Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

My feeling is to just pull it up as far as it goes, but I've heard this is bad for the brakes and the car and so it would be better to pull it up with the button pressed till you feel slight resistance, then let go of the button and leave it as pulled up as it is..

Also - for any answerers in the UK - is there anything in the highway code concerning handbrakes? How about over there in the US? Any rules for your handbrakes?

share|improve this question

The MOT requirements state that when fully applied, the lever should not be at the end of its travel, i.e. there should be a few 'clicks' left before it hits the stops. You should apply it fully, otherwise it won't be properly on and won't hold the car!

When applying it, be sure to press the button in rather than letting it click over the ratchet, as the latter will increase the wear on the ratchet which could eventually lead to failure.

share|improve this answer

Indeed, pulling the handbrake up too far puts additional stress and wears the mechanism quicker, especially cables and their attachments. But on steeper hills that is necessary. On flat surfaces few clicks should be enough.

Also don't forget to turn front wheels towards road borderstone, so that even if handbrake snaps your car safely bumps into road border rather than in next parked car or even goes on it's own across the lines.

share|improve this answer

I can say that if I only pull my handbrake up until there's light to moderate resistance that it's not enough if I'm parked on a hill. I had my car pop out of gear and start slowly creeping down a hill with the handbrake on like that before...

Of course, the opposite of pulling on it both hands to gorilla it on is also a bad idea. I was parking on a steep hill one time and wanted to make sure to get it extra tight. I snapped the cable...

Something in between would be good. :-)

share|improve this answer

When doing some DIY Maintenance on my car awhile back, I picked up a Chilton book from my library and in the section on parking brakes they actually had a chart saying the number of clicks my Toyota should make when pushing the petal down.

For example they say five to nine clicks is safe (going from unset to full max) but any more or less means you need to have it adjusted.

The book also provided a good outline on how to adjust the tension of the brake (which in my car was as simple as tightening a bolt) but I'm sure going to a mechanic wouldn't be too expensive if it's something you'd rather have a pro handle (which is probably a good idea when dealing with breaks)

But overall, my point is that emergency brakes should be able to be pulled up without destroying them, but the key is making sure that the number of clicks matches what your car maker says is the ideal range.

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.