Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

Why would 'Lug Bolts' be snapping off constantly and tires wearing faster on the passenger front tire of a '98 Blazer, 4 wheel drive. The tire is wearing on the outside. It has had a front end alignment and the gentleman who ran the shop told me the 'camber' was all the way out? What do I have to do to correct this problem? I have had to replace the CV axle on that side an thats when the problem began, I also just replaced the hub as well, both about 5-6 months ago.

share|improve this question

1 Answer 1

up vote 2 down vote accepted

Camber is the angle of the wheel on it's vertical axis - If you have wear on the outside of the tyre, then you have too much positive camber, i.e. the top of the wheel is further out than the bottom - the opposite of the diagram below (from Wikipedia), which shows negative camber.

Negative Camber

For it to be far enough out to cause such serious problems, I would surmise that something in the suspension is bent. At a guess, I'd say one of the lower arms, as that would lead to the bottom of the wheel being further in than it ought to be, as a bent arm is shorter than a straight one. You might be able to fix it by adjustment or adding shims (a common way of adjusting camber), but that only tends to give a small amount of adjustment - the best option is to replace the damaged part.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.