Referring to the portion of a wheel brake which slows the rotation of the wheels/tires to slow or stop a vehicle. Friction is applied through pads by way of a caliper to reduce the rotational speed. This item is a round disc and is normally placed between the wheel and hub assemblies and can be ...

learn more… | top users | synonyms (2)

4
votes
0answers
41 views

Warped disc rotors again?

When I took my 02 Honda Accord in for its last service (not Honda) I had a very bad vibration in the steering wheel when braking which was obviously brake related. The shop told me that the front ...
16
votes
8answers
62k views

What causes brakes to pulsate right after rotor and pad replacement?

I have a 2002 Infiniti Q45. I replaced the front rotors and pads on Sunday. It was the first time I've done this on a car, though I have done it countless times on various motorcycles. I was careful ...
7
votes
1answer
702 views

Is grinding the “ear” of a disc brake pad ok to make it fit?

I searched this but no luck finding an answer. I recently did a disk brake rotor and pad replacement on a friends car. One of the pads would not fit in the allocated space in the caliper frame. The ...
4
votes
1answer
54 views

03 Honda Civic Serious Brake Caliper Question

The car began to lose speed and I immediately got to the side of the road.The car was losing power. I noticed smoke from the wheel while still in the car once I stopped. in reverse and drive the car ...
4
votes
2answers
61 views

After new brake rotor installation, white smoke come out of brake system

I installed new rotors and serviced my front brakes. I sprayed both sides of the new rotors with brake cleaner. I lubricated the caliper pins with this brake lubricant. I added the lubricant to the ...
7
votes
2answers
66 views

2000 Chevrolet Silverado brakes dragging, 4 new rotors, 4 sets of pads, new e-brake shoes, new front calipers

I recently replaced myself or had replaced all pads, all rotors, front calipers, rear guide pins and brackets, rear brake shoes, and rear e-brake hardware, as well as the e-brake cable on my 2000 ...
4
votes
3answers
84 views

Wheel stuck to Rotor

My 2000 Durango 2 wheel drive front tire is seized to the rotor, I tried the heating method and hitting but still seized, how can I get it off without damaging the wheel?
58
votes
16answers
263k views

Should I resurface or replace my rotors everytime I replace brake pads?

I have heard it is proper practice to replace or resurface your brake rotors every time your do a brake pad replacement. Does this need to be done every single time or is it overkill? Maybe it is ...
0
votes
1answer
31 views

Trying to figure out if my rotors are bad? [closed]

2002 Volkswagen Passat I'm trying to figure out if my rotors needs to be changed out
2
votes
1answer
196 views

Car shaking when braking

I got a used car. I notice that on speeds higher than 80Km and when I brake, the car shakes. The shaking is very soft, it is not tough and it is not every time. I noticed it twice on a 2 hours journey ...
13
votes
3answers
16k views

What can cause warped rotors?

I have a forward rotor on my '04 Chrysler Sebring causing a lot of pulsation when braking. I replaced the rotor- but within about a month the problem had re-appeared. The guys at Monroe noticed my ...
4
votes
1answer
55 views

Wheel rubbing/tight at one point per wheel revolution

On my 2005 BMW 320D, I recently (200 miles/1 month ago) noticed a rubbing noise coming from the front passenger side wheel. It is only really noticeable on smooth tarmac at slow speeds, but I did ...
6
votes
2answers
1k views

How much disc brake drag is acceptable?

As far as I know brake pads are supposed to maintain slight contact with the rotor at all times. As usually the only thing pushing the piston back after braking is flex of the square cut seal around ...
4
votes
1answer
51 views

When getting rotors turned should the thickness be exactly the same throughout?

I have to drop off my rotors to an auto parts store that does rotor turning in house and I wondered when I pickup my rotors and check it's thicker than the minimum thickness from the manufacture ...
9
votes
2answers
214 views

What are the visual signs that brake rotors must be replaced?

Let's say you take off the wheel (when replacing the pads, for example) and look at the brake rotor. What are the signs that it's time to replace the disc? Let's stick to clear visual signs that don'...
12
votes
4answers
26k views

brake rotors- blank, slotted or drilled?

There is a lot of conflicting information whether slotted or drilled rotors perform better than blank rotors. For a street car that will do the occasional track day, which type of rotor should I get?
5
votes
3answers
546 views

Replace driver side first, then passenger side brakes?

Need advice. I am replacing brake rotors and pads for all four wheels. My home 2-car garage only gives me enough room to work on the side facing the other car, the middle of the garage. Is it safe ...
6
votes
7answers
11k views

Why are drum brakes still fitted on Ford's cars?

Currently I own a Mk5 Astra SRi, however I am looking to sell this and buy a Ford Focus Mk2. The other day I looked at a Ford Focus Zetec Mk2. My understanding is that Zetec is sort of the ford ...
5
votes
2answers
124 views

Do I need to replace just my one rusted rear rotor, or do I need to replace both rear rotors?

I have one rear rotor that is partially rusted on the braking surface and the rust won't go away. I tried scraping down the surface to even it out, and then the entire surface looked rusted. I had ...
4
votes
4answers
15k views

Squeaking brakes on motorcycle - an issue or not?

The front disc on my motorcycle emits a low pitch squeaking noise when I'm pulling up to a complete stop (almost like the sound train brakes make when pulling up to a station). This only happens when ...
6
votes
2answers
2k views

2 week old disk brake pads rubbing on rotor. Is this OK? (motorcycle)

I got the pads on the front brake of my bike replaced 2 weeks ago. Immediately I heard a rubbing noise at low speed. I thought this would be ok - that the pads just had to be worn in or something, but ...
7
votes
1answer
87 views

Standard vs Carbon Ceramic Brake Discs - What do you pay for?

I was watching a car review on YouTube recently. I know that carbon ceramic brakes are often a huge optional extra on cars and they're normally physically huge as well (from what I can tell). What is ...
13
votes
9answers
18k views

How can I remove a seized brake disc?

I'm changing the rear brake discs and pads on my Ford Focus C-MAX. I've done one side which was fairly easy, but on the other side I can't get the disc off. There is nothing holding it on as far as I ...
5
votes
1answer
74 views

Disk rotors wear

I recently bought a second hand car (Porsche Cayman S) and I was looking at the disk rotors. Do you think that it's time to replace the front disk rotors of my car? picture1 picture2 ...
7
votes
1answer
211 views

Continual Brake Issues on a 2002 Kia Spectra

I have a 2002 Kia Spectra. We have replaced the rotors 3 times, but prior to doing that we were having problems with our back brakes. The mechanic we were going to said nothing was wrong with the back ...
7
votes
3answers
1k views

Rotor Replaced and MY Car is only 3 years old

I went to pep boys because i heard squealing and my pads were worn down. he also told me that i needed to replace my rotors so not knowing anything i did but i asked them tog ive them to me so i could ...
4
votes
4answers
31k views

Replaced brake pads - one pad was full, the other was gone. Brakes now very hot after driving

The content is pretty much contained in the title. When I went to replace the brake pads, one pad was completely gone and the other was almost like new. Now that I have replaced the pads, the wheel ...
4
votes
4answers
11k views

Does the brake pedal always feel soft after the pads are changed?

About my bike Model: Honda CBR 250R Total Run: 17500kms Total Time: 1 year 1 month (rotor & break fluid never changed, break pad changed 6 months back) Break Fluid Level: 3mm above lower line ...
5
votes
3answers
7k views

Should I get my brake rotors turned without replacing the recently-replaced brake pads?

Earlier this year, I noticed my brakes starting to screech (especially in the morning or when it was cold out). Not the distinctive squeal of finished brake pads, but the more "grinding" screech of ...
1
vote
1answer
40 views

Locating Special Tools for Auto Free Hub Removal

I am attempting to replace rotors on a 1988 Dodge Ram 50 (2.6L, 4WD). To remove the rotors, I need to use a special socket (visible around the auto free hub ) and the special locknut socket. Are there ...
1
vote
3answers
58 views

Rotor replacement on 2010 Honda Accord w/ 170k mi!

My 2010 Honda Accord has ~170k mi, a lot of hwy miles, so minimal brake use! The original rotors AND front brake pads (seriously!) are still on and the rear brake pads that were replaced at only ~32k ...
4
votes
1answer
329 views

Brake pad failure and chewed up rotor after 1 month

Replaced front rotors and brake pads less than a month ago, and now my right front brake pad is completely gone....and the rotor is totally chewed up! Began to notice a metal grind like sound on the ...
1
vote
2answers
365 views

Can I take the front rotors and put them in the back

I have some front rotors from when I replaced them it looks like I didn't need them so I kept them. I would like to take them to get shaved and put the in the back. Is this possible to do something ...
3
votes
2answers
215 views

How to cleanup disk brake rust rings

Some years ago I replaced the stock rotors for slotted and drilled on all four wheels of my 2003 Monte Carlo. At the time I needed to replace the rotors and they had a habit of warping. The new ...
4
votes
1answer
161 views

Why did front rotors and brake pads have to be replaced after one year?

KIA replaced my front rotors and brake pads Aug 2014. One year later my brakes were not functioning well and KIA said the right front rotor was grooved because of rust and should be replaced, adding ...
3
votes
1answer
195 views

Noise and vibration when car is moving

My 2007 Toyota Corolla has been having an odd issue. When the car is moving, even slowly, I hear something that sounds like rubbing, and as I go faster, there is a vibration that starts as though a ...
4
votes
1answer
27k views

Front Wheel Squeal When Driving After New Brakes

We have a 2006 Buick Lacrosse. We just installed new front brakes. 2yr rotors and lifetime performance ceramic pads. We have used these pads in the past on the car and never experience this issue. We ...
1
vote
0answers
19 views

Recommended rotor disc combination for Ranger truck. Normal usage [closed]

Any recommendations for brake rotor and brake pad combination for good stopping power. My rotors warped after 185,000 miles. I am easy on my brakes; first set of pads lasted 150,000 miles. This is for ...
19
votes
9answers
198k views

When do brake rotors really need to be replaced?

I need to replace my rear brake pads. A mechanic suggested I also replace my rotors because they are rusted around the edges. The rotors are in fact quite rusted, however, there is no rust on the ...
3
votes
3answers
301 views

What are the different types of disc brakes

I have head of Ventilated Disc,Carbon Ceramic disc. I do not know what are the different types of disc brakes available on the market. Which one should I choose. I would also like to know the ...
2
votes
1answer
37 views

Early rotor warping on newer 11 Lexus GS350

I can't at all explain why this happened, but my 11 Lexus GS350 warped front rotors and all I ever do is keep the car in gear and use the engine to slow down. There is even a Standard Simulation mode ...
3
votes
2answers
259 views

Why does my front wheel rotor is heating up more than rear one?

I had been facing high fuel consumption lately. To my surprise I discovered that my front wheel free rotation seems bit restrictive to my rear one even when rear wheel drags chain and two sprockets ...
7
votes
3answers
344 views

Wheel change/balance leading to continuous braking

So I go to get my wheels changed and balanced and I leave with the driver side rim heating up unnaturally even after driving just a few miles. The car stops unusually quickly. It's quite clear that ...
3
votes
1answer
46 views

Rotor removal help

I have a 2005 CRV the rotor will not come off. I have tried almost everything. I say almost as there must be something else. I have beaten the rotor like it stole my rent money. I have tried ...
1
vote
2answers
37 views

deep pressing of disc brake lever when whee not in position

I would like to know what happens when the disc brake lever is deeply pressed when wheel is removed. Does it cause any damage? If yes then what should be the repair and how much it may cost? Update: ...
2
votes
3answers
6k views

Steering wheel shakes when braking at high speeds

I got a 2011 lexus ES350, the steering wheel shakes badly when i push the brake. I have been told that its the rotors. I got the rotors resurfaced last week at the lexus service center but no ...
5
votes
2answers
2k views

New Pads, Rotor, & Caliper; Grinding, Squeaking, and Heat

I just replaced my rear-passenger side Caliper, Caliper Bracket, Rotor, and Brake-pads due to the rotor, pads, and caliper bracket grinding together. Vehicle: 2000 Blazer 4WD, recently had front ...
3
votes
2answers
521 views

Why is martensitic steel used instead of grey cast iron for ATV disc brakes?

Grey cast iron has better thermal properties -- conductivity and specific heat -- lower density, better castability, and better friction than martensitic stainless steel. Why are OEM parts made of ...
3
votes
4answers
140 views

Slight pulsation from brakes at 70+ MPH (Replace rotors?)

my pads have about 25% life left, I am going to replace them soon and Im wondering, should I replace my rotors as well? Im feeling a very slight pulsation at 70+ MPH (when braking only). But braking ...
4
votes
1answer
493 views

Replaced rear rotors and pads, now both rotors hot on first test drive

Yesterday I replaced the rotors and pads on my 09 Mini Cooper. I thought it went well, but in the first short test drive, it feels like the emergency brake is set a bit. I drove a half mile, and both ...