Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

A few weeks ago I noticed that the wire going to the starter from the solinoid was broken off at the connection, so I resoldered it, and it ran for a few weeks until this happened:

I went out to start my truck and it just clicked when i tried to turn it over. I pushed it into the garage and replaced the starter with a used one. Went to start truck and all it did was turn the starter but wouldn't fire up and run. I tested the sensors and it read to replace crankshaft position sensor along with the MAP sensor. Still doesn't want to run. I replaced the spark plugs, but left one out to check for spark against the metal frame didn't see any spark. Not sure what to do next.

share|improve this question
add comment

1 Answer

HAve you tested the battery? If you have a bad battery, it could cause the starter to click like that.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.