Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

My headliner has started to sag right over the front passenger. While it is not causing me any issues (it is not so low that it hits the passenger or distracts me) it is very ugly. What is the best way to go about fixing it?

share|improve this question
    
thumbtacks! :-) –  Patrick Mar 8 '11 at 18:12
    
This one hits home for me. I remember this issue in one of my first cars. –  Troggy Mar 9 '11 at 8:25
3  
@Troggy, I think this is a a common first car experience for a good portion of people. First car check list is 1) Runs 2) Has seat belts 3) headliner sags. –  Bob Roberts Mar 9 '11 at 13:34
add comment

3 Answers 3

up vote 2 down vote accepted

I would recommend an adhesive that is designed for headliners (ala Permatex).

An alternative to this would be contact cement, although you might have some bleedthrough.

If the headliner has stretched with age you might need to buy a new headliner.

share|improve this answer
add comment

My advice is to not spend too much time on trying to reattach it with spray on adhesives. I once removed a headliner and then scrapped all the loose foam off. Then sprayed and glued it back on. It lasted a few months, if that long. I got another car reupholstered professionally and it cost less that I thought it would and it was beautiful.

share|improve this answer
add comment

Had this problem once too in a older truck. There are a few options:

  1. Reupholster it. You could do this yourself, or have it professionally done. If you were to do it, you would need to remove the trim pieces in the inside along the roof, and then remove the fabric. It may be attached to the sheet metal with some plastic clips. You will want to save as many of these as you can. Then, make a decision as to whether you want to completely remove the old fabric, cover over it, or just tighten it. Then put the new fabric on, using some adhesive in the middle, and use some staples to stale the back side of the fabric near the ends, that would be covered up by the trim. Re-install, and you should be good to go!

  2. Tack it up. You could easily do this yourself, just use some small metal screws that match the color of the fabric.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.