a few weeks ago i had to work on my starter i notice that the wire going to the starter from the solinoid was broken off the connectiong so i resoldered it, ran for a few weeks until this happened: i went out to start my truck and it just clicked when i tried to turn it over, i pushed it into the garage and replaced the starter, with a used one. went to start truck and all it did was turn the starter but wouldnt fire up and run. i tested the sensors and it read to replace crankshaft postioning sensor along with map sensor. still doesnt want to run. i replaced the spark plugged, but left one out to check for spark against the metal frame didnt see any spark. not sure what to do next. need help. thankx tim from wisconsin.. email: tim9188@aol.com
Tell me more
×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for
mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.
|
|
|
HAve you tested the battery? If you have a bad battery, it could cause the starter to click like that. |
|||
|
|
