Questions relating to any part of the vehicle braking system

learn more… | top users | synonyms

3
votes
2answers
4k views

Should I get my brake rotors turned without replacing the recently-replaced brake pads?

Earlier this year, I noticed my brakes starting to screech (especially in the morning or when it was cold out). Not the distinctive squeal of finished brake pads, but the more "grinding" screech of ...
1
vote
3answers
4k views

Steering wheel shakes when braking at high speeds

I got a 2011 lexus ES350, the steering wheel shakes badly when i push the brake. I have been told that its the rotors. I got the rotors resurfaced last week at the lexus service center but no ...
2
votes
2answers
2k views

Weak front brake on dirt bike

After changing the air tube in my front tire and reinstalling the wheel on my Suzuki RMZ450, I noticed that the front brake lost a lot of stopping power. What caused this and what do I need to fix to ...
1
vote
1answer
49 views

Converting to a dual master cylinder?

1965 Chevy C-10. Manual brakes. Disk brakes on front - drum in rear. Single brake fluid cylinder. I think it would be safer to convert the single cylinder to a dual. Question: Is it necessary to ...
2
votes
1answer
122 views

1940 Buick Super brake master cylinder removal

I have a 1940 Buick Super. I need to remove the master cylinder to rebuild it, but the bolts turn in the frame when I try to remove the nuts. There is some kind of metal cover over the end of the ...
4
votes
2answers
635 views

Intermittently sticky caliper

This is a front caliper on a 03 Mazda protege. The right brake overheated the other day. I tore it apart and one of the caliper bolts was pretty rusted. I got a new bolt, pads and greased the ...
4
votes
2answers
334 views

Honda Civic braking problems in warm climate

I have a 1991 Honda Civic wagon that loses braking power on hot days. I have it working for the initial press, but as I hold down the brakes I slowly lose braking. I have to repeatedly press at red ...
2
votes
2answers
8k views

Sqealing noise from left rear wheel- very hot

I have a 2007 Mazda 6, and after cruising for a while on the highway, I started to hear a very loud squealing noise coming from the rear wheel on the drivers side. It's an extremely high pitched and ...
3
votes
2answers
1k views

What brake components need to be lubricated?

When doing a DIY brake job, I understand that it's necessary lubricate several components of the pad/caliper assembly. From various sources, I have been told that the following are the places where ...
5
votes
2answers
419 views

How can I verify my brakes are decent when I can't trust the mechanic who worked on them?

I took my car to my local chain repair shop last Saturday because the parking brake was nonfunctional -- the lever, when pressed, had no resistance, and was clearly not hooked up to anything. They ...
2
votes
1answer
394 views

Motorcycle: Irregular brake bite (front single disk)

My motorcycle's front brake is giving a irregular bite. I don't know how to express it in words please check the illustration below. --------$^^^^^^^^-^-^-^-^-^^--^^^---^^^^^^----^^^| ~60Kmph ...
4
votes
7answers
7k views

Why are drum brakes still fitted on Ford's cars?

Currently I own a Mk5 Astra SRi, however I am looking to sell this and buy a Ford Focus Mk2. The other day I looked at a Ford Focus Zetec Mk2. My understanding is that Zetec is sort of the ford ...
2
votes
4answers
12k views

Replaced brake pads - one pad was full, the other was gone. Brakes now very hot after driving

The content is pretty much contained in the title. When I went to replace the brake pads, one pad was completely gone and the other was almost like new. Now that I have replaced the pads, the wheel ...
12
votes
10answers
128k views

When do brake rotors really need to be replaced?

I need to replace my rear brake pads. A mechanic suggested I also replace my rotors because they are rusted around the edges. The rotors are in fact quite rusted, however, there is no rust on the ...
1
vote
1answer
1k views

Chevy Cruze with a funny sound when applying the brakes. The drums, pads and shoes among other things were replaced

When applying the brakes on my 2013 Chevrolet Cruze, a loud funny noise happens. I'm frustrated that this is my first vehicle I have purchased on my own and all I can think is it's just my luck. I ...
1
vote
1answer
273 views

Is brake working with clutch in ford econovan 1989?

Lately I have started losing my brakes in that they won't ease on, the pedal goes almost all the way to the floor then at the last little bit the brakes engage fully and pretty much make the tires ...
3
votes
2answers
512 views

Front, driver-side wheel sounds like it's skidding when braking

I have a Nissan Micra (UK, 51-plate, 2001 model) and I've today noticed a sound a bit like skidding when I apply the brakes, gently, around 30mph. Driving and steering as usual is fine, no unusual ...
6
votes
11answers
32k views

Use of Neutral Gear in Automatic Transmission

I am new to driving A/T cars and I am trying to understand the use of Neutral(N) gear. Should I shift my gear from D to N when my car comes to a complete halt on a red light or somewhere else? As per ...
3
votes
2answers
570 views

What could cause a metal-on-metal noise when braking only while backing?

I have a 1998 Acura Integra with 204k miles on it. Some mornings after the car has been parked in my driveway facing up a slight slope overnight with the handbrake set, the first time I apply the ...
6
votes
1answer
279 views

What are the brake specs on a 2008 VW GTI?

I have a fairly new to me 2008 VW GTI (US model, aka "Golf GTI" in other parts of the planet) and am trying to figure out the specs for the brakes. Specifically, I'm trying to determine the exact size ...
6
votes
1answer
6k views

Why would my electrical systems cut out when I brake?

So I told this little story to the dealership service department, and they were baffled. Never heard of anything like it in ten years, said they'd have to examine it very closely. Here's what ...
1
vote
1answer
295 views

'00 Civic Brake Imbalance

My 2000 Honda Civic Aerodeck just failed its MOT (roadworthyness test) on Front Brake Imbalance (51%). I changed the pads a few months ago, and had trouble with both calipers on the driver's side of ...
0
votes
1answer
438 views

Using clutch and motor brake - good or bad? [duplicate]

Possible Duplicate: Does Downshifting (Engine Braking) Cause Extra Wear and Tear? Edit: As mentioned in the comments: Duplicate of Does Downshifting (Engine Braking) Cause Extra Wear and ...
3
votes
2answers
4k views

Do I really need a lathe to turn my rotors?

Last time I changed my brake pads (Toyota Tacoma v6 4WD), I did not get my rotors turned and was told I should have taken them to a mechanic to get it done. I was wondering if there is any ...
3
votes
1answer
188 views

Brake lights on '94 Honda Prelude stuck on

All 3 brake lights on my Prelude seem to be permanently stuck on. This occurs all of the time - the lights stay on even if there is no key in the ignition. I've had to disconnect the battery. Would ...
3
votes
2answers
622 views

Can chafing brake pads damage rotors?

Since replacing all of the brake pads and passenger front rotor on my 2008 Chrysler Sebring convertible, the pads have been chafing and making a non-stop chirping sound while driving. There is a ...
4
votes
2answers
4k views

Honda Accord bubbling / gurgling sound when braking first few times

I have a 2009 Honda Accord. All 4 brakes were recently serviced so I don't think this is related to pads or rotors needing attention. When I first start driving, when I hit the brakes, there is a ...
4
votes
2answers
918 views

Can I put the tires in the opposite direction on the rear-end on my front wheel drive configuration?

When using a front wheel drive car, the rear end is only used for braking. Is it a good idea (and if not, why) to "reverse" the tires so the tire threads are useful when braking? I know it might ...
5
votes
1answer
825 views

Brakes gripping and causing skidding

I'm experiencing a problem with the brakes on my 1994 Jeep Grand Cherokee. I replaced almost every component of them over the course of the 2 years. Most of the replacements occurred in April 2012, ...
8
votes
3answers
34k views

I forgot to release the hand brake while I'm driving at around 4 to 5 km. what will happen to my rear brakes?

I forgot to release the hand brake while I'm driving at around 4 to 5km. What will happen to my rear brakes?
0
votes
1answer
115 views

“Flight recorder” for automobiles? [closed]

As I sat in traffic court last week for a non-moving violation, many of the cases were clearly he said/she said issues.. particularly with stop sign violations. I can easily see how this specific ...
5
votes
1answer
677 views

Replace stop light switch cushion - 2003 Toyota Camry Altise

So my brake lights are always on and it is the stop light cushion. I have purchased a new one from the dealer and now need to replace. I have tried pointy nose pliers and they are just not working. I ...
6
votes
2answers
2k views

Is it possible to lock wheels when ABS is working?

I have a Nissan Primera P12, which got ABS. When I normally brake, wheels don't lock and car comes to a stop as expected with any ABS system. Although if I'm travelling a bit fast and hit the brake ...
2
votes
3answers
9k views

Squeaking brakes on motorcycle - an issue or not?

The front disc on my motorcycle emits a low pitch squeaking noise when I'm pulling up to a complete stop (almost like the sound train brakes make when pulling up to a station). This only happens when ...
2
votes
2answers
1k views

Simple Question: Do I need to bleed brakes if I removed the blake fluid cap?

This is probably a very simple question, but I was just poking around the engine bay and checking the fluid levels of the various reservoirs. I then opened the brake fluid one and I remember reading ...
2
votes
2answers
11k views

Bleeding Brakes with Car on or off?

There's a pump that runs when the car is on to pressurize the hydraulics, right? When bleeding the brakes, should the car be on or off so this pump is on or off? I'm specifically talking about a ...
6
votes
2answers
37k views

Brakes Smell Bad and Smoke

Here's the situation: Initially Changed a wheel/tire, and snapped a hub stud. Had to take off the brake caliper on that hub (driver's side). No problem with that, but then all of a sudden my front ...
5
votes
2answers
7k views

Why does my engine perform poorly and get bad gas mileage after using fuel injector cleaner?

At the advice of someone at a local auto parts shop, I poured a bottle of fuel injector cleaner into my gas tank. This happened around the same time that I had a brake job done and rotated my tires. ...
4
votes
4answers
2k views

1972 Toyota Land Cruiser FJ40 Disc Brake Conversion

I just bought a '72 FJ40 and realized that three out the four (drum) brake cylinder's are seized and one of the grease seals is leaking bad. Since I have to replace the brake cylinder's, I am ...
1
vote
1answer
579 views

Audi A3 Brake warning after MOT

just dropping in to show my support for this forum and to ask a quick question! Had my '06 Audi A3 2.0 TDI Quattro Sport serviced and MOT'd yesterday. Knew my front pads were very worn (tried to ...
4
votes
2answers
1k views

Will brake dust corrode my wheels?

I've had my car for 1 month and 2,000 miles now and my wheels, which were once very shiny chrome, now look like I painted them gray because the brake dust is so bad. First of all, is brake dust ...
3
votes
2answers
605 views

Brake Pedal Requires More Distance to Push

My brake pedal requires a further distance to push than it used to. This is not to say it's harder to actually apply the brake; it's just that when I apply the brake, the pedal goes further back than ...
1
vote
2answers
1k views

How do I know if I need new brakes?

I recently purchased a car with 135k miles on it and I have no idea when the brakes were last replaced. I've done work on my cars before but never have changed the brakes, so I'm not sure how to tell ...
1
vote
1answer
718 views

What can cause a stiff brake pedal that softens when stopped?

I have a 2002 Toyota Avalon. Overall the car is in excellent shape, no major issues. Recently, I have noticed the brake pedal requiring increasing pressure, but only when moving (which is obviously ...
1
vote
2answers
13k views

Brake pedal will not return after being depressed: brake booster diagnosis?

After being on holiday for a few weeks, I come home and find that the car brake pedal on my (automatic tranmission with ABS brakes) car will no longer spring back up after depressing it. After doing ...
1
vote
3answers
348 views

New brakes squealing?

I just had all my brakes, calipers, and something else related to that replaced. Brand new. And they're working perfectly. So why are they squealing whenever I touch the brake pedal?
3
votes
2answers
1k views

C-clamp stuck in brake caliper

I'm a first timer replacing (front) brake pads in my Nissan Pulsar 1.8 (hatch). I had problems removing the caliper bolts on both sides - after successfully removing them, I removed the old pads and ...
1
vote
1answer
253 views

Toyota Camry 2000: Odd Coughing when starts

Recently, I notice that my car begins coughing couple minutes after it starts. It have happened since Jan, 2012. First, I thought it might be due to Winter since it is cold weather. However, it ...
3
votes
2answers
138 views

2005 Infiniti G35x - squeaky brakes only when backing up slowly

Don't squeak when braking forwards, or braking hard/fast backing up. Only when backing up and lightly pressing on them. Extended squeal, and very loud. Anything I can do?
0
votes
1answer
109 views

part of rear brakes for 2000 tracker

My 2000 trackers rear brake cylinder blew. The mechanic also said among the parts needed was something I can't remember the name of. It was bent and therefore comprimised. He said it is not easy to ...