 700/900 series FAQ without success. That procedure involves plugging the ...
2
votes
1answer
49 views

Brakes smoke on driver side, but only after non-level terrain

I recently had my brakes serviced. Pads and rotors were replaced. Everything seemed fine. Today, I took a 30 minute drive where I applied the brakes significantly on the way back due to hilly terrain, ...
-1
votes
3answers
115 views

Steering wheel vibration

While driving my 2012 camaro at freeway speeds, the steering wheel vibrates violently. However, it will continue to vibrate intermittently even after braking every few seconds.
1
vote
2answers
564 views

Low rumble/groaning noise when come to a slow stop

I just replaced my front brake pads and rotors about 2 months ago and am now hearing a very noticeable noise when braking. I'm driving a 2010 Honda Civic LX-S with about 67K miles. The odd thing is ...
1
vote
1answer
130 views

Brakes lock up when you put the vehicle in reverse

My 2002 Kia Sportage's brakes are locking up when you put the vehicle in reverse. When you put it in drive or neutral the brakes release. When they lockup, it sounds like air pressure and the pedal ...
2
votes
1answer
63 views

Aveo 2012 brakes do not work when the engine is running

I have this problem when you depress the brake pedal it moves all the way to the floor and does not slow the car down. It's happen only when the engine is started. Please any fix or help. I really ...
4
votes
0answers
212 views

Long brake pedal travel after replacing pads

I recently installed new brake pads. They haven't been bedded in yet and I don't intend to use them for daily driving. The pressure feedback from my brake pedal progressively increases as I apply ...
2
votes
3answers
6k views

Steering wheel shakes when braking at high speeds

I got a 2011 lexus ES350, the steering wheel shakes badly when i push the brake. I have been told that its the rotors. I got the rotors resurfaced last week at the lexus service center but no ...
5
votes
2answers
2k views

New Pads, Rotor, & Caliper; Grinding, Squeaking, and Heat

I just replaced my rear-passenger side Caliper, Caliper Bracket, Rotor, and Brake-pads due to the rotor, pads, and caliper bracket grinding together. Vehicle: 2000 Blazer 4WD, recently had front ...
2
votes
3answers
398 views

New brakes squealing?

I just had all my brakes, calipers, and something else related to that replaced. Brand new. And they're working perfectly. So why are they squealing whenever I touch the brake pedal?
3
votes
2answers
431 views

Why is martensitic steel used instead of grey cast iron for ATV disc brakes?

Grey cast iron has better thermal properties -- conductivity and specific heat -- lower density, better castability, and better friction than martensitic stainless steel. Why are OEM parts made of ...
2
votes
1answer
93 views

What are the effects of not having ABS?

I recently realised that my car does not have ABS. Would my stopping distances increase? Does it make a lot of difference in good conditions (e.g dry, smooth roads)? Would it make any difference in ...
0
votes
0answers
14 views

brakes still pulsating [duplicate]

replaced rotors and pads(rotors twice)and still pulsating. Are the calipers the only thing left that could cause the pulsating? I checked the slides on the calipers the were ok( not stuck or frozen). ...
0
votes
1answer
117 views

The brakes on my vehicle continue to pulsate, even with new rotors and pads

I've replaced the rotors and the brake pads so far, but the brakes continue to pulsate whenever they are applied. The slides on the caliper are not stuck or frozen, but I think they may be the ...
1
vote
1answer
140 views

steering wheel shakes in a turn

I drive a 2011 Ford F150. After new tires, new brakes and rotors and a wheel balance, the truck rides fine at all speeds and braking is good. However, when I enter into an exit ramp and brake while ...
1
vote
1answer
2k views

Squealing noise when reversing and turning, from RHS of car

I drive a 2010 Civic with about 80k kilometers on it and it makes a screeching or squealing noise when I drive. I've checked other relevant posts + googling, and I suspect brakes, not the fan belt ...
5
votes
3answers
404 views

Is my Forester's caliper bracket bolt hole stripped?

While replacing my calipers and their mounting brackets, I passed a tap through the bolt holes on the wheel hub assembly that secure the bracket, to clean up the threads. The tap's movement felt ...
4
votes
1answer
63 views

Strange electrical issue with after market brake lights

I've got a 1991 Jeep Wrangler. About 3 years ago I put LED brake lights on. They worked great until just a couple days ago, when the drivers side stopped working. Shortly after, they started working ...
8
votes
1answer
14k views

Is it normal for stop distance to be long on brand new brake pads?

I just had the brake pads replaced in my car. As I left the shop I noticed coming to a complete stop took longer distance or needed a fair bit more force on the pedal. Is this normal? Will the ...
1
vote
2answers
103 views

Resurfacing brake rotators without replacing pads

I had my 300C Chrysler serviced for brake issue some time ago. They said that there was wear on both front and rear brakes. They changed the front pads, and said that there was pulsation when ...
4
votes
2answers
940 views

Brake Pads worn in under two months

Vehicle: 2000 Chevy Blazer 4WD 4.3L V6 Engine Current Symptoms (I suspect this might be the symptoms of 2 over-lapping problems?) Brake light comes on. It then goes off if I press the brake to the ...
4
votes
1answer
465 views

Replaced rear rotors and pads, now both rotors hot on first test drive

Yesterday I replaced the rotors and pads on my 09 Mini Cooper. I thought it went well, but in the first short test drive, it feels like the emergency brake is set a bit. I drove a half mile, and both ...