Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

In a silly move during an engine overhaul, I dropped my Honda Rebel's fuel tank and put a dent in the top side.

Is it possible to pull this dent out? I've heard there is a method using heat and ice to cause the metal to contract back into its original position, but the only time I've ever seen it used it was a total failure.

Here's an image of what I'm working with:

enter image description here

share|improve this question

2 Answers 2

Given you have such easy access to the inside of the tank, you might try pushing the dent out from the inside with a lever-type tool.

Here's a video of one such tool and some of the technique.

share|improve this answer
    
I think I'll give this a try tonight. The metal the tank is made of is fairly thick, would heating that spot to make it a bit softer compromise the tank? There's no fuel in it. –  BrMcMullin Dec 13 '12 at 19:27
    
If it were me, I'd try without heat first. You're going to cook your paint before the metal softens enough to make a difference. –  mac Dec 14 '12 at 14:28
1  
Actually, you want a little heat from something like a hairdryer to ensure that the paint softens a little and doesn't crack when the dent is pushed out. The dent might be a little bit too big for the paint to escape unscathed, though. –  Timo Geusch Dec 14 '12 at 15:59

The right side looks like it has a small crease. You may be able to get it to look better but I don't think it will be perfect without some filling and painting. You can try covering the filler opening with some heavyduty plastic and installing the gascap. Hook the fuel outlet up to an air compressor. Gradually increase the pressure to see if the dent will pop out. I wouldn't let the pressure go any higher 35-40 psi. I am not sure what the burst pressure rating of a gas tank is, but I wouldn't go much higher. I know that some bodyshops have a paintless dent remover. A short stem is glued to the paint and a dent puller attaches to the stem. The glue is heated and the stem removed when it is finished.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.