Brake systems on vehicles are typically driven by either pneumatic or hydraulic systems that multiply the force applied by an operator to slow a vehicles rate of speed through the use of friction.

learn more… | top users | synonyms

2
votes
0answers
9 views

2000 Chevrolet Silverado brakes dragging, 4 new rotors, 4 sets of pads, new e-brake shoes, new front calipers

I recently replaced myself or had replaced all pads, all rotors, front calipers, rear guide pins and brackets, rear brake shoes, and rear e-brake hardware, as well as the e-brake cable on my 2000 ...
7
votes
6answers
38k views

At what point do you need to replace the calipers?

I bought my car in February 2013 with 49K miles. It now has 61K miles on it and my brakes are starting to squeak very gently, until I apply more pressure on the brake pedal. When I bought the car, I ...
12
votes
0answers
56 views

Revving and rattling sometimes when braking

My Tacoma has been making a strange revving and rattling sound when the truck is in motion and the brake or the clutch is pressed and the gas pedal is released. I couldn't reproduce the effect when ...
13
votes
6answers
59k views

Clicking type sound when braking at low speeds

Most of the time when I brake at low speeds I hear a clicking type sound, that is fairly faint. I do NOT hear squeaking, grinding or any high pitched noises that might indicate my brake pads are ...
3
votes
0answers
26 views

Slow speed crunch/pop sound?

Having this issue that started recently. Hearing and feeling in the steering wheel and pedals crunch/pop sound when rolling slowly. On/off brakes doesn't seem to matter. In gear/off gear doesn't ...
5
votes
3answers
4k views

Mixing DOT 4 with DOT 4 synthetic

I couldn't see an existing question about this but please link to it if you know of one ... I should point out I'm English and the products described are bought in the UK, in case it makes a ...
18
votes
3answers
1k views

What is the proper way to bleed brakes and replace the fluid?

What is the proper way to replace the brake fluid in a car? What tools are required? I want to make sure I do not get any air or bubbles in the system as this is something that needs to be done right ...
55
votes
16answers
249k views

Should I resurface or replace my rotors everytime I replace brake pads?

I have heard it is proper practice to replace or resurface your brake rotors every time your do a brake pad replacement. Does this need to be done every single time or is it overkill? Maybe it is ...
15
votes
8answers
53k views

What causes brakes to pulsate right after rotor and pad replacement?

I have a 2002 Infiniti Q45. I replaced the front rotors and pads on Sunday. It was the first time I've done this on a car, though I have done it countless times on various motorcycles. I was careful ...
3
votes
1answer
41 views

03 Honda Civic Serious Brake Caliper Question

The car began to lose speed and I immediately got to the side of the road.The car was losing power. I noticed smoke from the wheel while still in the car once I stopped. in reverse and drive the car ...
0
votes
1answer
25 views

Trying to figure out if my rotors are bad? [closed]

2002 Volkswagen Passat I'm trying to figure out if my rotors needs to be changed out
4
votes
2answers
6k views

Honda Accord bubbling / gurgling sound when braking first few times

I have a 2009 Honda Accord. All 4 brakes were recently serviced so I don't think this is related to pads or rotors needing attention. When I first start driving, when I hit the brakes, there is a ...
4
votes
0answers
35 views

Mazda CX7 metallic pulsating sound when driving below 20 MPH

I have this issue with my CX7, when I drive at a regular speed, the car performs very well. Now when I release the gas pedal and brake the car makes no sound until it goes below 20 MPH, then I can ...
1
vote
1answer
23 views

Brake issues 2004 Pontiac Grand Prix

Intermittently, my brake pedal will drop slightly, and there will be a loud clunking noise, metal on metal sounding. Normally happens at slow speeds, weather conditions don't seem to be a factor.
2
votes
3answers
109 views

Brakes pads changes and cutting rotors

My brakes started vibrating occasionally when slowing down on highways at high speeds. I have been realizing that the brakes feel low. I went to a shop for an oil change and the mechanic peeked in ...
4
votes
1answer
54 views

Rotors - Slotted and cross drilled, are they better than OEM rotors?

I have a 2010 Grand Caravan which eats brakes. In 75.000 Kms they have been done three times. I'm wondering if slotted and cross drilled discs may be better than OEM? It is mostly city driving ...
9
votes
1answer
49 views

'04 Daewoo Nubira brakes keep sticking on after disc and pad replacement

On my '04 Daewoo Nubira I have been and had new discs and pads all round and now the brakes keep sticking on, I have been advised I now need new calipers all round, how can I tell if its them or that ...
6
votes
2answers
58 views

2010 Toyota Matrix - Brake Shake Highway Speeds

I just replaced all four corners pads and rotors with the Power Stop Economy kit off Rock Auto and I'm having horrible shaking while braking at highway speeds. All slide pins have been re-greased and ...
10
votes
1answer
61 views

Brake fade and spongy brakes at high speeds

I was driving my girlfriends Ford Fiesta last week and it started to experience brake fade. It always happened after driving the car at higher speeds over 100kmh (60 MPH). The brake pedal became ...
1
vote
2answers
1k views

2011 Jetta rear brake drum removal

Can anyone tell me how to remove rear brake drum from a 2011 VW Jetta? I can't tell if it should just pull off or does the center hub nut need to be removed. Thanks for any help.
2
votes
1answer
148 views

Car shaking when braking

I got a used car. I notice that on speeds higher than 80Km and when I brake, the car shakes. The shaking is very soft, it is not tough and it is not every time. I noticed it twice on a 2 hours journey ...
3
votes
1answer
510 views

How do 99 chevy tracker rear brakes self adjust?

I adjusted the brake shoes a bit after I installed them, but do they now adjust on their own as they are used or how do I get them to adjust?
4
votes
2answers
167 views

Is it necessary to bleed brakes if the system is never opened?

Just wondering if there is a point to bleeding the brakes if the system is never opened, since it's effectively a closed system. For example, does the chemical change should the fluid reach boiling ...
7
votes
1answer
72 views

'Click' Sound on Applying Brake

I have 2014 Honda Civic; couple of months ago, my car's brakes started making a weird 'Clicking' sound when I would apply brakes first time after my car is parked for say around 30 mins or so. Once ...
5
votes
3answers
56 views

Brakes getting tight on their own

I own a Ford Focus ZX4 LE 2.0 engine. This is on my Android so bullet points are not available. But I would explain as good as I can. -The problem I have is when I drive anywhere either on the ...
6
votes
1answer
37 views

Bleeding Brakes

Also with regard to my 2002 Bonneville brake bleeding question, I could not get the rear bleeder bolts loose and did not want to twist them off, thus I bled the rear brakes at the brake hose going ...
7
votes
1answer
33 views

Bleeding Brakes 2002 Bonneville with ABS

I had to replace the 2 brake lines that go from the master cylinder to the ABS control box. I bled all 4 brakes in the proper order, (RR,LR,RF,LF) but the brakes are minimal and the pedal goes to the ...
13
votes
3answers
15k views

What can cause warped rotors?

I have a forward rotor on my '04 Chrysler Sebring causing a lot of pulsation when braking. I replaced the rotor- but within about a month the problem had re-appeared. The guys at Monroe noticed my ...
4
votes
1answer
37 views

Wheel rubbing/tight at one point per wheel revolution

On my 2005 BMW 320D, I recently (200 miles/1 month ago) noticed a rubbing noise coming from the front passenger side wheel. It is only really noticeable on smooth tarmac at slow speeds, but I did ...
6
votes
2answers
738 views

How much disc brake drag is acceptable?

As far as I know brake pads are supposed to maintain slight contact with the rotor at all times. As usually the only thing pushing the piston back after braking is flex of the square cut seal around ...
4
votes
1answer
32 views

My Jeep is making a squeaky noise when I apply the brakes and when I drive slowly it makes a clunking noise

I have a 2002 Jeep Grand Cherokee Laredo. I just bought it two weeks ago so I don't know much about it. They guy I got it off of said it has brand new brakes, rotors, and calipers. When I apply the ...
12
votes
1answer
120 views

Does the brake bleeding sequence really matter?

We've all heard this tip - "start with the wheel furthest from the brake master cylinder and finish with the closest one". Why? Does the sequence really matter? What exactly happens if we don't keep ...
10
votes
1answer
90 views

What are the pro's and con's of compression braking vs. exhaust braking?

My truck supports 2 types of engine brakes: Compression release brake Exhaust brake Both can be selectively deactivated using switches. What are the pro's and con's of each type of engine braking ...
9
votes
1answer
8k views

Front right 'squeals' when turning

Hi I have an incredibly frustrating noise coming from the front right of the car. It only occurred after replacing pads and rotors. It occurs when turning left (weight on right) and occasionally going ...
5
votes
3answers
3k views

Weak front brake on dirt bike

After changing the air tube in my front tire and reinstalling the wheel on my Suzuki RMZ450, I noticed that the front brake lost a lot of stopping power. What caused this and what do I need to fix to ...
12
votes
5answers
422 views

Do these EBC brake pads look like a counterfeit?

I have purchased a pair of EBC Red Stuff front brake pads for my Audi S4 from a supplier whose name I will keep anonymous for now. I opened up the box and everything seemed in place except a weird ...
6
votes
1answer
115 views

I just replaced my CV Axle and the now the brakes are making scary noises

I have a 2011 Toyota Corolla and my CV joints were starting to make popping noises. I replaced both driver and passenger axles. The car drives fine, but after about 20MPH the brakes make weird ...
5
votes
3answers
1k views

Seized brake caliper following brake pad & disc replacement - what could be wrong?

Took my 2006 VW Touareg in for servicing and had the dealership replace the rear brake pads and discs. In a post-replacement test drive the dealership discovered that one of the sides has a stuck ...
6
votes
1answer
49 views

New brakes, intermittent ABS light and battery light

Last weekend, I put new Wilwood calipers, pads and stainless brake lines on the rear of my 06 Solstice. On Tuesday, I started seeing an intermittent ABS warning light. Yesterday (Wednesday), I ...
6
votes
1answer
46 views

Fork bent and replacement

I own a Royal Enfiel Classic 350. I recently met with an accident and had to replace the tank, handle, light set, metal mount for light and the handle for the fork. My insurance did not cover for ...
17
votes
4answers
859 views

What is regenerative braking and why don't we use it?

I know that many electric cars use regenerative braking to enable the car to become more efficient by converting what would otherwise be lost heat energy in to a more useful, reusable form of energy. ...
4
votes
1answer
41 views

Brake judder on new rotors

2013 Corolla have replaced front pads, rotors, pistons, bled fluid, still rotors overheating causing 'judder' when braking?
5
votes
2answers
109 views

How much distance would 1mm off front brakes translate into?

I am planning to replace my front brake pads within a month. I was told that if my brake wear sensor trips, I will need to buy new sensors as they will get destroyed. So I am trying to save my brake ...
4
votes
1answer
65 views

Replaced busted brake line but the brakes still don't work

I have a 2003 Chevrolet Avalanche with a broken brake line. We replaced the broken brake line, added new fluid and bled the brakes for about an hour and there still seems to be air in the lines or ...
5
votes
1answer
77 views

Is there any side effect with using brake cleaners as a general grease or oil cleaner?

The brake cleaner spray I use is relatively cheap and does a great job cleaning my tools. After an oil change, I spray oily stuff and they become clean. The sprayed brake cleaner evaporates and dry ...
8
votes
2answers
121 views

Squealing brakes on 14 ' Audi S4 (B8.5)

I have a 2014 Audi s4 (B8.5) that has around 35,000 km and the brakes are already squealing when I slow down by braking gradually. The sound is intense, and very annoying. It comes and goes but for ...
3
votes
1answer
46 views

Replacing brakes on 14 ' Audi S4 (B8.5)

I will be replacing front brake pads and rotors on my 14 ' Audi S4 (B8.5) @ 40,000km. What I will do is purchase all the parts and bring it to my trustworthy mechanic. Can someone please confirm my ...
9
votes
2answers
134 views

What are the visual signs that brake rotors must be replaced?

Let's say you take off the wheel (when replacing the pads, for example) and look at the brake rotor. What are the signs that it's time to replace the disc? Let's stick to clear visual signs that ...
7
votes
2answers
195 views

removing spindle cap

Trying to remove rusted spinlde cap to change brake drum shoes but it seems to be stuck. Tried to grab eyeglass screw driver flat and oil lubricant spray can to remove the rust but it is pretty stuck. ...
7
votes
1answer
134 views

Brakes grinding when roads are snowy

I have a 2013 Chevy Cruise that has new brakes changed by the dealership, and they work perfectly in the rain, and dry conditions. But when there's snow on the ground, the brakes often start grinding, ...