Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

I just got a KnuKoncepts 4AWG kit and it came with the wires etc. and then a baggie with a bunch of gold tips (circle things)... I was wondering how you attach the wires to these things? Should I solder them? Should I crimp them? If I don't buy a crimping tool, is there a suitable replacement (vice grips/hammmer,ect).

share|improve this question

1 Answer 1

It depends on the design of the ends. Normally power connectors are just crimped, whereas data connectors are often crimped and soldered. While vice grips/hammer can crimp in an emergency, it's not going to do a proper crimp. You really want the right tools doing this, especially in large gage wire (which can obviously carry a lot of current). I'd recommend picking up the Haynes Electrical Manual as a reference. http://www.amazon.com/Automotive-Electrical-Manual-Haynes-Techbook/dp/1850106541

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.