Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

I have a Chevrolet Suburban, 1500 model, year 2001. How do I remove the wiper arm of my Chevy after I remove the base cap and nut. The arm is not coming off the base after significant prying with screw driver.

On image the base of wiper arm is on the left, wiper extends to the right.

http://i.stack.imgur.com/wPnMU.jpg

share|improve this question
add comment

2 Answers 2

up vote 0 down vote accepted

It's best to use a Windshield Wiper Arm Puller (shown below). These are about $15usd and most likely available at any auto store. But, before going and spending money, spray the threaded area with some WD-40 and let it sit for a few minutes, this will give it time to set in. Next, place the wiper in the service position* as if you were about to replace the wiper blades (this will require you to lower the hood). Once in position, place one hand where the wiper arm makes a 90 degree angle. Then rock it back and forth and it will hopefully wiggle free.

  • Windshield Wiper Arm Puller

    wiperarmpuller

share|improve this answer
add comment

When my 2002 silversdo was new the arm slipped several times. The dealer Loctited them in place. Try using a small gearpuller. If you don't have a small puller try a battery terminal puller. If you can't grab the arm with a puller you may need a wiperarm removal tool. It is a small lever that prys on the arm without damage to the plastic trim.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.