Take the 2-minute tour ×
Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles. It's 100% free, no registration required.

I have just recently found a rather large hole in my windshield washer supply line. So I'm trying to figure out how I am going to repair this.

Could I get new tubing and just re-run it? Is this an easy repair or would bringing it into a shop be worthwhile? Would I just end up with a tank of washer fluid on my face?

Could I patch the hole? It is pretty large altough I imagine a shrink-fit sleeve would likely be able to repair it.

My specific car is a 2003 Pontiac Sunfire.

share|improve this question

1 Answer 1

up vote 3 down vote accepted

You should be able to replace the tubing. Most parts stores sell it by the foot. Just take in a piece of of to match up the size and get a few more feet than you think need.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.