Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

My jeep's stock wiring has two ground cabled coming from the negative terminal. I recently upgraded all of my positive cables, and now I'm on to the negative. Is it necessary to have one cable going to the engine, and one going to the frame - or would one large wire going to the engine, since the engine is connected to the frame, work?

share|improve this question
1  
Normally when people upgrade a ground system, they add ground wires. If you're considering removing any of them, you're definitely not doing an upgrade... Generally speaking on car projects, if you find yourself using the term "Get away with", you've probably strayed off the upgrade path and are more likely to be downgrading... –  Brian Knoblauch Apr 20 '13 at 13:19
add comment

2 Answers

up vote 6 down vote accepted

The frame ground is needed. Although the engine is bolted to the frame all the connection points are isolated hence insulated by rubber. The reason for the rubber mounts is to isolate the engine vibration and the resulting stress from the frame. Some older vehicles did use a single ground to the block. This required a second ground wire from the block to the frame or chassis. A possible reason for the switch to a frame/chassis to battery ground connection is the increase in electronics that require a more secure ground.

share|improve this answer
    
The reason I asked about the engine bay is because I upgraded from an 80amp alternator to a 160amp alternator. –  Keegan McCarthy Apr 20 '13 at 14:57
add comment

You should maintain both ground wires. If you removed battery to chassis you would have to add engine to chassis wiring. The battery to engine wire is there to ground the alternator.

Battery to chassis wiring is probably a safer, shorter, and easier run than engine to chassis anyways so why bother.

You probably want 2gauge wire all the way around. You could probably "get away with" 4gauge but I by no means recommend it since I am not an electrician.

share|improve this answer
    
Yes. I added a 160amp alternator - I wired it with 0awg welding cable (the real stuff, not the ebay stuff). I could only afford enough for the posative wiring at the time, but I am going to add 0awg ground wire to at least my engine (for the starter and alternator) and maybe to my chassis, as well. –  Keegan McCarthy Apr 23 '13 at 1:45
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.