Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

I have read that, when you add electrolyte and acid to a new battery, it will then be at 80% of max charge. You can put the battery in your bike and it will turn. However, it's highly recommend to tend that battery and bring it up to 100% charge. Is it possible to drop the battery in and take her for a spin (because it's a beautiful evening) then hook her up to the tender anyway and still charge the battery up to 100%?

share|improve this question
    
I wouldn't know why not. My suggestion, ride the bike. –  Paulster2 Apr 3 at 1:52

4 Answers 4

up vote 4 down vote accepted

The reason behind tending it to bring it to 100% vs. just riding it up to 100% is to save wear and tear on the alternator or generator. They're really designed to maintain a battery/do light charging, not do a major charge.

A secondary thing is that a severely discharged battery may vent a lot of hydrogen while charging and you'll need to monitor the cell electrolyte levels. That's hard to do while riding...

share|improve this answer
1  
from experience of lead acid batteries going bang - its better to not be on the bike in the event of it going bang than on it. If the vents arent fully open and the charge rate is high because the battery is so low then it can create a hazardous situation. Also need to consider why the old battery is being replaced, is the reg/rec faulty and overcharging? –  Mauro Apr 4 at 13:29

It should be no problem. An otherwise good electrical system will get you to 100% after a short ride. However, having just dealt with a bad regulator myself, I'd say to check the levels and make sure there is no overcharging (boiling/"cooking") of the battery taking place. "Wet-type" batteries should have a vent and overflow tube. In my experience the main danger of overcharging is ending up somewhere inconvenient with a dead battery that can't be charged. On some bikes, the engine won't function without a conductive, if not dead, battery in place.

share|improve this answer

The battery is ready to use after you've put the acid in, and you can charge it on the bike, however, better practice would be to attach it to a charger to complete the first charge... Personally, I filled my battery with acid, and attached it to the battery charger WITHOUT putting the caps on the battery in order to allow the gas to escape. When completed, I'd leave it to stand for a small while, then put the caps on, you'll get better battery life this way.

share|improve this answer

Hi in my opinion you will be fine to use the battery with 80% charge, your bike will do the rest when you are out for a ride. Also it is a good idea to invest in one of the new SMART CHARGERS that are now on the market, these automatically top up the battery charge and are ideal for protecting your battery over the dormant winter period, when the battery is charged the charger switches off and then on again when the battery requires topping up with charge, hope this helps you Eric Roberts www.batteriesontheweb.co.uk enter image description here

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.