Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

On my '09 Chevy Traverse, the windshield washer pump stopped working on both the front and back. I first checked for fuses. There was one in the fuse block under the hood, that one looked good. I found another under the dash on the passenger side (what a PITA to get at). That one was blown. I replaced that one and now the rear works. When I try the front, I hear a click (a relay?) but nothing else happens. Any idea if there is another fuse somewhere label incorrectly or where I should look next?

share|improve this question

2 Answers 2

up vote 0 down vote accepted

So I replaced my pump... and it still didn't work. After doing some more looking I discovered that I read the fuse map wrong and put the fuse in the wrong spot. After putting it in the right spot it started to work. Since I know you can't take used electronic parts back, I just kept it in and kept the old one.

BTW, to get at the pump, you have to remove the wheel and open up the wheel well.

share|improve this answer

Is it possible the pump is seized? This could also cause the fuses to blow.

share|improve this answer
    
I am not ruling it out, but I don't want to take it to the shop to find out that it was a fuse. $50 fuses get spendy quick. –  Mike Wills Jan 29 '13 at 15:39
    
Do you know how to jump your pump, and bypass? That's the easy way of checking. 12V battery can do it. –  FossilizedCarlos Jan 31 '13 at 3:58

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.