Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

I forgot to release the hand brake while I'm driving at around 4 to 5km. What will happen to my rear brakes?

share|improve this question
add comment

3 Answers

If this was a one time occurance the damage should be minimal. If the brake shoes were worn or damaged the lining material may have cracked from overheating. This is rare if they were in good shape.

The damage done will depend on the type of parking brake brake along with the extent of wear before the incident. The older design of parking brake used the service brake shoes (the one that normally stop the car) as the parking brake, they are activated by a cable system instead of the normal brake hydraulics system.

Typically if the brake shoes were in good shape a manual readjustment of the shoes will return everything to normal. The manual adjustment consists of turning an adjusting screw inside the brake drum. Most vehicles have an access hole so this can be done without removing the drum. If your car has rear disc brakes you may have a small set of brake shoes behind the rotor that act as the parking brake. If these shoes are worn they will have no effect on normal braking.

Similar to drum style brakes these are adjustable, however the adjustment involves removing the caliper and rotor to get at the adjuster. On some Subarus and Saabs the parking brake is part of the front brake caliper, it uses the normal brake pad as a parking brake. The pad is moved mechanically via a cable. In this type no readjustment is needed, as the pads self adjust with every use.

share|improve this answer
    
I've had the parking brakes freeze "on" in my car a few times in the Winter. Taking it nice and slow I was able to limp the car home to my warm garage to thaw them out. Did generate a good deal of heat, but no obvious extra wear (and not enough heat to boil the brake fluid). YMMV of course, especially if you drove fast with them locked on. –  Brian Knoblauch Nov 19 '12 at 14:58
add comment

Depending on to what degree of "on" you had it, anywhere from nearly none to possibly some. Leaving it on the last click (or two, or three, depending on how much slack there is) usually doesn't engage the brakes at all. Especially on older cars.

However, if you left it on fully engaged, then it could wear the brake shoes or pads prematurely, and cause damage to them. It would also probably start smelling as well.

share|improve this answer
add comment

If car still brakes effectively without shuddering all should be well.Handy hint-if your car has discs and you're unsure when to change pads visually inspect.If pad material is thinner than the backing plate time to change.In any case you should hear screecher if they're are due but don't rely on it.Some are known to remove them

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.