Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

I have a 1998 Ford Contour that has a check engine light. I checked the codes, and found:

  • P0171 System Too Lean (Bank 1)
  • P0174 System Too Lean (Bank 2)
  • P0401 Insufficient EGR Flow
  • P1131 Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates Lean - Bank No. 1

I think the main culprit might be a vacuum leak, and that the codes are related to the side effects caused by the leak. Are there any common hoses that I should check first? I remember we had two main hoses on BMWs that were usually the guilty party.

share|improve this question
    
Checked for leaks, and found none. I did find that the fuel pump might not be coming on. –  FossilizedCarlos Dec 23 '11 at 15:01
1  
Check the ground on the fuel pump wiring, it's easy to get to, pull the rear seat. If it looks corroded, clean it off. –  Mark Johnson Dec 23 '11 at 17:28
    
I'm guessing since it was throwing a code for EGR flow the engine was a 2.5L Duratec? The '98 2.0L Zetec has VVT instead of EGR. –  Mark Johnson Jun 21 '12 at 21:10

1 Answer 1

up vote 2 down vote accepted

The problem did end up being the fuel pump. Checked wires and fuses, but in the end it was a bad pump. The filter was also replaced, and can probably be blamed for the pump failing.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.